2. A spring is hung vertically and an object of mass m attached to the lower end is then slowly lowered a distance d to the equilibrium point a. find the value of the spring constant if the magnitude of the displacement d is 2.0 cm and the mass is .55 kg b. if a second identical spring is attached to the object in parallel with the first spring, where is the new equilibrium point of the system? c. What is the effective spring constant of the two springs acting as one?

2. A spring is hung vertically and an object of mass m attached to the lower end is then slowly lowered a distance d to the equilibrium point a. find the value of the spring constant if the magnitude of the displacement d is 2.0 cm and the mass is .55 kg b. if a second identical spring is attached to the object in parallel with the first spring, where is the new equilibrium point of the system? c. What is the effective spring constant of the two springs acting as one?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A board sits in equilibrium. On the left end, there is a wire that supports the board from the ceiling, and to the right, there is a sawhorse that supports the board from the ground. The sawhorse is a distance d= 1/5l from the right edge of the board. There is a block with mass ms= 4.5kg that is a distance 3/4l from the right edge of the board. Finally the board has a mass mb= 11kg. c) Write down Newton's 2nd law. Put the equation in terms of mb, ms, g, T, and Fn. Where T is the tension in the wire, and Fn is the normal force of the sawhorse on the board. d) Write down Newton's 2nd Law for rotations. Put the equation in terms of l, mb, ms, g, T, and Fn.
A sliding block weighing 50 lb can slide freely within the frictionless slot shown. The spring is undeformed (i.e., not stretched) when it is in a horizontal position. What is the spring constant k if the slider is in equilibrium in the position shown? Show your calculations and result.
Learning Goal: To analyze a rod assembly in three-dimensional space and determine the support reactions by using the equations of equilibrium for a rigid body. The rod assembly shown has smooth joumal bearings at A, B, and C. The forces F 600 N. F-480 N. F 460 N, and F-900 N are applied as shown in the figure. The geometry of the rod assembly is given as a 0.900 m, &0.650 m, and c 0.800 m Neglect the weight of the rod Determine the magnitude of the 2 component of the reaction on the rod at A Express your answer to three significant figures and include the appropriate units. View Available Hint(s) Submit PA A₁ = Value Submit Part F- Finding the x component of the reaction at A Determine the magnitude of the x component of the reaction on the rod at A Express your answer to three significant figures and include the appropriate units. View Available Hint(s) Units μÁ Value ? Units ?
The linkage shown is used in a vehicle suspension system. Find the forces indicated below when a static force of F = 1000 lb is applied to the tire at point C at an angle of 0 = 17° as shown. Assume the connection of the wheel to member AB is rigid. 1 h₁ K: LOFF 0 W₁ h₂ h3 h4 h5 B W₁₂ AXHIMAL W4 hs: h₂ cc i❀O BY NC SA 2013 Michael Swanbom W3 - W₁ Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value Variable Value h₁ 6.6 in W1 7.5 in 16.6 in W2 4.6 in 14.6 in W3 8.3 in 10.2 in W4 6.2 in 5.2 in W5 9.7 in
Given: Member OC rotates about the pin at point O when the force T' is applied. Spring AB is unstretched when OC is vertical. The spring constant for spring AB is k = 80 lb/in. Find: the magnitude of force T that is required to hold the position shown. 10 in 45° 5 in B k = 80 lb/in 5 in 30⁰
or 5, 2. You have a massless spring of force constant 64 N/m, but it is wound tightly enough that you must apply 16 N of force to it before it begins to stretch. You attach a 12 kg mass to one end of the spring. The other end is fixed in place above the mass (e.g. it is clamped to the room's ceiling). A second mass of 1.0 kg is connected to the bottom of this first mass via a thin string of negligible mass. The system is initially in equilibrium, but then the string connecting the smaller mass suddenly snaps. 2.1 What is the initial acceleration of the spring-mass system? 2.2. What is the amplitude of oscillation for this system? 2.3 What would be the period of oscillation for this system? 2.4 Determine the maximum value of the kinetic energy of the mass still connected to the spring. Assume negligible damping.
5. Car doors are easy to slam shut but difficult to press shut by hand force. The door lock as two latches, the first easily engaged, and the second requiring the rubber seal around the door to be quite compressed before it can engage. The rubber seal gives a spring constant of 50,000N/m at the lock position for the door, and the mass moment of inertia for the door around its hinges is 2.5kg- m². The distance between the lock and the hinges is Im. Calculate what force is needed to press the car door shut at the lock if a speed of 0.8m/s at the lock slams it shut.
Resources Hint An ideal spring hangs from the ceiling. A 1.95 kg mass is hùng from the spring, stretching the spring a distance d = 0.0845 m from its original length when it reaches equilibrium. The mass is then lifted up a distance L = 0.0265 m from the equilibrium position and released. What is the kinetic energy of the mass at the instant it passes back through the equilibrium position? kinetic energy J Equilibrium position about us privacy policy careers terms of use contact us help WWWW. www
Two blocks of mass m = 2.00 kg are connected by a vertical string of negligible mass and unknown tension Tm are hanging vertically. The higher one of these two masses is directly attached to another string of negligible mass and unknown tension T that goes over a frictionless pulley of negligible mass and is connected to a third block of mass M = 6.00 kg. The heavier block is free to slide on an incline (of angle 0 = 30.0° w.r.t. the horizontal) with coefficients of kinetic friction of µA = 0.120 and static friction µ,=0.150 between the block and the incline. The system is released from rest. !! M a) Please perform a test to determine which way the system would like to move in the absence of any friction. b) Please perform a test to determine whether the system will be able to overcome the maximum of static friction and be able to move, or remain at rest instead. c) Determine the magnitude of the normal force N exerted on the third block by the incline. d) Determine BOTH the magnitude…
THANK YOU
Under some circumstances when two parallel springs, with constants k₁ and k2, support a single mass, the effective spring constant of the system is given by k = 4k1k₂/(k₁ + k₂). A mass weighing 20 pounds stretches one spring 4 inches and another spring 2 inches. The springs are attached to a common rigid support and then to a metal plate. As shown in the figure, the mass is attached to the center of the plate in the double-spring arrangement. k₂ II k = 20 lb Determine the effective spring constant of this system. lb/ft Find the equation of motion x(t) if the mass is initially released from the equilibrium position with a downward velocity of 6 ft/s. (Use g for the acceleration due to gravity.) 32 ft/s² x(t) = ft