3. What is the reactive factor of a circuit that has an input impedance of 40L50 Q? Also, what reactive power does the circuit absorb when the input current is 5 A? 4. Find the power components of a load that draws 20 L-30 A with 240 L20 V applied.

Q: I, I. The values of E, R, and I are given on the Student Values Spreadsheet. Give the values of I1…

A: Given circuit, Where, E = 62 VR = 31 OhmI = 87 A

Q: 1. An 8-bit register contains the number 10000110. The serial number 11011011is applied to the…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 8 Look at the photo of the boys on the charity Write the correct answer. 1 Paul and Donny _are a is…

A: Given

Q: Please answer in typing format

A: Step 1: Calculate the Annual Loan Repayment (L): Using the formula for the annual payment on a loan:…

Q: 3.) A power supply circuit is shown below. For the diodes, assume Vy = 0.7V. Sketch the output…

A:

Q: Do you know what to do if the electricity in your house suddenly surges and you don't want your…

A: Yo, if you're dealing with a sudden power surge and wanna save your computer from biting the dust,…

Q: 1. Explain the significance of the following statement: In a series resistive circuit, in order to…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Q2: What is a demultiplexer? Explain some applications

A: A demultiplexer (also known as a demux or data distributor) is a circuit which can distribute or…

Q: Three 47.1 ohm resistors and three 17.1 H inductors are all in series with a 37 volt battery and a…

A:

Q: 5. What are the advantages of Centre tapped and Bridge Rectifier?

A: Various loads work on DC, but the supply available to us naturally is AC supply. Rectifier is a…

Q: An offset / must be introduced into a metal tube of 0.75-in. outer diameter and 0.08-in. wall…

A: An offset h must be introduce into a metal tube of 0.75-in.outer diameter and 0.08-in.The internal…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.