•30 A 0.400 kg sample is placed in a cooling apparatus that re- moves energy as heat at a con- stant rate. Figure 18-33 gives the temperature T of the sam- ple versus time t; the horizon- tal scale is set by t,= 80.0 min. The sample freezes during the energy removal. The specific heat of the sample in its initial liquid phase is 3000 J/kg K. What are (a) the sample's heat of fusion and (b) its specific heat in the frozen phase? 300 270 250 t (min) Figure 18-33 Problem 30. T (K)

•30 A 0.400 kg sample is placed in a cooling apparatus that re- moves energy as heat at a con- stant rate. Figure 18-33 gives the temperature T of the sam- ple versus time t; the horizon- tal scale is set by t,= 80.0 min. The sample freezes during the energy removal. The specific heat of the sample in its initial liquid phase is 3000 J/kg K. What are (a) the sample's heat of fusion and (b) its specific heat in the frozen phase? 300 270 250 t (min) Figure 18-33 Problem 30. T (K)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

3) An open system allows mass flows across the system boundary carrying 4000 kJ of energy. The change in system energy of 1800 kJ was gained when the system receives 280 kJ of heat and the energy carried out by the air is 480 kJ. Calculate the amount of rejected work.
A cheese ripening room which, has a total surface area of A = 25.0m2, has to ensure that the inside temperature does not exceed 11.0°C at all times. If the maximum outside temperature is 35.0°C and the cheese ripening room has an air conditioner which provides 125 kW of cooling, calculate the how thi ck the wooden walls would need to bein mm, in order to ensure the inside temperature do es not go above 11.0°C. Assume that the thermal W conductivity, k of wood is 0.0800 Assume that the entire cheese ripening room is m.C made of wood (including ceiling and floor) and ignore any losses through the door as it remains closed most of the time and is well sealed. Given: P = KA(Tinside –Toutside ) L
A 0.217 kg sample of tin initially at 96.9◦Cis dropped into 0.112 kg of water initially at10.2◦C.If the specific heat capacity of tin is230 J/kg ·◦C, what is the final equilibriumtemperature of the tin-water mixture? Thespecific heat of water is 4186 J/kg ·◦C.Answer in units of ◦C.
GHANA SCHOC EXERCIS BOOK NOTE 1 ALEX MORGAN - An object of emisivity 07 and cooss- sectional of SSmm? ait room tempeiature area of 30 lasseS energy dt What is the initial temperature I o=5.6703 x 103 w/m/x+] a rate of 35.65/s. of the object?
In this problem you will estimate the heat lost by a typical house, assuming that the temperature inside is Tin = 20°C and the temperature outside is Tout = 0°C. The walls and uppermost ceiling of a typical house are supported by 2 x 6-inch wooden beams (kwood = 0.12 W/(mK)) with fiberglass insulation (kins = 0.04 W/(mK)) in between. The true depth of the beams is actually 5.625 %3D %3D %3D inches, but we will take the thickness of the walls and ceiling to be Lwall = 18 cm to allow for the interior and exterior covering. Assume that the house is a cube of length L = 9.0 m on a side. Assume that the roof has very high conductivity, so that the air in the attic is at the same temperature as the outside air. Ignore heat loss through the ground. The effective thermal conductivity of the wall (or ceiling) keff , is the area-weighted average of the thermal conductivities of the wooden beams and the fiberglass insulation that make up each of them. Allowing for the fact that the 2 x 6 beams…
Unreasonable Results - A meteorite 1.20 cm in diameter is so hot immediately after penetrating the atmosphere that it radiates 20.0 kW of power. (a) What is its temperature, if the surroundings are at 20.0C and it has an emissivity of 0.800? (b) What is unreasonable about this result? (c) Which premise or assumption is responsible?
0•19 A 1.28-m-long vertical glass tube is half filled with a liquid at 20°C. How much will the height of the liquid column change when the tube is heated to 30°C? Take aglass = 1.0 x 10-5/K and Bliquid = 4.0 × 10-$/K. The answer IS O.13 mm. Please explain in neat and clear detal how I can arrive to get this answee. Thina you!
Review 8-64 (algorithmic) Question Help ▼ When boiling water, a hot plate takes an average of 8 minutes [min] and 35 seconds [s] to boil 110 milliliters [mL] of water. Assume the temperature in the lab is 71 degrees Fahrenheit ["F]. The hot plate is rated to provide 385 watts [W]. If we wish to boil 110 milliliters [mL] of acetone using this same hot plate, how long do we expect the process to take? Acetone has a boiling point of 56 degrees Celsius [c]. [Hint: you must determine the efficiency of the hotplate.] Click the icon to view conversion formulas for temperature scales. Click the icon to view the factors for conversions involving temperature differences. Click the icon to view the conversion table. E Click the icon to view the density of water. E Click the icon to view the table of specific heats. E Click the icon to view the specific gravities of liquids. The time required to boil 110 mL of acetone is s. (Round your answer to the nearest whole number.) More Enter your answer in…
Nuclear fusion, the energy source at the Sun, hydrogen bombs, and fusion reactors, occurs much more readily when the average kinetic energy of me alums is high-that is, at high temperatures. Suppose you want me atoms in your fusion experiment to have average kinetic energies of 6.40 × 10-14J. What temperature is needed?
490 grams of copper pellets are removed from 150 ° C oven and immediately dropped into 650 mL of water in an insulated cup . The temperature of water raises 43 ° C then remains at that temperature . Calculate the following : a) Mass of water in kilograms b) The heat energy removed from copper pellets in joules • ( Sp.Heat of copper is 385 J / Kg ° C ) c) The initial temperature of water degree celsius ( Sp.Heat of water = 4186 J / kg ° C )
A) Estimate the total solar heating absorbed by the Earth every second. Assume 36% of the incoming solar radiation is reflected by clouds and lost. You can assume that the Earth intercepts sunlight with an effective area of πr2 where r is Earth’s radius. B) Estimate the total heat lost by the Earth as infrared radiation every second. Assume Earth has an effective temperature of 252 K (-21 C).