3. Perfect resistor of resistance R=42, a perfect capacitor of reactance Xc=992 and a perfect coil of reactance X₁-62 are connected in series and supplied by a sinusoidal voltage source of effective (r.m.s.) value U=5V. Find the effective (r.m.s.) value of the taken current - I=?, and the power factor - cosp=?.

3. Perfect resistor of resistance R=42, a perfect capacitor of reactance Xc=992 and a perfect coil of reactance X₁-62 are connected in series and supplied by a sinusoidal voltage source of effective (r.m.s.) value U=5V. Find the effective (r.m.s.) value of the taken current - I=?, and the power factor - cosp=?.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A voltage vz(t) = 10 cos(2000zt) is applied to a 100-mH inductance. Find the complex impedance of the inductance. Find the phasor voltage and current, and construct a phasor diagram. Write the current as a function of time. Sketch the voltage and current to scale versus time. State the phase relationship between the current and voltage.
a) The voltage across a 20uF capacitance is v. = 50 sin( at - 80) volts and Frequency equal to 100 Hz. Determine the current through the capacitor i and sketch its waveform. b) Define phasor
The current through a 50 mH inductor is given below. Use Ohm’s Law to find the voltage. Convert to polar form, find the impedance and complete the math, then convert back to the waveform at i1 = 7.5sin(2500t – 20°) mA and i2 = 5.9sin(200t + 40°) mA
Consider a drcuk where an ideal inductor L=D.144H is connected in parallel to a resistor R=1.00k. This combination is connected in series with a capacitor C=3.67e-07. This combination in connected to a power supply source of frequency f-3.4kHz. To study this circuit you need to drawa phasor diagram. Note the sum cf the current phasors through the resistor and the inductor must be equal to the phasor representing the current through the capacitor fie. the total current). You should draw the phasor for the current through the capadtor on the horizontal axis, since this is also the total ourrent delivered by the supply. The angie between this phasor and that of the power supply represents the phase angle o. Note that the voltage across the inductor equals the voltage aoross the resistor since they conmected parallel to esch other. Furthermore the sum of the phasors representing the currents through the inductor and the resistor equals the phasor representing the current through the…
i need the answer quickly
3-10 A0.25-F capacitor has a current waveform i(t) as shown in Figure P3–10. Determine and plot the voltage waveform v(t) as a function of time. The capacitor is initially a and plot the voltage waveform v(t) as a function of time. The capacitor is imu uncharged. FIGURE P3-10 ilt) 4 A 6. -4 A
A capacitor "C", an inductor "L" and a switch "S" are connected in series. When the switch is open, the plate to the left of the capacitor has charge "Qo". The switch is closed the load and current vary sinusoidally with time. Represent graphically the load "Qo" and the intensity of current "I" as a function of time "t", and explain why the current leads the load by a phase difference of 90°.
An inductive impedance made up of a resistor and an inductor has the characteristic that its currentadvances in phase to the voltage at the impedance A) lags in phase with the voltage across the impedance B) is in phase with the voltage across the impedance. C) None of the above
An inductive coil of resistance 15 ohms and inductance 0.2H is connected in parallel with a 100 micro farad capacitor to a variable frequency supply. Find the frequency at which the total current taken is in phase with the supply voltage. What is this value of this current if the voltage is 200v. Draw a phase diagram
The picture shows three LC circuits, two of them with capacitors of capacitance C and the three with coils of inductance L, the three circuits are coupled by means of two capacitors Cc capacitors.L inductance coils, the three circuits are coupled by means of two capacitors of capacitance Cc. The currentscirculating through each mesh are those indicated in the figure: I1, I2 and I3. Using Kirchhoff's law for voltagesand taking into account the definition of current I = -dQ/dt, find the system of coupled equations for the systemand then find the angular normal frequencies of the system.
A circuit is designed with an AC source of max voltage 12 and frequency 60 Hz. The circuit has a resistance of 1050 Ohms, an inductance of 0.06 Henrys, and a capacitance of 0.009 coulombs per volt. - omega for source in rad/s? - omegaR for circuit? -XL? -XC? -phi in radians? -Z? -imax?
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source.