Answered: 8. Water at a pressure of 4.00 atm at… | bartleby

Related questions

Question

8. Water at a pressure of 4.00 atm at street level flows into an office building at a speed of 0.40 m/s through a pipe 3.60
cm in diameter. The pipes taper down to 1.90 cm in diameter by the top floor, 24.0 m above. Calculate the water pressure
in such a pipe on the top floor.
Pa
shpl
shpl
pl

Expert Solution

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

3. What is the laminar flow rate of water in a pipe with an internal radius of r and a length of L m if the pressure difference across the pipe is 2.0 kPa? The water in the pipe has a viscosity of approximately 0.6 mPa-s. let r =2.5 cm let L=0.5m Describe the effect on the flow rate given each of the following changes. Each change is to the original system and all other variables are held constant. The radius decreases The pipe length decreases The fluid viscosity decreases The pressure difference decreases
4
1. A capillary tube of inside diameter d=6mm connects tank A and open container B as shown in Fig.2. The liquid in A,B and capillary CD is water having a specific weight y=9780 N/m³ and a viscosity of μ=0.0008N s/m². The pressure PA-34.5 kPa gage. Neglecting the minor losses at C and D, determine the flow rate Q through the capillary tube. Assume laminar flow from A to B and use h=32μLV/yd² for the friction loss, where V is the water velocity through the capillary tube. (2) Container B 1.4 m Datum 1-4.3 m 45° D (1) Air Tank A Im 200151816
9. A liquid is flowing through a horizontal pipe whose radius is 2.22 x10-2 m. The pipe bends straight upward through a height of 9.8 m and joins another horizontal pipe whose radius is 3.82 x10-2 m. What is the speed of the liquid in the lower horizontal pipe if the pressure in both horizontal pipes is the same? x L0228) m/s
4.0 mm 16. Consider the following diagram. (let air be an ideal, incompressible fluid) 2.0 cm 1200 cm'/s a. If the air is found to have a flow rate of 1200 cm3/s as it leaves the 4.00 mm diameter pipe, what is the velocity of the air in both segments of the pipe? b. If the density of air is 1.28 kg/m3 and the end of the pipe on the right opens up to the atmosphere, what is the pressure of the pipe at the 2.00 cm diameter section? C. If the fluid in the bottom of the U-tube is mercury with a density of 13,600 kg/m3 what is the difference between the surface levels of both sides of the tube, marked as h in the diagram?
10. Water flows at a rate of 730.0 liters/min through a horizontal 5.80-cm diameter pipe under a pressure of 6.50 x105 Pa. At one point, calcium deposits reduce the cross-sectional area of the pipe to 8.50 cm?. What is the pressure at this point? Pa
3. Water at a pressure of 4.30 atm at street level flows into an office building at a speed of 0.75 m/s through a pipe 4.60 cm in diameter. The pipes taper down to 1.70 cm in diameter by the top floor, 22.0 m above. Calculate the water pressure in such a pipe on the top floor. Pa