4. A conductor carries a current that maybe regarded as equivalent to the sum of two components, one of them being a continuous direct current of 4.2 amp and the other a superimposed full-wave rectifier current. If the latter has a maximum value of 6.4 amp, calculate the average current in the wire if (a) both components have the same direction, (b) the two components are oppositely directed? 5. Solve prob.4 assuming the superimposed rectified component is half-wave with a maximum value of 8.3 amp.

Q: 3. A 3-phase full-wave bridge rectifier is built using six power diodes numbered 1 to 6. The phase…

A: 3-phase full wave bridge rectifier,Line voltage=191Vangle=30 degrees

Q: Shown below is a diode circuit. If the input signal Vs = 34 Vp-p and the DC voltage Vdc = 5 V, what…

A:

Q: H.W2 The single-phase full wave controlled rectifier has a with R= 0.50 and L= 6.5mH. The input…

A: Supply voltage,vs=Vm=220VResistance, R=0.5ΩInductance,L=6.5mHDelay angle, α=600Angular frequiency…

Q: For the given circuit below, it operates on a peak- to-peak input voltage of 112.3 V, F = 60 Hz…

A: Given Pek to peak Voltage = 112.3v Voltage peak, V1 = 112.3/2 =56.15v Input to rectifier, V2=(…

Q: load current is continuous current.

A: given full wave rectifier with L = 6.5 mH, R= 2.5 ohm, E= 10 V  frequency = 60 Hz assume that the…

Q: A full wave and a half wave rectifier with identical components and load, are fed from a sinusoidal…

A:

Q: A clamper circuit has 20 Vp-p, 100 Hz square wave input voltage. The circuit consists of silicon…

A:

Q: Figure Q3 shows a full bridge rectifier circuit. The input line voltage is 120 Vrms and the line…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Component conditions: 1. Rectifying Diode Breakdown voltage- 100v When diode is on- diode gets…

A: According to the question, for the given circuit as shown belowWe need to check the operation of the…

Q: The four diodes used in a bridge rectifier circuit have forward resistances which may be considered…

A:

Q: In the given circuit, (diodes will be considered ideal. a) Draw the V0 output by calculating it…

A:

Q: The two Zener diodes ofF FiG below have neglig;ble forwarod drops, and both regulate at Constant Vz…

A:

Q: A single phase bridge rectifier supplied from a 120V - 50 Hz sinusoidal source is connected to an…

A:

Q: Q3/ A- Convert the following numbers to their binary equivalent. (C8E)16 ; (140)s ; (1001…

A: As per bartleby expert policy, only three subparts are to be answered. Kindly repost remaining…

Q: The diodes in the circuit depicted can be modelled as ideal diodes with an 0.7 V diode drop. The…

A: Forward voltage drop across diode=0.7VVin=1V(peak)

Q: B) For the circuit shown in Figure 5, sketch the output voltage V, for the input V.. D, is an ideal…

A: The diode turns forward biased when the anode voltage is greater than the cathode voltage. The ideal…

Q: b) For the network in figure, input is supplied by a sine wave

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: R= 2.2k D1 R vo Input Voltage = Vi = 120 Vrms 60HZ vs Output Voltage = 6.3 Vrms Diodes = 1N4001 vs…

A:

Q: V Assume that the direction of the reverse DC voltage applied to the above Zener diode is from the…

A: We need to tell about input voltage to work zener diode in zener region . We also need to tell about…

Q: A half-wave rectifier uses dio de, with internal resistance assumed to be constant at 402. If the…

A:

Q: Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the…

A:

Q: 1) Diode half-wave rectifier a) Consider the half-wave rectified sinewave voltage waveform at the…

A: The  output waveform of the half-wave rectifier,

Q: Activity 1: A rectifier circuit is used to charge a 12 Vde battery using a 40 Vp-p AC source,…

A: Since you have posted a question with multiple subparts, we will solve first part for you. If you…

Q: In the circuit given in the figure, since Vi is a square wave with a frequency of 1 kHz and an…

A: According to the question, for the given circuit as shown belowVi is a square wave with a frequency…

Q: The input voltage in the following circuit is Vs = 33.62 V rms and the frequency is 50 Hz. The value…

A:

Q: A 3-phase full-wave bridge rectifier is built using six power diodes numbered 1 to 6. The phase…

A: As per given information, rectifier circuit is as shown below Vab =191 V

Q: In the voltage regulator circuit shown below the power rating of Zener diode is 400 mW. The value of…

A: Zener diode is heavily doped semiconductor that conduct in forward and reverse direction In forward…

Q: Design an Voltage amlifier to amplify 150 mV U P to 5v. with the necessary calcula tions and drawing…

A: In its most basic form, a voltage amplifier is any circuit that produces a higher voltage than the…

Q: a steady dc signal. If SCR2 is made open circuit, what will be the average charge current?

A: The single phase full-wave rectifier is a device which convert an AC wave into a pulsing Dc for a…

Q: Q2. A full-wave controlled rectifier circuit with resistive load shown below: Calculate the firing…

A: Given that  A full-wave controlled rectifier circuit with resistive load shown below: Calculate the…

Q: In the figure given we have u(t)=10- cosøt [V]. We assume the diodes and the A-meter (A) to be…

A:

Q: Q4 (a) Find the current through the diode, Ip in the circuit shown in Figure B.1 if the (1) ideal.…

A:

Q: èstion 23 During the analysis of diode circuits, the forward resistance will be considered if model…

A: An ideal has zero forward resistance A complete model of diode consists of forward resistance,…

Q: Q4) For the Zener regulated power supply shown below the rms value of vs is 15 V, the operating…

A: According to the question we have to find, Find Voutput & find the ripple voltage.

Q: Which of the following indicates the correct rms value of the diode current for a 1-6 full bridge…

A: The objective of the question is to find the root mean square (rms) value of the diode current for a…

Q: For the given circuit below, it operates on a peak-to-peak input voltage of 413.3 V, F = 60 Hz…

A: Given Peak to peak voltage = 413.3V Peak voltage = 413.3/2 =206.65V V1/V2 = N1/N2 V2 = (N2/N1) *V1 =…

Q: 4) For Single-phase half-controlled bridge rectifier shown in the figure : 1- Derive a formula for…

A: Answer(1) For 1 phase half controlled rectifier the mean voltage is given by,…

Q: the circuit shown in Figure 1, where R1 = 2.2 kΩ, R2 = 22 kΩ, and R3 = 4.7 kΩ. the supply is at 6 V.…

A:

Q: VRL = ? Iz = ? P₂ = ? + = R + Vz I Iz PZM RL

A: Given Data:A Zener voltage regulator with,Input voltage Zerner breakdown voltage  (Negative sign…

Q: Design the single-phase half wave controlled rectifier has a purely resistive load of R=1092 and the…

A: In the given questions we need to design the single phase half wave controlled rectifier based on…

Q: Shown below is a diode circuit. If the input signal Vs = 31 Vp-p and the DC voltage Vdc = 8 V, what…

A: Circuit diagram is given as,  It is a negative clamper with negative reference voltage.

Q: the given circuit, (diodes will be considered ideal. a) Draw the V0 output by calculating it…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.