64. A 50 Hz, 11 kV, 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase and is connected to a bus-bar through a circuit breaker. The distributed capacitance upto circuit breaker between phase and neutral is 0.01 µF. The peak re- striking voltage across the contacts of the breaker is

64. A 50 Hz, 11 kV, 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase and is connected to a bus-bar through a circuit breaker. The distributed capacitance upto circuit breaker between phase and neutral is 0.01 µF. The peak re- striking voltage across the contacts of the breaker is

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 1600KVA, 6.7 kV, 3 phase wye-connected alternator has an effective resistance of 0.50 ohm per phase and a synchronous reactance of 8 ohms per phase. What is the percentage rise in voltage when full rated output at 0.80 lagging power factor at rated voltage is suddenly switched off?
A series resistance – capacitance (R – C) circuit is connected to 230 – volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the following: 1.) Power factor angle 2.) Circuit impedance 3.) Ohmic value of the resistor
common types of electrical failures of an AC induction motor
Draw the schematic arrangement of diesel power plant
Eo(LL) (V) a) 3000 b) 2500 2000 1500 1000 500 0 No-load excitation curve @3600rpm 0 1 2 3 4 5 6 DC Excitation current (A) 7 The figure above shows the no-load excitation (LL) curve of a 3-ph, 2-pole, 60 Hz, 1000 kVA, 2.3 kV synchronous alternator at rated speed. The alternator has negligible resistance and Synchronous Reactance Xs = 1.2 n/phase. If the alternator is synchronized to the Power Grid at 2.3 kV (Line to Line), calculate the following: 8 9 10 The value of excitation current required for full load current at 0.7 pf lagging (over-excited). |EO(LL)I IF The alternator current and reactive power when it is delivering 80% rated power (0.8 MW) and its DC excitation current is 4 A. IL Q3ph
If a 3-phase short circuit occurs at the terminals of an alternator, the current in the armature circuit increases suddenly to a large value. Select one: True False
A 6 pole, delta connected three-phase alternator having 144 slots is wound using double layer lap coils having 7 turns per coil. The coil has 16 / 24 pitch. The flux per pole is 7380000 maxuells. If the alternator is driven at a speed of 700 rpm, determine the total line-to-line generated voltage.
Two 60MVA, alternators operate in parallel. The setting of the governor are such that the rise in speed from full load to no load is 2% in one machine and 3% in the other, the characteristics being straight lines in both cases. If each machine is fully loaded when the total load is 120MW, what will be the load on the first machine (with 2% speed regulation) when the total load is reduced to 80MW?
dentify the conditions to be satisfy for the synchroscope method of synchronizing an alternator. (i) The terminal voltage must be equal to the bus bar voltage. (ii) The frequency of the generated voltage must be equal to the frequency of bus bar voltage. (iii) The phase angle between the generated voltage and the voltage in the grid will be zero. Option 1: (i) & (ii) Option 2: Only (i) Option 3: Only (ii) Option 4: (i),(ii) & (iii)
1. Impedance is the total opposition to an AC circuit caused by electric penalty tions, the tra capa multiple pacitive systema 62 Fundamentals of AC Electricity Questions for This C a. 1. Draw a diagram of an AC sine wave and identify its peak voltage and peak-to-peak voltage levels. b. 2. Explain the term frequency as it refers to AC electricity. c. 3. Discuss the difference between a load center and a fused disconnect. 2. WE wa 4. Explain how you would test for voltage in a fusible dis- connect on the line-side and load-side terminals. vi ci 5. Trace the path of a generated AC voltage from the generat- ing station where it is produced to the point where you would connect it to a machine in a factory. Be sure to iden- tify all the important parts of the system between the gen- eration station and the disconnect on the machine. a. be 3. True or False inductive reactance, capacitive reactance, and resistan 2. The units of impedance are
A 1200 kVA, 6600 volt, 3-phase, Y-connected alternator has an effective resistance of 0.40 ohm and a reactance of 6 ohms per phase. It delivers full load current of 0.80 lagging power factor at rated voltage. What will be the terminal voltage for the same excitation and load current if the power factor is 0.80 leading? a. 4,560 V b. 9,878 V c. 7,898 V d. 4,250 V
The reactance of the synchronous generator after sometime of the fault cleared is ............