20 5 60 burned a) Find the average power in the 6Ost load, P 6) Find the avenage power provi ded by the supply, P c) if Pi+R, where in the circuit 1s the power lost? ded

Q: The power factor of the circuit shown in figure 1 is a. 0.8 lagging b. 0.75 lagging c. 0.4 lagging…

A:

Q: For the network of the figure below, Calculate the true power delivered to the reactance Xc. R 20 E…

A:

Q: 27 in crlinr cal rotor SYchronous Genrator (8) what is the relation Bet ween the Angle( in the Plot…

A: There are leading and lagging Power factor phasor diagrams given.

Q: Find the equivalent resistance seen by the generator 10v. 52 50 Ic 10V 302 42 122 Vo 59 72

A: given data:

Q: 53. Determine the voltage at point C shown below with respect to ground: A 100 2 120 V= 50 2 B ww

A: we need to find out voltage at point c with respect to ground.

Q: SINE(0 6Vp-p 1.5K) R₁ LL 2.5 mH 100 PL On the load, find the Power (P) in Watts (W) R A 180//180 Ω…

A: Given Data: A series RL circuit with, Peak-to-peak voltage Vpp=6 V Frequency f=1.5 kHz To Find:…

Q: Show that the average power absorbed by each resistor is P2Ω.=P4Ω.=7.20W.

A: In this question, we need to determine the average power absorbed by each resistance as shown the…

Q: An engineer wants to design a half-wave rectifier for some of his circuit application.…

A: Half wave rectifier with capacitor Capacitor charges and discharges once in one time period.…

Q: For the circuit shown in figure beside, find the total average power delivered to the circuit? * J5…

A:

Q: Altennators also Conelitim it . oPerated in write are pasalled sequired the ofexcitation ised in

A: Parallel Operation:   If a large number of tiny units are performed in parallel, we can switch off…

Q: Circuit Value Xc1 = 1/[2(f)(C₂)] Xc2=1/[2(f)(C₂)] IRI=VS! RI IR2-VS/R₂ Ici=Vs/Xci Ic2=Vs/Xcz IT…

A: The circuit diagram,

Q: 1 Ohm 2 Ohms 4 Ohms 4 Ohms ELECTONICS HU acov A07 H Ohms m

A:

Q: refer to the figure below VP . O Rp jXp Ip Rp = 10 ohms Xp = 3 ohms Rs = 5 ohms Xs = 2 ohms Rc jXm…

A: it is asked to find the value of Rc in terms of secondary winding

Q: For the circuit shown in figure beside, find the total average ?power delivered to the circuit J5 2…

A:

Q: I need help determining the apparent power in the circuit and the power factor of the circuit below…

A: Given circuit,

Q: A resistance 100 N and a capacitance 30 µF are connected in series across a 240 V, 50 Hz a.c.…

A: Capacitance- Capacitance does not depend upon Q and V but depends on the ratio of Q and V. The…

Q: • Find the current I, given 0.IF reee vle) = 10 Sin(5ot) sinlsot)

A: Given circuit:

Q: 5 mV + Vie + WW. 250vbe e + M U 8.

A:

Q: For the circuit of Figure, assume the source operates at a frequency of 100 rad/s. Calculate the…

A: In this questionWe need to determine the power in 100 ohm resistance.We are solving this problem…

Q: For figure (1)draw and calculate the voltages waveform across each half of secondary winding and…

A: The figure shows a full wave rectifier circuit using two diodes D1 and D2. The supply voltage is…

Q: One of the following is not a law for power factor calculation. O P/S O cose O Q/P O P/VI

A:

Q: Determine the power factor of the source. R = 6 Ohms

A: The given circuit diagram is shown below,Here, the value of R is 6 ohms.So,

Q: What is the value of the equivelent impedance? 250 j1SA w m 302 20 j102 51.09 +9.8j 0.46+0.21j…

A: Choose the correct option Find the equivalent impedance across the terminal as shwon in the figure.…

Q: In the shown figure the circulation of A= pa, is on 7. 2. 60° 30° 2. Windows bu

A: Circulation of vector A is the line integration of the A along path.  i.e. ∮ A.dl We will calculate…

Q: If the frequency were doubled, what would be the new impedance? R www R = 121 ohms XL = 41 ohms Xc =…

A: given here a circuit of RLC series circuit and asked to find the impedance of the circuit when…

Q: evalue of real

A:

Q: Wit öf the follOwing Vith a D.C. generator wnich of the TOllOwing ? efficiency is preferred None of…

A: Regulation is defined as the drop in voltage from no load to full load voltage. Voltage regulation…

Q: ブ32 j2 Q 10/30° V 4 2

A: To delivered maximum power to the load in the AC circuit, Thevenin impedance should be conjugate to…

Q: Solve for Vx and give the magnitude of Vx (in Volts). Let the source V = 88 20°V. j4 Q 1092 www…

A: here we have to find the magnitude value of Vx .

Q: What is the value of real power supplied by the source in the figure? ww 30/0° V ms 42 5252.8 None…

A: Given circuit,

Q: low voltage systems In the circuit in the figure, the effective value of the voltage source is V,…

A:

Q: on A Load absorbs 10 KVA at a leading power factor of 0.6 The complex power is: Select one: O a…

A: The is a problem of circuits.  Given:- Load power |SL|= 10 kVA  Power factor, cos(phi)= 0.6 leading…

Q: An impedance draws a current l=10sin(wt-30°) A from a voltage V=220sinwt V. What would be the…

A:

Q: Solve for I using Kirchhoff's Laws 82 20V 24V

A:

Q: Q4- Calculate the voltage between "a" and "b" using Thevenin's theorem. 562 jsa -102 HH -jsn 80/60°…

A:

Q: According to the figure below, it determines the power required by the current source.

A:

Q: What can we eliminate negative parts of an AC signal, with and without using offset

A: Eliminate the negative part of the ac signal without using offset voltage  Using a positive clamper…

Q: The neutral current in a balanced star connected system is equal to Three coils each having…

A: Solve as below

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is ?applied to the circuit…

A: For this problem first we need to find RMS value of voltage and then current.

Q: A circuit with a resistor and a capacitor in series takes 227.6 watts at a power factor of 0.513…

A: It is given that: P=227.6 Wcosϕ=0.513V=220Vf=50 Hz

Q: For the circuit shown, determine the current through the 2+j5 ohms impedance. 1 2л jsn mm 2 B Loa D…

A: Impedance -  Impedance  represented by the symbol Z  is a measure of the opposition to electrical…

Q: Calculate the power factor of the er source. What is the average power supplied by the 102 4020°…

A:

Q: A load is connected to a 210 V, 50 Hz supply. If it has resistance of 30 02 and a capacitor of 0.25…

A: Supply voltage V = 210 V.Frequency f = 50 Hz.Resistance Capacitance

Q: What is the impedance of the circuit shown in the figure

A:

Q: QUESTION 4 A 200mH inductor, a 820 ohm resistor, and a function generator are all connected in…

A:

Multistage Amplifier

The multistage amplifier is generally a voltage or power amplifier. The multistage amplifier has a number of single stage amplifier that are cascaded together. Since a single stage amplifier output is not useful, they are being replaced with multistage amplifiers or multistage transistor amplifiers. The multistage amplifier are used where the gain required is high or the input signal is very small such that only a single stage amplifier cannot amplify it.