2. A 17KVA, 340V/680V transformer has been tested to determine its equivalent circuit. The open circuit test data when high voltage side is open: Voc=340, lo=5A, Pac=250W. The short circuit test data when low voltage side is short circuited: V=50V, Ik=25A, Pa=275W. Use approximate equivalent circuit. Find the equivalent circuit parameters of this transformer referred to the low voltage side.

2. A 17KVA, 340V/680V transformer has been tested to determine its equivalent circuit. The open circuit test data when high voltage side is open: Voc=340, lo=5A, Pac=250W. The short circuit test data when low voltage side is short circuited: V=50V, Ik=25A, Pa=275W. Use approximate equivalent circuit. Find the equivalent circuit parameters of this transformer referred to the low voltage side.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

- A Transformer has primary windings as Np = 750 and secondary windings as Ns = 125. Its secondary voltage is Vs = 36V and output power of the transformer is PN= 3200W. The value of loses powers are Pcu = 43W and Pfe = 29 W. The resistance of loads are RLI = 1,250 and R12 = 0,88Q. (Pcu and PFE will be considered to be approximately the same in different load values.) Determine the following values in the circuit: Primary winding N, turns Secondary winding Ng turns Primary current Magnetic Flux, Secondary IsL s current ISL1 'Isl2 Primary voltage Secondary voltage RL1 R12 Transformer Core (a) the primary voltage Vr, (b) the secondary load currents ISLı and Isl2 if the transformer is rated at RLI and R12, (c) the resulting secondary power PSL, (d) the resulting primary power PPl, (e) the primary load current IPL, (f) efficiency nL
A short circuit test performed on a 25 KVA 2300/230 V transformer gives the measured value of the resistance as 0.8 Q and 0.009 Q on the two sides of the transformer. The total equivalent resistance in Q referred to LV side will be
b) A lkQ resistance is connected across the secondary winding of a 200V/400V transformer with the following equivalent circuit parameters, Kleq=502, Rc = 10k2, XM =1 k2 , ^leq = 100 2. Determine the following: R i. The Open Circuit Output Voltage (Vsoc) ii. The Output Voltage under load (Vs) i1i. The Output Current (Is) iv. The Transformer Efficiency (%)
13)This MCQ QUESTION FROM BASIC POWER ELECTRICAL ENGINEERING course.
Why we used isolation transformer
A Buck converter has an output power of 1950 Watts, and a source voltage of 1000V (the constant DC voltage). Using the information provided and the "“transformer-like" relationships derived in class, estimate the corresponding load currents for the following duty ratios: a) D=0.35 b) D=0.9 c) D=0.5
30-kVA, 2200/220-V, 50-Hz distribution transformer is tested for efficiencyand regulation as follows :O.C. test( Low voltage side ) : 220 V 4.2 A, 148 W S.C. test ( Low voltage side ) : 86 V 10.5 A, 360 W 1-The working current and resistance component of no-load are.........amper , .........ohm * 2-Efficiency at full-load and half the full-load at 0.8 p.f. lagging current. * 3-Equivalent resistance referred to primary & referred to secondary..........ohm , ..........ohm * 4-Regulation of transformer at 0.5 p.f. lagging current * 5-Equivalent reactance referred to primary & referred to secondary..........ohm , ..........ohm * 6-The magnetizing current and reactance component of no-load are.........amper , .........ohm *
please solve the question lmlmlmlm
1. A 1000-VA 350/140-V transformer has been tested to determine its equivalent circuit. The results of the tests are shown below. Open-circuit test Short-circuit test Voc = 235 V Vsc = 20.1 V loc = 0.57 A Isc = 9.6 A Poc = 34.3 w Psc = 42.7 W All data given were taken from the primary side of the transformer. Evaluate the equivalent circuit of this transformer referred to the low-voltage side of the transformer.
The value of A =436, B=57, C =7
A 9KVA, 360V/180V transformer has been tested to determine its equivalent circuit. The open circuit test data when high voltage side is open: loc=1.8A, Poc=200W. The short circuit test data when low voltage side is short circuited: Vsc=40V, Psc-230W. Use approximate equivalent circuit. Calculate equivalent resistance primary value. 0.736 0.023 0.368 0.092 0.184
Which of the following statements is true about an ideal transformer? O It changes the magnitude of DC signals. O It converts DC signals into AC signals. O It converts AC signals into DC signals. O It changes the magnitude of AC signals. hp