3. Consider a drilling operation in which a 0.5-inch diameter hole is drilled in an aluminum plate that is1.2 inches thick. The drill is rotating at 400 RPM, and the feed is 0.012 in/rev. The specific energy of thismaterial is 0.3 hp-min/in³. Find the power required to complete this operation.

Given data:Hole diameter d=0.5inchesPlate thickness t=1.2inchesDrill speed (RPM) ω=400rpmFeed rate…

Answered: 3. Consider a drilling operation in…

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter20: Shop Math And Weld Cost

Section: Chapter Questions

Problem 10R: Using the Pythagorean theorem, find c if a=6 and b=8.

See similar textbooks

Similar questions

calculate the speed (rpm) with a 1 inch diameter of the steel shaft which must work so that it can go at 10 hp without going over the allowable stress of 6500 psi.
1. A 4-stroke, single-cylinder gasoline engine has 85-mm bore and 85-mm stroke. What is the piston displacement of the engine? If the engine has a 10-compression ratio, what is its clearance volume? What would be the total volume of the cylinder? 2. A four-stroke gasoline engine is running at a speed of 3,000 rpm. The piston diameter is 4 inches while the stroke is 4.5 inches. What is the speed of the piston? 3. A four-cylinder gas engine has 20-cm cylinder diameter and 40-cm stroke. The cylinders run at 150 rpm speed. The engine is a four-stroke cycle with 8 kg/cm² mean effective pressure. What is the area in cm2 and length of stroke of the engine piston in meter? Also, compute the power stroke per min per cylinder and the total power stroke of the 4 cylinders. Compute the indicated horsepower and the brake horsepower of the engine. And, what is the stroke-to-bore ratio of the engine? 4. Compute the specific fuel consumption of the 10 hp engine that drive a power tiller if it…
please solve the equations in steps ()i and ()ii
An saw blade starts from 9 rad/s and accelerates at 4 rad/s2 and covers 483 rad. Determine the time it takes.
can you please find solution for this question?
It is required to cut screw threads of 2 mm pitch on a lathe. The lead screw has a pitch of 6 mm. If the spindle speed is 60 rpm, then the speed of the lead screw will be
a circular copper rod is 20.02 mm in diamter and has to be insterted into a square hole that is 20.0 mm on each side . How much does the shaft need to be cooled to allow this operation ?
can you please find the solution question no:18
4. The drilling speed for cast iron is assumed to be 70 ft/min. Find the time required to drill two holes in each of 500 castings if each hole has a diameter of 3/4" and is 1" deep. Use .010" feed and allow 14 minute per hole for setup. Page #
solve fro d to f
21. What is the diameter of line shaft that transmit 180 kW at 25 rps?
Two shafts 12 feet between centers carry pulleys 4 feet and 3 feet in diameter respectively, connected by a crossed belt. It is desired to put the belt on as an open belt. How long a piece must be cut out of it? Please Show a clear and detailed solution (with illustration). Thank you!

SEE MORE QUESTIONS

Recommended textbooks for you

Welding: Principles and Applications (MindTap Cou…

Mechanical Engineering

ISBN:

9781305494695

Author:

Larry Jeffus

Publisher:

Cengage Learning