2. The sequence reactances of a three phase alternator are X1 = x2 = 0.15 and Xo = 0.05 pu, based on the machine rating of 30MVA and 13.2 kV. The alternator is connected to a transmission line having X1 = X2 = 0.1 pu and Xo = 0.4 pu. A line to line fault occurs on the line at the receiving end. Draw the sequence networks for the faulted system and calculate the fault current.

2. The sequence reactances of a three phase alternator are X1 = x2 = 0.15 and Xo = 0.05 pu, based on the machine rating of 30MVA and 13.2 kV. The alternator is connected to a transmission line having X1 = X2 = 0.1 pu and Xo = 0.4 pu. A line to line fault occurs on the line at the receiving end. Draw the sequence networks for the faulted system and calculate the fault current.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Figure shows a generator connected to a metropolitan system (infinite bus) through highvoltage lines. The numbers on the figure indicate the reactances in p.u. Breakers adjacent to afault on both sides are arranged to clear simultaneously. Determine the critical clearing anglefor the generator for a 3-phase fault at the point P when the generator is delivering 1.0 p.u.power. Assume that the voltage behind transient reactance is 1.2 p.u. for the generator andthat the voltage at the infinite bus is 1.0 p.u.
powe system Q8
A star connected neutral grounded 3-phase synchronous generator consists of 0.1 p.u of sub transient reactance ,0.3 p.u of transient reactance and 0.5 p.u of leakage reactance.The zero sequence reactance of the synchronous reactance is None of the above 0.5 p.u 0.7 p.u 0.6 p.u
2.5.3 A three phase power system has two generator connected in parallel to a transformer and subsequently to a 230 kV transmission line. The ratings for the components are given as below: Generator 1:10 MVA, reactance of 12%. Generator 2: 5 MVA, reactance of 8%. Transformer: 15 MVA, reactance of 6% Transmission line: impedance of 4+j60 2, for which the reactances in percentage are based on the ratings of the respective components. Obtain the reactance and impedance values of the components in the system in percentage, based on 15 MVA and rated voltage of the components.
A 4-bus three-phase power system consists of the following equipment: • Generator 1 connected to bus 1 with a rated power of 20MVA, rated voltage of 20 kV, and a series reactance of 0.4 p.u. • Generator 2 connected to bus 5, with a rated power of 12MVA, rated voltage of 10 kV, and a series reactance of 0.3 p.u. Transformer 1 connected between buses 1 and 2, is wye-wye connected with a rated power of 20 MVA, rated voltages 20/100 kV, and a series reactance of 0.1 p.u. • Transformer 2 connected between buses 4 and 5, is wye-wye connected with a rated power of 12 MVA, rated voltages 12/110 kV, and a series reactance of 0.15 p.u. • Transmission Line 2-3 connects buses 2 and 3 and had a series impedance of 50 + j75 ohms. • Transmission Line 3-4 connects buses 3 and 4 and had a series impedance of 40 + j80 ohms. • Load A connected to bus 3 and abosorbes20 MW and 10 MVAR. The voltage at bus 3 is 105 kV. 1) Draw the one-line diagram for the system. 2) Draw the per-unit, per phase…
Q3/ For the system shown in figure. The generator is supplying 1.0 pu MW power under prefault condition. When three-phase fault occur at point F. What should the value of fault reactance must be to make the critical clearing angle equal to 58.9. Sc j0.1 j0.1 10.21 BE j0.38 38 j0.21 IEgl-12 pu 10.19 F 10.19 IVI-1.00 pu j0.1 j0.1 Q4/ Figure below shows the one-line diagram
(b) A 30000 kVA, 13.8 kV generator with X = 18% is connected to a bus which supplies two identical motors as shown in the Figure 2. The subtransient reactance X of each motor is 25% on a base of 6000 kVA, 7 kV. The bus voltage at the motors is 7 kV when a three phase fault occurs at the point P. For the fault specified, determine (a) the subtransient current in the fault (b) the subtransient current in breaker A and (c) the symmetrical short circuit interrupting current in the fault and in breaker A. юю DO A P 0-0 Gen. Figure 2 Motors
A 15 MVA, 6.6 kV, wye connected generator has X 1 = X 2 = 20%and X 0 = 10%. The neutral of the generator is groundedthrough a reactor of 5% reactance based on the generatorrating. A double line-to-ground fault occurs at terminals band c. What is the current in the ground?
EXPLAIN THE THREE-PHASE GENERATED EMF PRODUCED BY SYNCHRONOUSALTERNATOR.
10. A three-phase transformer consists of a bank of single-phase transformers connected to form a Dd0 connection. A fault on one of the transformers causes it to be removed from the circuit, and the remaining two transformers are connected in an open-delta (V-V) connection. Show that the capacity of the open-delta connected transformers is 58% of the delta-connected transformers.
Question 7 . .Full explain this question and text typing work only We should answer our question within 2 hours takes more time then we will reduce Rating Dont ignore this line ....