15. Statements Which of these statements are correct? (Note: multiple answers possible) Water vaporizes at 100 [OC], it cannot evaporate into room air Water droplets can evaporate into air because of their low partial pressure Water droplets can evaporate into air because of their high partial pressure When spraying water droplets into air, the temperature of the air decreases The cooling effect of spraying droplets in very humid air (close to saturation) is much lov spraying droplets in dry air Pump energy for spraying water is high and evaporative cooling is therefore not efficient

15. Statements Which of these statements are correct? (Note: multiple answers possible) Water vaporizes at 100 [OC], it cannot evaporate into room air Water droplets can evaporate into air because of their low partial pressure Water droplets can evaporate into air because of their high partial pressure When spraying water droplets into air, the temperature of the air decreases The cooling effect of spraying droplets in very humid air (close to saturation) is much lov spraying droplets in dry air Pump energy for spraying water is high and evaporative cooling is therefore not efficient

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Task3
1.3 A mixture of two liquids of equal volume is made, the one has a relative density of 0,8 and the other a density of 980 kg/m³. What will the weight of 2 500 litres be? 1.4 1.5 1.6 15 1.7 [21830 N] A solid block of stone with a relative density 4 is broken down and crushed to an average size of 20 mm. If the stone originally had a volume of 50 m³, how many truck loads with a volume of 2 m³, will it take to transport the crushed stone if 25 of the crushed stone has a mass of 80 kg. Has the relative density changed? How much? Why? [32 truck loads] Use table 1.4.2 to determine the kinematic viscosity of crude oil with a density of 855 kg/ m³ at temperatures of 20°C and 100°C. [9,357 x 10-6 m²/s; 3,275 x 10-6 m²/s] Air is used in a sensitive gyroscope to keep the metal bearing surfaces apart. Will the friction losses in the bearing be higher, lower or the same if the temperature of the bearing increases? A widely used S.I. unit for kinematic viscosity is centi- stoke cSt. One stoke is…
12. Imagine a solar collector for hot tap water in a hot climate. De outdoor temperature is 22 degree Celsius. De tank of the solar collector is placed outside, and the cold water temperature to the collector is 20 degree Celsius. De water flow rate through the collector is 45 liter/hour. De collector is 2 [m2] and the average solar radiation in the time period considered is 1000 [W/m2]. What is the temperature of the hot water to the tank? The efficiency of the collector can be assumed to be 0.7 (we neglect the dependency to the water temperature) (multiple choice, one answer) 34 [OC] 47 [OC] 54 [OC] 67 [OC] 74 [OC]
solve the proble regarding otto cycle and fill the unknow
A power plant condenser diverts from the power plant water that condenses heat at a rate of 34 [MW] The cooling water enters the condenser at a temperature of 15c and leaves at a temperature 30C lower than the water's condensation temperature. The pressure of the water at the exit of the turbine is 9[kpa]The condenser is made of brass tubes with an inner diameter of 25mm and an outer diameter of 30mm and the number of tubes in the condenser is 1000 A. Calculate the cooling water flow.B. Calculate the area of the heat exchanger on the condensing side
Thermodynamics question. please help (2nd Attachment is the table question B is referring to)
Tma X Liquidus mg All Liquid A Liquid B+Liquid T TE A+B (all solid) Solidus A Figure 1 Study the following terms and phase diagram, fill in the blanks as indicated. Refer to the figure above. Melting point is a physical property of a pure organic solid and is defined as the temperature at which the vapor pressure of the solid and liquid are equal. A pure solid melt reproducibly over a narrow range of temperatures. Above is a two-component phase diagram for two hypothetical compounds A and B. а. indicates the melting point of pure solid A. b. _indicates the melting point of pure solid B. С. _indicates the melting point of a 80:20 mixture of A and B respectively. d. indicates the melting point of a 55:45 mixture of A and B respectively. Eutectic composition is a mixture of compounds with a specific chemical composition that solidifies at a lower temperature than any other composition. е. _indicates the eutectic temperature for these two compounds f. A: B indicates the composition of A…
10 Material Science and Engineering
Please solve it correctly, Don't copy paste.
Combustion of a fuel sampie in a bomb calorimeter increases the temperature of the entire system by 5.10 °C if the calorimeter contains 1500 g of water, but only by 4.00 "Cif the calorimeter contains 1950g of water. What is the heat capacity of the dry bomb calorimeter assembly? Assume that the specific heat capacity of water is 4.18 J A. 570 J "C- B. 912 J "C-1 C. 722 J "C- D. 366 J "C-1 E. 494 J "C-
C4
Kindly answer correctly. Please show all the necessary steps