Solve part 2. using branch current method 1.Use nodal analysis to solve for Vx.un55IA+ 1Vx $424V (+2. Repeat #Im22211Current method.(3.a)Ix½/22using the branch

In this question, we need to determine the voltage Vx as shown the circuit using the mesh analysis.

Answered: 2. Repeat #1 Current using the branch…

Engineering

Electrical Engineering

2. Repeat #1 Current using the branch method.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 4PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Related questions

Q: Get the value and show the direction of the current using conventional flow

A: Given an electrical circuit. To get the value and show the direction of the current using…

Q: one turn of a copper bar is produced by cutting copper washer along a radius and spreading the ends.…

A: The cross section area of washer is circular. A =πr2 =π9 inch2 =π×(22.86cm)2 =1641.73A…

Q: An energy meter connected to an immersion heater (resistive) operating on an AC 230 V, 50 Hz , AC…

A: Given- AC 230 V, 50 Hz, 2.3 units kWh single phase source, Time t=1 hour, Peak square wave source…

Q: DA at 0.9 p. f lagging. Calculate the in each phase. If the coils are delta

A: A system is said to be balanced if the all three-phase carry the same load current and carry the…

Q: Find the TEC and NEC for the circuit and the current and voltage running accross the 100 ohm…

A: In the given questions we need to calculate the TEC and NEC .

Q: please detailed equation soultion , and why V*R instead V/R in nodal equation?

Q: A conductor having a resistance of 50 ohms has temperature coefficient of resistivity of 4.143x10^-3…

A: We need to find resistance at given temperature

Q: a) A 345 kV, three phase transmission line is 100 km long. The resistance per phase is 0.033 2/km…

Q: Problem 1: For a second order system with no zeros, the table shows some values of Percent Overshoot…

A: b) Given data Hyr=Ks2+10s+25+K Maximum overshoot range %Mp≤16.3% To Find out We have to determine…

Q: use both IEC and NEMA symbols. - Conductors crossing but not connected - Conductors crossing and…

Q: 1/ Suppose that there are two types of H.V.T.Ls operating at the same voltage and carrying the same…

A: In this question we need to choose a correct option.

Q: Draw AC and DC equivalent circuit for the circuit given in Figure 4. (1 33KO Rs 2.2KN C. 10uf I, G…

A: For drawing dc equivalent circuit capacitor will be open circuited as capacitive reactance will be…

Q: Obtain the per-unit equivalent circuit for the following one-line diagram in Figure 1. Xine = 100 Q…

Q: Question Network Theory Network Synthesis> RLC Network A 150 kW balanced 3-phase star-connected load…

A: Given- 150 kW balanced 3-phase star-connected load, Leading current IL=100 A, Line voltage VL=1100…

Q: Two ideal CTs with turns ratios of 300 : 5 and 600 : 5 are connected as shown in Figure 3.6a and b.…

A: The above question is based on CT connections.Given: Primary current = 3000 ABurden = 1 ohmCT turn…

Q: • Draw the single line diagram of a substation having the following equipments: i) Incoming lines:…

Q: 2.35 Calculate Vo and I in the circuit of Fig. 2.99. 200 V + Α 70 Ω 20 Ω Μ Το tsol L 30 Ω 5Ω

Q: 11- The main three common types of photovoltaic cells are a.

A: Since you posted the multiple questions, therefore we will solve questions 11 for you.

Q: Problem E Determine whether the BJT circuit can function as a closed beta Rc switch if Rc is equal…

Q: A capacitor is made with a polymeric dielectric having an e, of 2.26 and a dielectric breakdown…

A: Given- A capacitor is made with a polymeric dielectric having, Dielectric constant, εr=2.26.…

Q: Using the I – V curves how are ohmic materials different from non-ohmic materials

A: Ohm's Law: Most substances' current flow is exactly proportional to the voltage V applied to them.…

Q: inm do A ☺ 52

A: From the mesh Analysis

Q: Discuss the operating principle of the hydroelectric power plant

A: Hydroelectric power plant is an electricity generating power plant which uses potential energy of…

Q: please have step by step solution and explain

A: please give helpful rating and thank you so much....

