1500 m 0.4 m/s 30 cm /30 cm B 2500 m

Q: In a circular pipe of diameter 1 ½ in. the flow is described by the equation u(r) = 1/2 (1 - r 2/R2…

A:

Q: Determine the loss of pressure in overcoming the friction in a coil through which water flows with a…

A:

Q: Water is pumped through a horizontal, smooth circular pipe at a bulk velocity of 0.4 m/s. The pipe…

A:

Q: Water at 30°C flows at 120 L/s inside a forged steel pipe shaped as an equilateral triangle of 50 cm…

A:

Q: A reservoir at 300 ft elevation has a 6-in.-diameter discharge pipe located 50 ft below the surface.…

A: Given: elevation of the reservoir→Z1=300 ft And elevation of the outgoing flow →Z2=150 ft Diameter…

Q: Water at 20 degree C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the…

A: Introduction In this issue, we apply the Bernoulli equation between the discharge level and the top…

Q: Water (viscosity of 0.001 kg/m.s and density of 1000 kg/m ) is to be pumped through 50 m of pipe…

A:

Q: Glycerin at 20 °C flows upward in a vertical 75-mm-diameter pipe with a centerline velocity of 2.0…

A:

Q: large buildings, hot water from the water tank is continously recurculated in a loop to avoid long…

A:

Q: ty of 3.5 m/s. Determine the pressure drop per 10 m of the pipe. What is minor loss in pipe flow?…

A: given:density ρ=1252kg/m3μ=0.27kg/m.sdiameter D=6cm

Q: Water at 15°C (p = 999.06kg/m², µ = 1.1373 x 10-³Pas) is flowing steadily in a 28-m-long and 6.7-cm-…

A: Find the head loss along the pipe section.

Q: Water at 20°C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A:

Q: Gasoline (p = 680 kg/m² and v = 4.29 × 10o-7 m²/s) is transported at a rate of 190 L/s for a…

A:

Q: Consider laminar flow through a very long straight section of a round pipe, with parabolic velocity…

A:

Q: air flows in a duct at the rate of 0.056 m3/s. Determine the pressure drop (kPa) between the 6 and 3…

A:

Q: A metal pipe (ID: 20 cm, friction factor: 0.012) is used to deliver cooling water (10°C) from Tank A…

A: Here we will use Bernoulli equation

Q: Oil ( μ = 0.478 Pa.s and ν = 5.3 *10-4 m2/s ) flows downward in a pipe which is ( 3 cm ) in diameter…

A:

Q: Determine the pressure drop per 100-m length of horizontal new 0.30-m-diameter cast iron water pipe…

A:

Q: oss in turbulent flow in a pipe (a) varies directly as velocity  (b) varies inversely as square of…

A:

Q: Water is conveyed from a constant head tank (head or operation is 4 m) through a 100 m long…

A: To Find: Loss coefficient for value i.e. K Given that, H=4 m, L=100 m, d=100 mm=0.1 m Q=12…

Q: Water is flowing in a conical tube. the inlet conditions are D=100mm, v=1m/s & density = 1000kg/m3.…

A:

Q: uryer eharges ameter, well-rounded vent with negligible loss is n en connected to a 15-ft-long,…

A: select point (1) toward be inside the drier and point (2) toward be the exit of the drier.consider…

Q: The flow through a circular pipe is laminar. Now, the fluid through the pipe is replaced with a more…

A: When fluid flows in a circular pipe at low velocity, then the intermingling of fluid particles was…

Q: water at 4-degree centigrade ( ρ=998 kg/m3 and μ=1.52 *10-3pa.s) is flowing steadily through a 3mm…

A: Given data:

Q: An orifice of 0.1-meter-diameter is installed in a pipe having a diameter equal to 0.3 meters as…

A: The given values are -  A0=π40.12=7.85×10-3 m2  A1=π4(0.3)2 = 0.071 m2 Cd=0.63 Pressure head (h) =…

Q: The horizontal pipe length is 180 m and the vertical pipe length is 24 m in the fire protection…

A: dear student please rate me postive :) Stay safe stay happy !   Data given -  L1 = 180 m  L2 = 24 m…

Q: Water flows at the rate of 0.80m3/s in a 900-m long pipe. The total head loss in the pipe is 4m.…

A: GIVEN DATA - Q=0.80 m3/s L=900m h=4m f=0.018 We have to find diameter of pipe using Darcy-Weisbach…

Q: here are two fully open gate valves (KV= 2 m) and three 90° elbows (K90°= 2.2 m) on the horizontal 4…

A:

Q: Water is pumped from the river through a 45-mm-diameter hose having a length of 2.5 m. The friction…

A:

Q: Water at 20°C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A:

Q: Water is flowing through the 40 mm pipe shown below at 250 L/min. The pressure at point 1 is 5322…

A: Given:d=40 mmQ=250L/min P1=5322 KPaP2=4358 KPaP1'=5081 KPaP2'=1222 KPa

Q: A metal pipe (ID: 20 cm, friction factor: 0.012) is used to deliver cooling water (10°C) from Tank A…

A: INTRODUCTION : We'll figure out how much energy it takes to lift water from one tank to another in…

Q: Water at 20°C is pumped through a smooth 12-cm-diameter pipe 10 kmlong, at a flow rate of 75 m3/h.…

A:

Q: inwhich ris the local radius, Ris the radius of the inner wall of the pipe and Vawg is the average…

A: For solution refer below images.   ∗From the given data   V=2.Vavg  1-r2R2    ∗Velocity profile:-…

Q: A horizontal pipe bend with a deflection angle of 120o has an entrance diameter of 300 mm and exit…

A:

Q: Water at 20°C is pumped through a smooth 12-cm-diameter pipe 10 kmlong, at a flow rate of 75 m3/h.…

A:

Q: Glycerin at 40°C is flowing through a 4-cm-diameter horizontal smooth pipe with a flow rate of 6…

A: Write the given data: T=40°Cd=4 cm=0.04 m100 cm1 mm.=6 kg/sL=10 mat 40°C:ρ=1252 kg/m3μ=0.27 kg/ms

Q: Task (2) The water needs of a small farm are to be met by pumping water from a well that can supply…

A:

Q: Straight 0.15 m diameter cast iron pipe with equivalent roughness E=0.22 mm is used for water…

A: The relative roughness of a pipe is its roughness divided by its internal diameter, or e/D, and this…

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.