5. The double pulley consists of two wheels which are attached to one another and turn at the same rate. The pulley itself has a mass of 15 kg and a radius of gyration of ko = 110 mm. If the block at A has a mass of 40 kg, determine the speed of the block in 3 s after a constant force of 2 kN is applied to the rope wrapped around the inner hub of the pulley. The block is originally at rest. 200 mm 75 mm 2 kN

5. The double pulley consists of two wheels which are attached to one another and turn at the same rate. The pulley itself has a mass of 15 kg and a radius of gyration of ko = 110 mm. If the block at A has a mass of 40 kg, determine the speed of the block in 3 s after a constant force of 2 kN is applied to the rope wrapped around the inner hub of the pulley. The block is originally at rest. 200 mm 75 mm 2 kN

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The 21-kg uniform thin hollow square plate is pinned at point O, and its side L = 0.5 m. If it is…

Q: 3. The 300-kg gear has a radius of gyration about its center of mass O of ko=400 mm. If the wheel is…

A: Given:The mass of the gear is .The radius of gyration is .The couple moment is .The radius is…

Q: Given: The 30 kg rod is released from rest when 0 = 0°. The spring is unstretched when = 0°. Find:…

A: The given question is solved using the principle of conservation of energy which states that total…

Q: the pin support at A suddenly fails, determine the beam's initial angular acceleration and the force…

A: the 600-lb beam is supported at A and Bsubjected to a force of 1000lb calculat , the assume that the…

Q: each of 0.15 m radius and 1.9 kg mass). If the system is released from rest when 0= 76°, when rod AB…

Q: B 1 m Ө A

Q: The truck carries the spool which has a weight of 460 lb and a radius of gyration of kg = 2 ft.…

Q: The pendulum consists of a 10-kg uniform slender rod and a 15-kg sphere (IG-2/5 mr²). If the…

A: The mass of the sphere is ms=15 kg The mass of the rod is ml=10 kg. The applied torque is M=50 Nm.…

Q: The system is at rest with the spring unstretched when 8 = 0. The 5.3-kg uniform slender bar is then…

A: mass,m=5.3 kgb=0.45 mto determine:(a) Spring constant k(b)magnitude of angular velocity

Q: The body consists of a uniform slender bar and a uniform disk, each of mass m/2. It rests on a…

Q: Select the most appropiate free body diagram

A: To Find : The appropriate correct option Given : The free body diagram is,

Q: he thin 12 kg bar has an angular velocity in a clockwise direction ω = 1.5 rad/s when in position…

A: The mass of thin bar is given as,m=12 kg The angular velocity of thin bar is given as,ω=1.5 rad/s…

Q: The 153-kg wheel has a radius of gyration about its center of mass O of KO = 283 mm. If it rotates…

Q: 20 The spool has a mass of 40 kg and a radius of gyration of k=0.65 m. If the 20 kg weight is…

A: The mass of spool is .The radius of gyration is .The mass of weight is .The final angular velocity…

Q: The disk weighs 50 lb and has a radius of gyration (kg) of 0.8 ft, and a couple moment of 35 lb-ft…

A: To find-: The acceleration of the mass center G. Given-: The weight of the disk is W=50 lb. The…

Q: The double pulley consists of two parts that are attached to one another. It has a weight of 52 lb…

Q: The 33-kg reel has a radius of gyration about its center O of ko = 240 mm. If it is released from…

Q: The circular concrete culvert rolls with an angular velocity of w= 0.48 rad/s when the man is at the…

A: Angular velocity = 0.48 rad/s Radius of gyration = 3.6 ft Combined weight = 500 lb

Q: Part A The double pulley consists of two wheels which are attached to one another and turn at the…

Q: The two 10 kg, thin, 1-m long rods are pin connected as shown. The wheel is frictionless with a mass…

A: Given: mass of the each rod→m=10 Kg Length of the each rod→L=1 m Unstreatched length of the…

Q: 3. ac = 600 m/s² Each of the two links (slender rods) has a mass of 2 kg/m. If the piston has a mass…

A: To find: The torque M applied to link AB. Given: The mass of piston is m=3 kg. The acceleration of…

Q: The amusement ride weighs 20 kip and has a radius of gyration of kp = 37ft, and is initially at…

Q: The 35-kg roll of paper rests along the wall where the coefficient of kinetic friction is μ = 0.2. A…

Q: 3. The 30-kg gear A has a radius of gyration about its center of mass O of ko = 125 mm. If the 20-kg…

A: Given:mass of the gear= 30 kgradius of gyration ko=0.125 mmmass of the rack= 20 kgP=200Ninitial…

Q: The 5-kg cylinder is initially at rest when it is placed in contact with the wall B and the rotor at…

Q: The uniform 179-kg beam is freely hinged about its upper end A and is initially at rest in the…

Q: The 75-kg wheel has a radius of gyration about its mass centre of kg = 375 mm. If it is subjected to…

