Please correct answer and don't used hand raiting (5) Calculate the melting point of ice under a pressure of 50 bar given that the melting point at 1bar is 0°C. Assume that the density of ice under these conditions is 0.92 g/mL and thedensity of liquid water is 1.00 g/mL. The molar enthalpy of fusion of water is 6.01 kJ/mol.

Answered: Image /qna-images/answer/a72efb07-2a7c-4d97-8bba-c7524274a2dd.jpg

Answered: (5) Calculate the melting point of ice…

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter9: Liquids, Solids, And Materials

Section: Chapter Questions

Problem 43QRT

See similar textbooks

Similar questions

The vapor pressure of ethanol, C2H5OH, at 50.0 C is 233 mmHg, and its normal boiling point at 1 atm is 78.3 C. Calculate the vapH of ethanol.
A portion of the crystalline lattice for potassium is illustrated below. (a) In what type of unit cell are the K atoms arranged? A portion of the solid-state structure of potassium. (b) If one edge of the potassium unit cell is 533 pm, what is the density of potassium?
Dichloromethane, CH2Cl2,is widely used as a degreaser and paint stripper. Its vapor pressure is 381.0 mm Hg at 21.9C and 465.8 mm Hg at 26.90C. Estimate (a) its heat of vaporization (Hvap). (b) its normal boiling point.
The compounds ethanol (C2H5OH) and dimethyl ether (CH3OCH3) have the same molecular formula. Which is expected to have the higher surface tension? Why?
The phase diagram for water over a relative narrow pressure and temperature range is given in Figure 9.19. A phase diagram over a considerably wider range of temperature and pressure (kbar) is given nearby. This phase diagram illustrates the polymorphism of ice, the existence of a solid in more than one form. In this case, Roman numerals are used to designate each polymorphic form. For example, Ice I, ordinary ice, is the form that exists under ordinary pressures. The other forms exist only at higher pressures, in some cases extremely high pressure such as Ice VII and Ice VIII. Using the phase diagram, give the approximate P and T conditions at the triple point for Ice III, Ice V, and liquid water. Determine the approximate temperature and pressure for the triple point for Ices VI, VII, and VIII. What is anomalously different about the fusion curves for Ice VI and Ice VII compared to that of Ice I? What phases exist at 8 kbar and 20 °C? At a constant temperature of −10 °C, start at 3 kbar and increase the pressure to 7 kbar. Identify all the phase changes that occur sequentially as these conditions change. Explain why there is no triple point for the combination of Ice VII, Ice VIII, and liquid water.
A 1.50-g sample of methanol (CH3OH) is placed in an evacuated 1.00-L container at 30 C. (a) Calculate the pressure in the container if all of the methanol is vaporized. (Assume the ideal gas law, PV = nRT.) (b) The vapor pressure of methanol at 30 C is 158 torr. What mass of methanol actually evaporates? Is liquid in equilibrium with vapor in the vessel?
Palladium has a cubic crystal structure in which the edge of the unit cell is 389 pm long. If the density of palladium is 12.02 g/cm3, how many palladium atoms are in a unit cell? In which of the cubic unit cells does palladium crystallize?
p-Dichlorobenzene, C6H4Cl2, can be one of the ingredients in mothballs. Its vapor pressure at 20C is 0.40 mm Hg. (a) How many milligrams of C6H4Cl2 will sublime into an evacuated 750-mL flask at 20C? (b) If 5.0 mg of p-dichlorobenzene were put into an evacuated 750-mL flask, how many milligrams would remain in the solid phase? (c) What is the final pressure in an evacuated 500-mL flask at 20C that contains 2.00 mg of p-dichlorobenzene? Will there be any solid in the flask?
Describe the behavior of a liquid and its vapor in a closed vessel as the temperature increases.
Consider the following data for xenon: Triple point: 121C, 280 torr Normal melting point: 112C Normal boiling point: 107C Which is more dense, Xe(s) or Xe(l)? How do the melting point and boiling point of xenon depend on pressure?
Arrange the following substances in order of increasing strength of the crystal forces: He, NH3, NO2, NaBr, BaO. Identify the kinds of forces that are most important in holding the particles together in a crystalline solid sample of each of the following substances. (a) H2O (b) C6H6 (c) CaCl2 (d) SiO2 (e) Fe
The molar heat of fusion of sodium metal is 2.60 kJ/mol, whereas its heat of vaporization is 97.0 kJ/mol. a. Why is the heat of vaporization so much larger than the heat of fusion? b. What quantity of heat would be needed to melt 1.00 g sodium at its normal melting point? c. What quantity of heat would be needed to vaporize 1.00 g sodium at its normal boiling point? d. What quantity of heat would be evolved if 1.00 g sodium vapor condensed at its normal boiling point?

Recommended textbooks for you

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Introductory Chemistry: An Active Learning Approa…

Chemistry

ISBN:

9781305079250

Author:

Mark S. Cracolice, Ed Peters

Publisher:

Cengage Learning

Chemistry: Matter and Change

Chemistry

ISBN:

9780078746376

Author:

Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:

Glencoe/McGraw-Hill School Pub Co

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Introductory Chemistry: An Active Learning Approa…

Chemistry

ISBN:

9781305079250

Author:

Mark S. Cracolice, Ed Peters

Publisher:

Cengage Learning

Chemistry: Matter and Change

Chemistry

ISBN:

9780078746376

Author:

Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:

Glencoe/McGraw-Hill School Pub Co

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Chemistry for Engineering Students

Chemistry

ISBN:

9781337398909

Author:

Lawrence S. Brown, Tom Holme

Publisher:

Cengage Learning

Chemistry: Principles and Reactions

Chemistry

ISBN:

9781305079373

Author:

William L. Masterton, Cecile N. Hurley

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

(5) Calculate the melting point of ice under a pressure of 50 bar given that the melting point at 1 bar is 0°C. Assume that the density of ice under these conditions is 0.92 g/mL and the density of liquid water is 1.00 g/mL. The molar enthalpy of fusion of water is 6.01 kJ/mol.