Consider a refrigeration system based on an ideal vapor-compression cycle using R-134a as the refrigerant. It operates between 0.7 MPa and 0.12 MPa with a flow rate of 0.5 mol/s. Calculate the following: (a) the rate of heat removal from the refrigerated unit (b) the power input needed to the compressor (c) the COP

Q: A refrigeration system with a capacity of 10 tons of refrigeration operates at 210 kPa in the…

A: Given data: Capacity of refrigeration = 10 ton Temperature in evaporator = 210 kPa Temperature in…

Q: Refrigerant 134-a enters the condenser of a residential heat pump at 800 kPa 35 C at a rate of 0.018…

A:

Q: In order to increase the velocity of steam used as a fluid for a power plant, it was concluded that…

A: Nozzle is a device which is used to increase the velocity of fluid. Given data: Mass flow rate of…

Q: T2=45 °C 1-25 °C TI=45 °C 12-40 °C

A:

Q: The correct answers are shown. Please show me the steps to calculate these specific answers.

A: Step 1:  Step 2:  Step 3:  Step 4:

Q: A transmission case measures W = 0.30 m on a side and receives a power input of P; = 150 hp from the…

A:

Q: Q4. A refrigerator uses fereon-12 as the working fluid operates in a vapor-compression refrigeration…

A:

Q: A reciprocating compressor draws in 500 gal per minute of air whose density is 0.079 Ibm/cu ft and…

A:

Q: Calculate Reynolds number for six flat blade turbine agitator running at a speed of 20 rpm in a tank…

A: Given, Diameter ,D=3m Density ,ρ=1000kgm3 Viscosity , μ=1 Pa.s Speed(n)=20 rpm Velocity…

Q: A refrigerator operates on a reversed Carnot cycle whose coefficient of performance is 5.0. The…

A:

Q: Q1) Air is used at a rate of 0.2 m³/min from a receiver at 50°C and 700 kPa gage. If the atmospheric…

A: Given, Volumetric flow rate, V2=0.2 m3/min=0.00333 m3/sec Final temperature, T2=50°C=323 K Final…

Q: A. What is the difference between a compressor and a pump? B. What is the difference between Carnot…

A: To answer A. difference between a compressor and a pump B. difference between Carnot cycle and…

Q: Kerosene is pumped into a tank at rate between 0 and 1000 Litres per minute. The inlet temperature…

A: Given that- Kerosene is pumped into tank at rate between 0 to 1000 L. Hence, inlet flow rate= Fi…

Q: Q2/ A vapor-compression refrigeration system. The refrigerant is R134a for operating conditions,…

A:

Q: 12 kg of air per minute is delivered by a centrifugal air compressor It enters the compressor at a…

A:

Q: In the gas turbine cycle whose installation scheme is given in the figure below, 80% Isentropically…

A: Outlet temperature; Pressure ratio =5 T2T1=P2P1γ1-γ⇒T2290=50.41-0.4⇒T2=459.3 K (outlet tempreature…

Q: Consider a steam power cycle operating according to the simple ideal Rankine cycle. The steam enters…

A: Hello. Since your question has multiple parts, we will solve the first question  for you. If you…

Q: A converging-diverging nozzle is used to accelerate water at the state of superheated steam. The…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: 2.

A: Using the steam table, State 1 at P1= 0.8 MPa T1= Tsaturated= 31.31oC H1 =Hf= 95.47 KJ/Kg and State…

Q: At steady state, a power cycle develops a net power output of 20kW while receiving energy by heat…

A:

Q: To achieve cooling to a lower temperature on an industrial scale, a cascade refrigeration system…

A:

Q: Consider the transmission case of Problem 1.23, but now allow for radiation exchange with the…

A: Given Data:Pi=150 hPTsur = 30oCThe emissivity () is 0.80.W= 30 mThe efficiency ()is 0.93.

Q: It is proposed to design and develop a Rankine cycle Steam Power Plant in which steam at 80 bar and…

A: Note: Since we are entitled to answer only 3 sub-parts, we’ll answer the first 3 subparts. Please…

Q: A co-current (same direction) heat exchanger has one line with 5 kg/s of n-butane at 120oC and 5 bar…

A:

Q: Q3. A Carnot system operates between temperatures 500 "F and 100 °F. Its efficiency may be increased…

A:

Q: Air enters an insulated compressor at ambient conditions, 100 kPa, 20C at the rate of 0.2 kg/s and…

A: Given: P1 = 100kPa T1 = 273+20 = 293K m = 0.2kg/sec T2 = 500K n= 70% Cpo= 1.004kJ/kg.K

Q: The reservoir problem containing 45 kg of liquid with an initial temperature of 45 ° C has one inlet…

A:

Q: Air at static temperature of 300 K and static pressure of 140 kPa flow with velocity 60 m/s. a.…

A: Static temperature of air, T1 = 300 K Static pressure of air, P1 = 140 kPa Velocity, v = 60 m/s

Q: s a chemical engineering student, you are asked to investigate the efficiency of a Rankine Power…

A:

Q: What is the power output -2

A:

Q: )Problem #3 A prototype pump is designed to so that the attached dimensionless performance curves…

A:

Q: Using the first law of thermodynamics, analyze the cycle below in the thermodynamic equipment to…

A:

Q: A gas refrigeration system using air as the working fluid has a pressure ratio of 5 (see Fig. Q 1).…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: A Compressor compresses the air at 112 kPa and 300 K to 415 kPa and its inner diameter is 0.021 m.…

A:

Q: As can be seen in the figure, the air conditioner working in a stable state keeps the indoor…

A:

Q: A compressor receives air at 101.3 kPa at a steady rate of 0.5 kg/s and delivers at 700 kPa. At the…

A: Given mass flow rate of air into compressor, v= 0.5 kg/s inlet velocity of air V1=6 m/s exit…

Q: The temperatures of the 12 °C water at inlet 13 °C 15 °C 30 °C The temperatures of the 20 °C water…

A:

Q: Compare the COPs for an R-404a vapor-compression cycle, assuming Tcond = 45°C, Tevap = -5°C, Q =…

A:

Q: 4.3. Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa,…

A:

Q: 3. An engineer intends to use a simple double pipe counter flow heat exchanger to preheat process…

A:

Q: A heat pump system which uses R-134a operates on the ideal vapor compression heat pump cycle with a…

A: