19. A tank containing saturated steam undergoes a rapid drop in pressure. This results in rainout from the steam. In the absence of any other process, use the con- servation equations of mass and energy to derive a relation for the rainout mass flow rate in terms of the depressurization rate. [Ans.: mg = (m, / h [(dh, I dP) – v,](dP/ dt)].

19. A tank containing saturated steam undergoes a rapid drop in pressure. This results in rainout from the steam. In the absence of any other process, use the con- servation equations of mass and energy to derive a relation for the rainout mass flow rate in terms of the depressurization rate. [Ans.: mg = (m, / h [(dh, I dP) – v,](dP/ dt)].

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A vertical piston-cylinder arrangement with a diameter of 120 mm contains water with a quality of 60%. The pressure is 3 bar. Initially the piston rests 40 mm above the bottom of the cylinder. Heat is then added until the volume is 3 times the original volume. (a) Determine the mass of the water in the cylinder [ Select ] kg (b) Determine the work done. [ Select ] (J) (c) The final temperature [Select ] °C (d) The heat transferred to the system 1.8 kJ
What is the mass flow rate of airflow, with a Mach number of 0.230, Area of 10 in^2, Speed of sound of 200 ft/s and a pressure of 0.95 atm?
Estimate the pressure kPa(a) in the tank and density (kg/m3) of the gas mixture in the tank where Components /Mass CompositionCO2 /0.2O2 /0.7N2 /? Total mass of gas in tank 25 kgHeight of the tank 1.5 mDiameter of tank 2 mTemperature of tank 30 °C
A1] A small, artificial satellite of mass 10 kg and initial velocity: -1 Vo = [3000i + 4000j] ms enters a region of space, at t = 0 s, where it experiences a force given by: %3D F(t) = [2000j + 1200rk] N. The constants in the expression for F(t) require that t is specified in seconds. a) Write down an expression for the acceleration of the satellite, a(t). b) Determine the speed of the satellite at t = 0 s. c) By integrating your expression from (a), deduce the velocity of the satellite as a function of t for t > 0s. d) If the satellite experiences the force for 10 s, what is its final speed?
Question B2 a) At a given instant of time, two pressure waves, each moving at the speed of sound, emitted by a point source moving with a constant velocity in a fluid in at rest are shown in figure QB2. Determine the Mach number involved and indicate with a sketch the instantaneous location of the point source. R=5 cm 12 cm Figure QB2 R=24 cm [8 Marks] b) The gas velocity across a normal shock wave decreases from 480 m/s to 160 m/s. If the pressure and density upstream of the shock are 62 kPa and 1.5 kg/m ³, find the pressure and density downstream of the shock and the specific heat ratio of the gas. c) An aircraft is in supersonic flight at 11 km altitude on a standard day. The true air speed of the plane is 695 m/s. Calculate the flight Mach number of the aircraft. A total head tube is attached to the plane is used to sense stagnation pressure which is converted to flight Mach number by an on-board computer. However, the computer programme has ignored the normal shock wave that…
Writhe the full solution using thermodynamics equation. Steam at 14 bar & 315 C [state 1] enters a turbine through a 75 mm diameter pipe with a velocity of 3 m/s. The exhaust from the turbine is carried through a 250 mm diameter pipe and is at 0.35 bar & 105 C [state 2]. What is the power output of the turbine in watts? HInt: Use the steam table to obtain the thermodynamics property of the steam at the specified conditions.
Steam enters a condenser at 35 C[P %3D sat @ 35°C 42.21 mm of Hg]. Barometer reading is 760 mm of Hg and vacuum of 690 mm Hg is recorded in the condenser. The vacuum efficiency will be given by: (а) 86.01% (c) 96.10% (b) 82.30% (d) 80.23%
Using the following information, determine the vapor pressure of water at 300 °C. Note: We started this problem in week 6 lecture 3. Please refer to the lecture to get started on this problem. You only need to show your work starting from where the lecture left off. H₂0 at T = 179.88 degrees C the vapor pressure is PSAT = 10 bar. The enthalpy of vaporization is 2014.59 kJ/kg V = 0.1944 m³/kg V¹ = 0.001127 m³/kg The equation we left off on in class was, cpf 1 [P² psat dpsat pi psat Tf 1 ∆vapH (TF 1 RAZ Ti dT T2a
When The process is accorcing to a law iso thermal. takes place in a perfectly thermally b. C. insulated Cylinder. 8=1.3 Ans.[ 270 i 5.138 1g1.713 1J,52.6i,sSiky.-5.51, 219 5251g, o leg] University of Anbar College of Engineering Mechantont Englning Dpartment Year (Sophomore year) THERMODYNAMICSA Lec. No. Date: / 202 ME2303 Instructor: Asst. Prof. Dr. Saad M. Jalil hr Page Na. Q7 225 1g Ih of air at 4o% enter amixing chamber where it mixes with 540 kg /h of air at isi. Calculate the temperature of the air leaving the Chamber. assuming steady flow conditions. A ssume that the heat loss is negligible . Ans [22.4c] Q8: Aquantity of gas occupying o14n at a pressure of 1.4MNIM? and temperature of 300 č is expanded adiabatirally to 280 K Nimi Cv = 0. 74 Kg 11eg K p=1o41g ng - detennine: a. the mass of gas b. the temperature of the gas after expansion. work done during the expansion. Ans-fa-1.14 kg C. the b. ४३१ C. 180 lT ) Internal mC,(T2-T1) mC,(T2-T
8. Find the Mac number when an aeroplane is flying at 900 km/hour through still air having a pressure of 8.0 N/cm and temperature -15°C. Take k = 1.4 andR= 287 J/kg K. Calculate the pressure, tempera- (Delhi University, 1986) [Ans. 0.776, 11.9 N/cm, 16.06°C, 1.434 kg/m] ture and density of air at the stagnation point on the nose of the plane.
QUESTION 1 Steam at 350 °C and 1.8 MPa enters a turbine with a velocity of 100 m/s. P/p = 3141.2 kJ/kg (flow energy) and the mass flow rate is 4.0 kg/s. What is the rate of mechanical energy transfer (power) due to the mass flow? Attach File Browse Local Files
Steam at 1400 kPa and 350°C [state 1] enters a turbine through a pipe that is 8 cm in diameter, at a mass flow rate of 0.1 kg/s−1. The exhaust from the turbine is carried through a 25-cm-diameter pipe and is at 50 kPa and 100°C [state 2]. What is the power output of the turbine?