3. In apower system, four generation units with second orderinput-output functions areoperating. When demand is 1000 MW,economic load dispatch obtained asP₁ = 230 MW, P₂= 250 MW, P₁= 320 MW, P₁₂ = 200 MWIf load halves (500 MW), resolving ELD give us:P₁ = 90 MWP₁ = 110 MW ₁ P₂ = 150 MW, P₂ = 150 MW,If at peak load, demand increased to 3000 MW, find theeconomic load dispatch (neglect the grid losses and generation limits).

Given data, when demand is 1000 MW, Load dispatch is, P1=230 MWP2=250 MWP3=320 MWP4=200 MW When…

3. In a power system, four generation units with second order input-output functions are operating. When demand is 1000 MW, economic load dispatch obtained as P₁ = 230 MW, P₂= 250 MW, P₂=320 MW, P₁₂ = 200 MW If load halves (500 MW), resolving ELD give us: P₁ = 110 MW ₁ P₂ = 150 MW, P₁₂ = 150 MW, If at peak load, demand increased to 3000 MW, find the economic load dispatch (neglect the grid losses and generation limits). P₁ = 90 MW

3. In a power system, four generation units with second order input-output functions are operating. When demand is 1000 MW, economic load dispatch obtained as P₁ = 230 MW, P₂= 250 MW, P₂=320 MW, P₁₂ = 200 MW If load halves (500 MW), resolving ELD give us: P₁ = 110 MW ₁ P₂ = 150 MW, P₁₂ = 150 MW, If at peak load, demand increased to 3000 MW, find the economic load dispatch (neglect the grid losses and generation limits). P₁ = 90 MW

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Vin V₁ leee liee V₂ R₂ ww Vout 1:5 Assume the transformer circuit above is ideal, and that R₁ = 1000, R₂ = 4000 and 11,rms = 50 A. Find the rms voltage, Vzrms, across the secondary coil of the transformer. V2.rms [V]:
The steady-state frequency change is a function of the generating unit's angular momentum and time constants of the governor and prime mover Select one: O True False
The subject EE463 Power Systems analysis Please show all steps , and in clear writing it is better in hand written form.
a question by considering the annual load time curve for an electric station as a straight line from 20mw to 3mw, and to cover these loads, then operate three generating units, the first and second, each with a capacity of 10mw, while the third has a capacity of 5mw, and illustrate the load time curve by drawing, then find: 1- the total capacity of the station 2- the maximum demand 3- capacitance coefficient 4- pregnancy coefficient 5 utilizatio
A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 200 MVA rating, R1 = 0.025 pu (on the 200 MVA base), initial output P1 = 150 MW. G2: 300 MVA rating, R2 = 0.01 pu (on the 300 MVA base), initial output P2 = 200 MW. G3: 400 MVA rating, R3 = 0.02 pu (on the 400 MVA base), initial output P3 = 300 MW. The frequency of the system is 60 Hz. Assuming D = 0.75 pu on a common base of 1000 MVA, what is the new generation output for G1 for a load increase of 150 MW? Select one: O a. None of these O b. 252.12 MW O c. 155.45 MW O d. 170.42 MW
For the circuit shown, what is the complex power, S, consumed by the 18 + j32 N load impedance? (Assume the voltage source is in RMS.) 30 j8 N a 18 2 = 25 20° V j32 0 b 39.84/29.4° VA O 33.61Z27.7° VA O 11.24Z60.6° VA O 17.02Z – 64.0° VÀ
Question 3 What is the value of real power supplied by the source in the figure? ww 30/0º V rms | C 40 3031.4 None of the answers 2007.8 5252.8
1- Your company is considering the installation of a 2 MW wind turbine with a rotor diameter of 80 m in a location with average wind v = 10 m/s. The turbine has a cut-in velocity of 5 m/s and a cut-out velocity of 25 m/s. The capacity factor is 0.45. The installed cost of the turbine is $3,500,000. Operating expenses are $225,000 per year. The system has a power coefficient (electric power generated divided by wind power) of 0.45. What price would you have to get for the electricity you produce to obtain a 10% return on the plant investment assuming a project lifetime of 20 years? Use the tables for the cumulative wind power distribution in the notes on wind probability to answer this question. Assume an air density of 1.225 kg/m3.
(4) show the figure (if needed), given, formula and substitution. thank you! promise i'll rate.
5. A generating station has a maximum demand of 20 MW, a load factor of 60%, a plant capacity factor of 48% and a plant use factor of 80% . Find 0the daily energy produced () ue reserve capacity of the plant
I need the answer as soon as possible
A high-voltage direct-current generating station delivers 5 MW of power at 178 kV to a city, as depicted in Figure below. The city is represented by resistance R₁ and each of the two wires of the transmission line between the generating station and the city is represented by resistance RTL. The distance between the two locations is 1752 km and the transmission lines are made of 7 cm diameter copper wire. Determine how much power is consumed by the transmission line. Please enter your answer 2 decimal places and in terms of Watt. (for copper-1.72 x 10-8) Vo Station RTL RTL ww RL (city)