Q: The 100-kgkg spool is resting on the inclined surface for which the coefficient of kinetic friction…

Q: The four-wheel-drive all-terrain vehicle has a mass of 300 kg with centre of mass G. If all four…

Q: The belt around the pulley, which weighs 60 lb and has a radius of gyration of 10”, has tensions…

Q: 900 N 4) The uniform 40 kg slender rod is being pulled by a cable that passes over the small smooth…

Q: The torsional spring is untwisted when the slender uniform rod is in the vertical position. The rod…

Q: The pendulum of the Charpy impact machine has a mass of 57 kg and a radius of gyration of ka = 1.52…

Q: In the figure, rod AB has a mass of 10 kg, and must slide within the slots as shown. If the spring…

Q: The cable drum has a mass of 610 kg with radius of gyration of 385 mm about its center O and is…

A: Find the velocity of the carriage and angular velocity of the drum.

Q: The small encd rollers of the 6.2-lb uniform slender ber are constrained to move in the slots, which…

A: Given that, Force on the bar is=6 lb, Let the angualar velocity of bar AB is ω The slender bar is…

Concept explainers

Clutches, Brakes, Couplings, and Flywheels

The clutch is described as a machine element used to connect or disconnect two shafts together to transmit torque or power. The clutch works on the principles of friction. The clutch is commonly used in automobiles to transfer power from the driving shaft to the driven shaft.

Question

5. The double pulley consists of two wheels which are
attached to one another and turn at the same rate. The
pulley itself has a mass of 15 kg and a radius of gyration of
ko = 110 mm. If the block at A has a mass of 40 kg,
determine the speed of the block in 3 s after a constant force
of 2 kN is applied to the rope wrapped around the inner hub
of the pulley. The block is originally at rest.
200 mm
75 mm
0
2 kN

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Final answer

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Clutches, Brakes, Couplings and Flywheels

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If P = 30 lb, determine the angular acceleration of the 50-lb roller. Assume the roller to be a uniform cylinder and that no slipping occurs
The 18-kg rod AB is pin-connected at A and subjected to a couple moment of M =15 N- m The rod is released from rest when the spring is unstretched at 0 = 30°. As the rod rotates, the spring always remains horizontal, because of the roller support at C. (Figure 1) Determine the rod' s angular velocity, measured clockwise, at the instant 0 = 60°. Express your answer using three significant figures. Enter positive value if the angular velocity is clockwise and negative value if the angular velocity is counterclockwise. vec rad/s k = 40 N/m 0.75 m M = 15 N- m
The system is made up of the 1-m, 6.5-kg uniform rod AB and the two uniform disks (each of 0.19 m radius and 1.5 kg mass). If the system is released from rest when = 80°, when rod AB has just become horizontal, determine the coefficient C in the expression Cw² which is the kinetic energy of rod AB at this instant. Assume the disks roll without slipping. Your answer must include 2 places after the decimal point. Please pay attention: the numbers may change since they are randomized. AB' Take g= 9.81 m/s². A-L B m Your Answer: Answer
The 2.28-kg uniform slender bar rotates freely about a horizontal axis through O. The system is released from rest when it is in the horizontal position 0 = 0 where the spring is unstretched. If the bar is observed to momentarily stop in the position 0 = 66°, determine the spring constant k. For your computed value of k, what is magnitude of the angular velocity of the bar when 0 = 48°. B 0.85 m 0.85 m 2.28 kg 0.29 my Answers: k = i N/m ω- rad/s 1
SOLVE USING PRINCIPLE OF WORK AND ENERGY
The 45-kg reel has a radius of gyration about its center O of ko = 220 mm. If it is released from rest, determine the total external work done to it when its center O has traveled 6.6 m down the smooth inclined plane (with angle = 35°). Please pay attention: the numbers may change since they are randomized. Your answer must include 1 place after the decimal point, and proper SI unit. Take g = 9.81 m/s². 0.4 m 0.2 m²
At the instant shown, the spring is un-deformed. Determine the change in potential energy if the 20 kg disk (with radius of gyration kG = 0.5 m) rolls 2 revolutions without slipping. k= 200 N/m 3 m/s datum 0.3 m M = 2 Nm 30° O 1791 J O -1791 J O 1051 J O 1421 J O E) None of the above
The uniform 80 kg slender rod is at rest in the position shown when P = 450 N is applied. Determine the value of angular velocity, w2 the rod if L1 = 5.5 m and L2 = 6.5 m. A L L2 L1 B
0₁ Oy || 5 Kronk is asked to pull the lever. He applies a force of 20 N, causing the 8 kg lever to have an angular rad velocity of 3 || 6 8 . Determine the angular acceleration of the lever and the reaction forces at O. Assume the lever is a slender rod and that the lever was originally propped up to be level horizontally. The prop was removed at the instant Kronk applied the force. α = 5 Kronk applies the force at a length 7 and the lever has length 1 = 0.2 m. Use negative if CW 1 N N 1 rad 8² F (0) -CCW