A water line with a 1/2 inch pvc pipe (diameter) that has a constant water pressure of 7psi is connected through a 1/2 inch hose with an elevation of 1.57m. what will be the flowrate of the water at the end of the hose? the end of the hose is then connected into a 3/4 inch hose and a 3mm nozzle. what will be the flowrate and pressure of the water that will leave the nozzle and how far can the water reach assuming a 45 degrees pointing downwards

A water line with a 1/2 inch pvc pipe (diameter) that has a constant water pressure of 7psi is connected through a 1/2 inch hose with an elevation of 1.57m. what will be the flowrate of the water at the end of the hose? the end of the hose is then connected into a 3/4 inch hose and a 3mm nozzle. what will be the flowrate and pressure of the water that will leave the nozzle and how far can the water reach assuming a 45 degrees pointing downwards

Similar questions

A water tank has a spigot near its bottom. If the top of the tank is open to the atmosphere, determine the speed at which the water leaves the spigot when the water level is 0.8 m above the spigot.
The water of a 14’ × 48’ metal frame pool can drain from the pool through an opening at the side of the pool. The opening is about h = 1.11 m below the water level. The capacity of the pool is V = 3880 gallons, the pool can be drained in t = 10.2 mins. P0 is the pressure of the atmosphere. ρ is the density of the water. a) Write the Bernoulli’s equation of the water at the top of the pool in terms of P0, ρ, h. Assuming the opening is the origin. b) Write the Bernoulli’s equation of the water at the opening of the pool in terms of P0, ρ, h and v, where v is the speed at which the water leaves the opening. Assuming the opening is the origin. c) Express the flow rate of the water in terms of V and t. d) Calculate the numerical value of A in cm2
Water is circulating through a closed system of pipes in a two-floor apartment. On the first floor, the water has a gauge pressure of 3.1 105 Pa and a speed of 2.4 m/s. However, on the second floor, which is 3.8 m higher, the speed of the water is 3.6 m/s. The speeds are different because the pipe diameters are different. What is the gauge pressure of the water on the second floor? Number Units. Pa
The pressure drop along a length of artery is 103 Pa, the radius is 9.5 mm, and the flow is laminar. The average speed of the blood is 16.5 mm/s.Randomized Variables P = 103 Par = 9.5 mms = 16.5 mm/s a. What is the net force on the blood in this section of artery in N? b. What is the power expended maintaining the flow in mW?
Suppose you have a 9.6 cm diameter fire hose with a 2.2 cm diameter nozzle. a.) Calculate the pressure drop due to the Bernoulli effect as water enters the nozzle from the hose at the rate of 40.0 L/s. Take 1.00 × 103 kg/m3 for the density of the water. b.) To what maximum height, in meters, above the nozzle can this water rise? (The actual height will be significantly smaller due to air resistance.)
3 8.54
Pipe. Water flows from left to right through a pipe with dimensions shown in the figure. If the water is flowing with a speed of 1.25[m/s] at point A, what is the pressure difference between points A and B? 1.00 cm Select one: A 2.34[kPa] ○ 2.50[kPa] O 0.781[kPa] O 1.88[kPa] 0.500 cm B
Note: FBD is mandatory,So please include it.
The mattress of a water bed is 3.00m long by 0.03cm wide and 0.3m deep. A. Find the weight of the water in the mattress. B. Find the pressure exerted by the water on the floor when the bed rests in its normal position. Assume that the entire lower surface of the bed makes contaxt with the floor. C. What is the water bed is replaced by a 300lb ordinary bed that is supported by four legs? Each leg has a circular cross section of radius 2.00cm. what pressure does this bed exert on the floor?
If it takes 2.15 min to fill a 23.0 L bucket with water flowing from a garden hose of diameter 3.10 cm, determine the speed at which water is traveling through the hose. If a nozzle with a diameter two-fifths the diameter of the hose is attached to the hose, determine the speed of the water leaving the nozzle.
Water flows with a constant speed through a pipe of constant cross-sectional area in the ground floor (y1=0m) of a house. The pipe rises (y2=5.0m) to reach a shower head on the second floor. The pressure at ground level is 140kPa. a) what is the pressure at the shower head? b) what is the maximum height that water from the ground level could reach?
A fish tank has dimensions 42 cm wide by 1.0 m long by 0.80 m high.If the filter should process all the water in the tank once every 3.0 h, what should the flow speed be in the 3.0-cm- diameter input tube for the filter?Express your answer to two significant figures and include the appropriate units.