15 kN 2) Two objects are glued on the angled plane as shown in figure. If the ultimate stress for the glued joint are 20 MPa and 10 MPa for tension and shearing stress respectively, find the value of 0 that corresponds to the maximum factor of safety and find the value of this maximum factor of safety. 0.035 m 0.05 m

15 kN 2) Two objects are glued on the angled plane as shown in figure. If the ultimate stress for the glued joint are 20 MPa and 10 MPa for tension and shearing stress respectively, find the value of 0 that corresponds to the maximum factor of safety and find the value of this maximum factor of safety. 0.035 m 0.05 m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Refer to the figure. The steel rod is supported by an aluminum plate of 8 mm thickness. Force P pulls down the rod through the 12 mm hole in the aluminum plate. Neglect all weights of the rod and plate, and based on the design criteria that the maximum allowable shear stress in steel to be 18 MPa, calculate the allowable value of P in kN. Round to the nearest tenth. 10 mm T 12 mm- 40 mm- P 8 mm
Q1/ Find the value of P for the joint shown in the figure if the allowable shear stress is 100 MPa for the rivets. The four rivets are equal, each of 20 mm diameter. | 100 100 200 600 All dimensions in mm.
For the lap joint shown in the figure 1. Determine the maximum safe load P which may be applied if the shearing stress in the rivets is limited to 60 MPa 2. Determine the safe load P which may be applied if the bearing stress of the plate Is limited to 110 MPa (4-20 mm diameter rivet) O O →P
Part A The bolted connection (Figure 1) joins the bar supporting force P to two flanges set into a wall at A and B. In addition to supporting the load transferred by the bolt, the flanges are also subjected to additional 5-kN and 2-kN loads, as shown. Determine the largest internal shear force resisted by the bolt when P= 8 kN. (Figure 1) Express your answer to three significant figures and include appropriate units. Value Units Submit Request Answer Part B Determine the largest internal shear force resisted by the bolt when P = 23 kN and P = 18.6 kN. (Figure 2) Express your answer to three significant figures and include appropriate units. Value Units Figure Submit Request Answer SAN Provide Feedback Next > 2kN
6 kN/m 4 kN/m 1.5 m- What is the concentrated load of the rectangular loading as shown in the figure? 6 KN 2.5 KN 8 KN 4.5 KN
QUESTION 1The pole ABC is loaded as shown in Figure 1.a. Determine the internal loadings acting at section a-a.b. Calculate the average normal stress and shear stress at section a-a if the pole has a uniform cross-sectional area of 400 mm2.Given AB = 0.6 m, BC = 1.0 m
Q2: The 20-mm-diameter bolt fastens two wooden planks together.. Find the smallest thickness of each plankes if the working bearing stress for wood is 13 MPa.