3. The figure shows how a stream of water emerging from a faucet "necks down" as it falls. The change in the horizontal cross-sectional area is characteristic of any laminar (non- turbulent) falling stream because the gravitational force increases the speed of the stream. Here the indicated cross-sectional areas are A₁ = 1.2 cm² and A = 0.35 cm². The two levels are separated by a vertical distance h = 45 mm. What is the volume flow rate from the tap?

3. The figure shows how a stream of water emerging from a faucet "necks down" as it falls. The change in the horizontal cross-sectional area is characteristic of any laminar (non- turbulent) falling stream because the gravitational force increases the speed of the stream. Here the indicated cross-sectional areas are A₁ = 1.2 cm² and A = 0.35 cm². The two levels are separated by a vertical distance h = 45 mm. What is the volume flow rate from the tap?

Name: 3. The figure shows how a stream of water emerging from afaucet "neck
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: 3. The figure shows how a stream of water emerging from afaucet "necks down" as it falls. The change in the horizontalcross-sectional area is characteristic of any laminar (non-turbulent) falling stream because the gravitational force increasesthe s

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in the figure below, the pressure is 1.65 ✕ 105 Pa and the pipe radius is 2.60 cm. At the higher point located at y = 2.50 m, the pressure is 1.29 ✕ 105 Pa and the pipe radius is 1.40 cm. a) Find the speed of flow in the lower section. b) Find the speed of flow in the upper section. c) Find the volume flow rate through the pipe.
A cylinder that is h1=18.0 cm tall and open on top is filled with water. If a hole is made in the side of the cylinder, Δh=3.90 cm below the top level, how far x from the base of the cylinder will the stream land? Assume that the cylinder is large enough so that the level of the water in the cylinder does not drop significantly.
3. One of the dangers of tornados and hurricanes is the rapid drop in air pressure that is associated with such storms. Assume that the air pressure inside of a sealed house is 1.02 atm when a hurricane hits. The hurricane rapidly decreases the external air pressure to 0.910 atm. A square window in an outside wall of the house measures 2.02 m on each side. What is the magnitude of the net force (directed outwards) exerted on this window? (1 atm = 1.0135 x 105 Pa.)
ECIDO Consider a liquid (p = 1 kg/m³,) in a large bottle. It flows through a rather thin tube and come out of the tube at D. The cross-sectional area of the tube at C is c = 0.2 m², while all other parts have a cross-sectional area b = 0.1 m². The atmospheric pressure is Po= 105 Pascal, and the gravitational acceleration is g = 9.8 m/sec². Assume that the bottle is so large that the motion of the liquid at A is negligible. (hA = 50 m, hB = 10 m, hp = 30 m). A Пл 1) 2) 3) he a B 0 по What is the pressure PD at D? What is the speed VD of the liquid at D? Assuming a continuous liquid flow in the tube, what is the pressure at C?
2. DETAILS S An incompressible fluid flows with velocity 12.00m through a round pipe with radius 2.30cm. If the pipe changes size and has a new, smaller radius of 0.20cm, what is the speed of the fluid moving through the narrower segment of pipe? m S What is the total volume flow rate for this pipe, in units of O 19.94- 11965698.10 L min L min L min 0.02- 1196.57- L min 1.20- L min L min MY NOTES (1000L=1m³ )? ASK YOUR TEACHER
3. Water moves through a constricted pipe in steady and ideal flow. At the lower point shown in figure, the pressure is 1.75 × 105 Pa and the pipe radius is 3.00 cm. At the higher point located at y = 2.50 m, the pressure is 1.20 x 105 Pa and the pipe radius is 1.50 cm. Find the speed of flow (a) in the lower section and (b) in the section. upper P2 P1 Address 99+ PrtScn Home End
4.0 mm 16. Consider the following diagram. (let air be an ideal, incompressible fluid) 2.0 cm 1200 cm'/s a. If the air is found to have a flow rate of 1200 cm3/s as it leaves the 4.00 mm diameter pipe, what is the velocity of the air in both segments of the pipe? b. If the density of air is 1.28 kg/m3 and the end of the pipe on the right opens up to the atmosphere, what is the pressure of the pipe at the 2.00 cm diameter section? C. If the fluid in the bottom of the U-tube is mercury with a density of 13,600 kg/m3 what is the difference between the surface levels of both sides of the tube, marked as h in the diagram?
4. A raft is made of 12 logs lashed together. Each is 30.5 cm in diameter and has a length of 6,00 m. How many people (whole number) can the raft hold before they start getting their feet wet, assuming the average person has a mass of 66.0 kg? Do not neglect the weight of the logs. Assume the density of wood is 600 kg/m3 People (whole number) 741 n na741 na
The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of 1.65 g/cm³ flows from left to right in the pipe, from larger to smaller cross section. The left side's cross-sectional area is 10.0 cm², and while in this side, the speed of the liquid is 2.72 m/s, and the pressure is 1.20 × 105 Pa. The right side's cross sectional-area is 4.00 cm². (a) What is the speed (in m/s) of the liquid in the right side (the smaller section)? (Enter your answer to at least three significant figures.) m/s (b) What is the pressure (in Pa) of the liquid in the right side (the smaller section)? Pa