A 3-phase full-wave bridge rectifier is built using six power diodes numbered 1 to 6. The phase sequence of the 3-phase source is ABC and the line to line voltage is 191 V. The line to neutral voltage of phase A has an angle of -30 degrees. The anodes of the diodes 1, 2, 3 are connected to phase A, B, and C, respectively, and the cathodes of diodes 1, 2, and 3 are connected to a common terminal that serves as the positive terminal of the rectifier's output. The cathodes of diodes 4, 5, and 6 are connected to phase A, B, and C, respectively, and the anodes of diodes 4, 5, and 6 are connected to a common terminal that serves as the negative terminal of the rectifier's output.  If diodes 1 and 3 are damaged and act as an open circuit, what would the DC voltage be at the load?

Q: Which of the following statements are FALSE?

A:

Q: In the circuit of the following figure, the input voltage Vs is 15 volts rms with a frequency of 60…

A: Input voltage Vs=15 V  (rms) Frequency f=60 Hz Resistance R=150 ohms Capacitance C=100,000 pF Vd=0.2…

Q: I need some help with this problem. I need to create a power supply from 110v 60hz to regulated an…

A: According to the question, we need to design the circuit as shown below The desired output is 6 - 9…

Q: In a given circuit below is connected to an AC signal with 240V peak in a 4:1 transformer. Sketch…

A: It is given that:

Q: 10Ω 5 V. 8 (a)

A:

Q: Question 13 The Zener breakdown occurs at moderate voltages because of tunneling of charge carriers…

A: The Zener breakdown takes place because of a high electric field. Whenever the high electric-field…