(b) Differentiate between single phase and three phase alternating current (A.C) supply for the following aspects with adequate comparisons and sketches:  (i) Generation of single phase and three phase e.m.f.s  (ii) Sine waveforms (iii) Advantages or disadvantages of both phases

Q: Exercise 2: Resistances connected in Series-Parallel across a Sinusoidal AC Supply Calculate the…

A: In the circuit, pure Resistances connected in Series-Parallel across a Sinusoidal AC Supply We are…

Q: The temperature of a noninductive heater unit is controlled by a reactor. The heater unit and the…

A: NOTE_“Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: Q1: What does happen if we change two currents? Q2: What does happen if we have a three-phase four…

A: to find the answers in the below steps

Q: Discuss Fully the various methods available for transforming 3-phase voltages to higher or lower…

A: Different methods available for transforming 3-phase voltages to higher or lower 3-phase voltages at…

Q: Upload answer sheets Find the following parameters of an ac voltage given by the equation…

A: Form Factor: It is the ratio of the RMS value to the average value. It is also known as root mean…

Q: Voltage

A:

Q: times

A: effective voltage =peak voltage/(√2) So by simplifying we get  Effective voltage equals to 0.707…

Q: Derive the formula and relation for voltage and current in a pure resistive- AC circuit and prove…

A:

Q: Q1// What is the purpose of conducting experiments (o.c) and (s.c) on asingl- nhase transformer?

A: TRANSFORMER: The transformer transfers power from one circuit to another circuit without a change…

Q: The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2…

A:

Q: A single phase 120V AC sourc controls power to a resistve load 202 using integral cycle control. a)…

A: Note: As per our policy, I have attempted the first three subquestions. Given data: The source…

Q: Question Network Theory Network Synthesis> RLC Network A 150 kW balanced 3-phase star-connected load…

A: Given- 150 kW balanced 3-phase star-connected load, Leading current IL=100 A, Line voltage VL=1100…

Q: The voltage regulation of an alternator having 0.75 leading p.f. load, no-load induced e.m.f. of…

A: Voltage regulation = no load voltage-rated voltagerated voltage x 100

Q: a buck converter, what are the benefits and disadvantages if the changes of duty cycle is drastic…

A: Duty cycle : Duty cycle in the power system is defined as the ratio of the time during which a load…

Q: The section bus-bars A and B are linked by a bus-bar reactor rated at 6000 kVA with 12% reactance.…

A:

Q: An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following…

A: In this question,  A RLC circuit connect with 110V , 50Hz battery.  Find the all data as per given…

Q: A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in…

A: A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in…

Q: 6. A series circuit connected across a 100-Vac source consists of a 10-Q resistor, a 5-N capacitor,…

A:

Q: ١-The PMSM used in the industry due to: a- Their low noise. b- Their easy control arrangement. c-…

A: 1) The permanent magnet synchronous motor(PMSM) is used in industry due to their low power…

Q: Explain the basic concepts of direct current and alternating current. Give an example with formulas…

A: Alternating Current: Whenever electric flow, AC is capable of changing direction. Different…

Q: (b) A symmetrical three-wire three-phase supply as shown in Figure Q2(b) is connected to a balanced…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: What is the relationship between primary induced emf( E1) and applied voltage (V1) of a Transformer?…

A: The relationship between primary induced emf( E1) and applied voltage (V1)

Q: A series resistance – capacitance (R – C) circuit is connected to 230 – volt, 50 cycle AC source.…

A:

Q: 1. Find the required single-phase excitation voltage at rated voltage and frequency, in Volts 2.…

A: The given information about the nameplate ratings of a synchronous motor are written below.…

Q: here era two type of currents, a. direct current and b. alternating current. For each of these type,…

A: (a) Consider the case of the ac current. The ac consider is one that changes its direction after a…

Q: The step down DC chopper uses DC source voltage V(dc) = 200 V and resistive load impedance of 10…

A: We have an step down DC chopper with, DC source voltage (Vdc) = 200 V Resistive Load Impedance (R) =…

Q: Q2/3-phase.E.W.C. R using center tap transformer supplies highly inductive load, find: 1. The…

A:

Q: QUESTION 2 The peak-to-peak voltage is 40V, its rms voltage is 14.1 V 11.4V 13.3V 12.3 V

A: Peak to peak voltage Vp-p=40 V.

Q: Q5. Answer the following: (i) (iii) Explain the power factor using a voltage and current waveform.…

A: What are Power Factor, Harmonics, and Voltage Disturbance? Power factor is the ratio of working…

Q: Generate a conclusion on this following statements:  Determine and analyze the voltage regulation…

A: GIVEN:  resistive load               inductive load               capacitive load DETERMINE: the…

Q: Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor m Non- linear, Load…

A: The given circuit is shown below.

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.