A refrigeration system with a capacity of 10 tons of refrigeration, operates at 210 kPa in the evaporator, while in the condenser it is 1240 kPa. If refrigerant R-717 is saturated, calculate the theoretical power required to operate the compressor. Compressor Power = AnswerkW.

Q: Refrigerant 134-a enters the condenser of a residential heat pump at 800 kPa 35 C at a rate of 0.018…

A:

Q: A transmission case measures W = 0.30 m on a side and receives a power input of P; = 150 hp from the…

A:

Q: Q1) Air is used at a rate of 0.2 m³/min from a receiver at 50°C and 700 kPa gage. If the atmospheric…

A: Given, Volumetric flow rate, V2=0.2 m3/min=0.00333 m3/sec Final temperature, T2=50°C=323 K Final…

Q: Find the specific work done in a Rankine cycle if the steam supplied at 650 kPa and 0.9 dry and the…

A: The given parameters are:Pressure at which steam is supplied (P1) = 650 kPaDryness fraction (x) =…

Q: 45 kg/h liquid propylene will be cooled from 300 K to 288 K by chilled water through a shell and…

A: Heat capacity of liquid propylene at 294 K is 2.6 kJ/kg-KCp-pl = 2.6 kJ/kg-KFlow rate of liquid…

Q: A converging-diverging nozzle is used to accelerate water at the state of superheated steam. The…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Consider the transmission case of Problem 1.23, but now allow for radiation exchange with the…

A: Given Data:Pi=150 hPTsur = 30oCThe emissivity () is 0.80.W= 30 mThe efficiency ()is 0.93.

Q: A co-current (same direction) heat exchanger has one line with 5 kg/s of n-butane at 120oC and 5 bar…

A:

Q: What is the power output -2

A:

Q: )Problem #3 A prototype pump is designed to so that the attached dimensionless performance curves…

A:

Q: Using the first law of thermodynamics, analyze the cycle below in the thermodynamic equipment to…

A:

Q: The small turbine in figure D extracts 400 W (assume efficiency equal to 1) of power from the water…

A: Given: ρ=1000 kg/m3ν=μρ=1.02×10-6m2sD1=0.05 mD2=0.03 m

Q: 4.3. Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa,…

A:

Q: The hot and cold inlet temperatures to a concentric tube heat exchanger are Thi= 200°C, Tei = 100°C,…

A: Introduction - A heat exchanger is a machine  that transfers heat from one  fluid to another. Both…

Q: Consider a refrigeration system based on an ideal vapor-compression cycle using R-134a as the…

A: