2.5 mm A solid object is hung by using a thin cord from a floating timber as shown in the figure. The timber has a specific gravity of 0.5 with dimensions of 60 x 30 x 10 mm. The solid object has a volume of 6600 mm³. Determine the following: a. The tensile force in the cord b. The buoyant force acting on the solid object c. Mass of the solid object 10 mm M0, 15°C

2.5 mm A solid object is hung by using a thin cord from a floating timber as shown in the figure. The timber has a specific gravity of 0.5 with dimensions of 60 x 30 x 10 mm. The solid object has a volume of 6600 mm³. Determine the following: a. The tensile force in the cord b. The buoyant force acting on the solid object c. Mass of the solid object 10 mm M0, 15°C

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Part II 1. The blocks shown in Fig. P-522 are separated by a solid strut which is attached to the blocks with frictionless pins. If the coefficient of friction for all surfaces is 0.20, determine the value of horizontal force P to cause motion to impend to the right. Assume that the strut is a uniform rod weighing 300 Ib. 200 lb _MATHalino.com 30° 400 lb 45° Figure P-522
The acrylic plastic rod is 200 mm long and 15 mm in diameter. If an axial load of 400 N is applied to it, determine the change in its length and the change in its diameter. E = 3.20 GPa, v = 0.4. %3D 400 N 400 N 200 mm
Please write the solution on paper.
Consider the timber beam shown below. The beam is made out of southern yellow pine, with an allowable bending stress of ?all= 2700 psi. The modulus of elasticity is E = 2,400 ksi. The maximum allowable deflection in the beam is 0.25 inches. A 1.5 kip/ft 6 ft 4 in. h B (a) What are the boundary conditions for this beam? (b) Determine the equation for the moment diagram using statics. (c) Determine the depth of the beam necessary to meet the allowable bending stress requirement.
A Homogeneous 2700 Kg Bar AB Is Supported At Either End By A Cable As Shown In The Figure. Determine The Stress In The Bronze Cable If The Cross Sectional Area Of The Bronze And Steel Cables Are 55 Mm 2 And 35 Mm 2, Respectively. Bronze L = 4 M Steel L = 3 M A 10 M B 240 MPa 126 MPa 135 MPa 150MPa
A steel tube is 5 millimeters thick and has an outside diameter of 60 millimeters. It is being used as a compression member. If the axial normal stress in the member is only limited to 200 megapascals, determine the maximum load P in kN that the member can support. Note: Draw the Free Body Diagram, include the units/dimensions, use the proper formula and round-off all the answers and the final answers to 3 decimal places.
As shown in the figure, a rigid beam with negligible mass is pinned at one end and supported by two rods. The beam was initially horizontal before the load was applied. Find the vertical movement of P if P=120kN.