For the given circuit below, it operates on a peak-to-peak input voltage of 413.3 V, F = 60 Hz household supply through a step-down transformer with turns N1 = 10 and N2 = 1. Silicon diodes are used with a 1 Kiloohms load. Determine the output peak voltage (in volts). D1 D2 AC Input (source) Vsec B D3 D4 Load 19.27 14.76 22.07 28.93 ellle

Q: What does the following code do? LDA 1000H MOV B, A LDA 2000H STA 1000H MOV A, B STA 2000H Loads the…

A: INSTRUCTION SET BASED ON OPERATION MODES: Data transfer (Copy) instructions set: In this group, the…

Q: draw an 8:1 multiplexer using 4:1 multiplexers

A: Need to draw the 8x1 multiplexer by using the 4x1 multiplexer. The design needs 2 numbers of 4x1…

Q: QUESTION 29 Select all signals that are inputs for the 8088. Use the schematic for our board. OSC…

A: Consider the schematics of 8088 shown below,

Q: In HDB3, If the number of non-zero pulses is even, the format used is a. V000 b. B00V c. V00B d.…

A: The HDR-3 is HIgh Density Bipolar 3 Zero Coding.It is more conservative than other coding methods

Q: 3. Using Mason's Rule, find the transfer function T(s) = for the system represented in the fugre.…

A: Signal flow graphwe have to find Transfer function

Q: The minimum multiplexers using to design 256-to-1 multiplexer are

A:

Q: 32K×4 A14 En • CS

A:

Q: represents a circuit breaker with thermal overload protection? A. C B. D C. A D. B

A:

Q: Need solution within 15 mins. Give 5 stars for correct solution

A: The solution is provided in the following section:

Q: A student takes five measurements of length with a centimeter ruler. Write the measured value with…

A: According to the question, a student takes five measurements of length with a centimeter ruler.…

Q: can you write it in paper and use super position

A:

Photoconductive Cell

Photoconductive cells are light-sensitive resistors in which resistance is inversely proportionated to light intensity when illuminated. These devices consist of a thin single-crystal or polycrystalline film of composite semiconductor materials. Cadmium sulfide (CdS) is used to make the most commercially available photoconductive particles which are sensitive to light in the visible spectrum. Other less commonly used substances respond to infrared light, but not to the visible spectrum. Such substances are lead sulfide (PbS), lead selenide (PbSe), and lead telluride (PbTe), and so on.