Q: 4. For the signals provided below a. Which are periodic? Give their periods. b. Which are power…

A: The expression of signals is, a). (i). Considering the first signal, Determining the composite…

Q: If the power source in the circuit below is 60 V, what is the total current in the circuit?…

A: In this question we need to find the total current of the given circuit

Q: an LTI system with impulse response

Q: B. Define ( resistance, reactance, impedance.

A: Resistance- It is the process by which flow of current is being opposed by an electric circuit. It…

Q: Uim care si): the Vim - QV Then diock D₁ equivalent avranit 20 Vin BI VB=2V R₁ -Umm + 2 + Nout Vout…

A: Consider the below ideal diode; When VAK>0 Then the diode will be in forward bias (conducting)…

Q: The principle operation of LVDT is based on the variation of Select one a. Self inductance b.…

A: Right Answer option C.Mutual Inductance

Q: How do I solve this using Kirchoff's Voltage Law?

A: As per Kirchoff's Voltage Law (KVL ), the algebric sum of all the voltages in a closed loop is equal…

Q: In the following circuit, if L = 8mH , LEo between terminals a and b is L1 8 mH a o 5 mH mm 12 mH 8…

A: To find the equivalent inductance between terminals a-b The equivalent of inductance is…

Q: Describe series and parallel circuits. Which is used in building electrical systems?

A: The explanation is as follows.

Q: A sphere of radius r floats in water. The volume of a spherical segment is (3 rh² – h° ). Find the…

A: The given data's are, A sphere of density is 800 kg/m2, The volume of spherical segment is, π33…

Q: Determine the Branch Currents using Mesh Currents: a.) Branch ab b.) Branch ac c.) Branch bc…

A: Appling KVL in loop1,…

Q: Example 7.2 In the following single phase distribution feeder, the nominal voltage is 600 V. If the…

A: Length L=500mTo determine:

Q: What is resistance? What is a node? What is a closed loop?

Q: what is ripple ? how to minimize the rippl , draw the circuit and show ??

A: It is one of the important parameter which is taken into consideration while designing any power…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

Solve part 2. using branch current method

1.
Use nodal analysis to solve for Vx.
un
55
IA
+ 1
Vx $42
4V (+
2. Repeat #I
m
222
11
Current method.
(3.a)Ix
½/22
using the branch

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction about the given question

VIEW

Step 2: Calculation for the voltage Vx

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Reconsider Problem 3.29. If Va,VbandVc are a negative-sequence set, how would the voltage and current relationships change? (a) If C1 is the complex positive-sequence voltage gain in Problem 3.29 and (b) if C2 is the negative sequence complex voltage gain, express the relationship between C1andC2
What are interpoles, and what is their purpose?
An ac resistance is higher than a dc resistance. True False
The principle operation of LVDT is based on the variation of Select one a. Self inductance b. Reluctance c. Mutual inductance d. Permanence
i need the answer quickly
The electrical equivalent of mechanical load in induction machine is? a. r2/s b. r2*(1-s)/s c. r2/(1-s) d. r2
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
Subject name: Electrical Power Distribution.
Q-3 A Cockcroft-Walton type voltage multiplier has ten stages with capacitances, all equal to 0.1 µF. The supply transformer secondary voltage is 100 kV at a frequency of 60 Hz. If the load current to be supplied is 5 mA, find (a) the percentage ripple, (b) the regulation, and (c) the optimum number of stages for minimum regulation or voltage drop.
Since R1=18.10Kohm, R2=67.58Kohm, RC= 1.08Kohm, RE= 3.23Kohm, VCC=14.00V, Beta=241.00 in the circuit given in the figure, calculate the IC current by doing a complete analysis. When performing your operations, 2 steps will be taken after the point. choose the closest one from the stylish ones according to the +/-10% margin of error. There is only 1 correct answer to the question.
What is load curve
by High Voltage