100 kg/s of superheated steam at 653.15 K and 8800 kPa enters a turbine and leaves as saturated steam at 2700 kPa. Determine: 1. Inlet enthalpy kkg 2. Inlet entropy: kkg.K 3. Outlet temperature: 4. Total entropy change: kJK 5. Total power gained: MW Next >

Q: A refrigeration system with a capacity of 10 tons of refrigeration operates at 210 kPa in the…

A: Given data: Capacity of refrigeration = 10 ton Temperature in evaporator = 210 kPa Temperature in…

Q: Air is to be compressed from 3 bar and 303K to pressure of 15 bar in a multistage compression…

A: a multipart question about a simply supported beam subjected to a thermal load and an axial point…

Q: Problem 2 (Rankine Cycle) The boiler of a Rankine power cycle operates at 7000 kPa and the condenser…

A: Operating pressure of the rankine cycle = 7000 kPaOperating pressure of condenser = 50 kPa Inlet…

Q: Refrigerant 134-a enters the condenser of a residential heat pump at 800 kPa 35 C at a rate of 0.018…

A:

Q: Q5. The food compartment of a refrigerator is maintained at 4C by removing heat at a rate of…

A: In thermodynamics, the coefficient of performance (COP) is a measure of the efficiency of the…

Q: T2=45 °C 1-25 °C TI=45 °C 12-40 °C

A:

Q: Problem 1.29 (modified), Masters and Ela, Introduction to Environmental Engineering and Science, 3rd…

A: Note: Since you have posted multiple questions with multiple sub parts, we will provide the solution…

Q: 5-161 An ideal gas expands in an adiabatic turbine from 1200 K, 600 kPa to 700 K. Determine the…

A: Given  Cv = 0.83 KJ/kg R = 0.3 KJ/kg K CP  - Cv = R Cp = 1.13

Q: . Two steady flows of air enter a control volume, as shown in Fig. One is a 0.035 kg/s flow at…

A: Consider a control volume steady state device with two inlets and one exit flow. Neglecting kinetic…

Q: 2 A co-current (same direction) heat exchanger has one line with 5 kg/s of n-butane at 120°C and 5…

A: Mass flow rate of cooling water and the heat exchanger efficiency is asked to calculate. Given:Mass…

Q: A refrigerator operates on a reversed Carnot cycle whose coefficient of performance is 5.0. The…

A:

Q: 45 kg/h liquid propylene will be cooled from 300 K to 288 K by chilled water through a shell and…

A: Heat capacity of liquid propylene at 294 K is 2.6 kJ/kg-KCp-pl = 2.6 kJ/kg-KFlow rate of liquid…

Q: Refrigerant 134a flows through a horizontal tube with an inside diameter of 5 cm. The refrigerant…

A: Given: The inside diameter of the horizontal tube=5 cm quality at which the refrigerant enters=0.1…

Q: A small domestic heater is used to raise the temperature of 1.8 litres of water from 5 to 100!C…

A:

Q: At steady state, a power cycle develops a net power output of 20kW while receiving energy by heat…

A:

Q: You have a workshop in the back yard of your house where you do carpentry. You like to be at…

A:

Q: Q2/ Steam at 320 °C and 80 bar enter Nozzle with velocity 70 m/s and leaving by temperature is 100…

A:

Q: 3) Steam is produced in a boiler using liquid water as the feed. The boiler operates at 100 kPa. The…

A: Given: Inlet Water Temperature  = T1  = 40 oC  = (40+273) K  = 313 K  Outlet Steam Temperature  = T2…

Q: It is proposed to design and develop a Rankine cycle Steam Power Plant in which steam at 80 bar and…

A: Note: Since we are entitled to answer only 3 sub-parts, we’ll answer the first 3 subparts. Please…

Q: A co-current (same direction) heat exchanger has one line with 5 kg/s of n-butane at 120oC and 5 bar…

A:

Q: Air enters an insulated compressor at ambient conditions, 100 kPa, 20C at the rate of 0.2 kg/s and…

A: Given: P1 = 100kPa T1 = 273+20 = 293K m = 0.2kg/sec T2 = 500K n= 70% Cpo= 1.004kJ/kg.K

Q: A 0.42 mở rigid tank contains refrigerant-134a initially at 160 kPa and 40 percent quality. Heat is…

A: Given A rigid tank V=0.42m3 Refrigerant-134a P1=160kPa x= 0.4 P2=700kPa Find Total amount of heat…

Q: information er a 210-MW steam power plant that o ple non-ideal Rankine cycle. Steam e ine at 10 MPa…

A:

Q: A refrigeration system with a capacity of 10 tons of refrigeration, operates at 210 kPa in the…

A: At 210kPahg=1440.59 KJ/Kg = h2sg= 5.8716 KJ/Kg-kAt 1250 kPahf=274.04 KJ/Kg=h1hg= 1476..66…

Q: Show the COMPLETE SOLUTIONS and DIAGRAM (T-s) (Cycle) including the switching of table and…

A: Consider a small power plant that produces the steam at 3 MPa and 600oC  temperature in the boiler.…

Q: Experiments have shown that, for airflow at T = 35°C and V₁ = 100 m/s, the rate of heat transfer…

A:

Q: The temperatures of the 12 °C water at inlet 13 °C 15 °C 30 °C The temperatures of the 20 °C water…

A:

Q: Compare the COPs for an R-404a vapor-compression cycle, assuming Tcond = 45°C, Tevap = -5°C, Q =…

A:

Q: 4.3. Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa,…

A:

Q: A refrigeration system with a capacity of 15 tons of refrigeration, operates at 150 kPa in the…

A:

Q: A heat exchanger uses 5000 kg/hr of water to cool hydrocarbon oil from 140oC to 65oC. The oil,…

A: In a heat exchanger, two fluids, namely hydrocarbon oil and water, are used to transfer heat between…

Q: Water vapor at 5 MPa pressure and 400 C temperature enters a nozzle at a speed of 80 m / s and…

A:

Q: A Super-heated Steam at 200°C and 2 atm with mass flow rate of 1000 kg/h is being cooled in a…

A: It is given that mass flow rate of superheated steam at 200oC and 2 atm pressure = 1000 Kg/h Also…

Q: The following graph shows a complete charge-discharge cycle at 1.5C for a battery. Estimate the…

A: Given data: Charge during charge-discharge cycle = 1.5 C