Answered: 10.67 In a rectangular channel 4 m wide…

10.67 In a rectangular channel 4 m wide flow of 7.65 m/s the depth is 0.4 m. If a hydraulic jump is produced, (a) what will be the depth immediately after it? (b) What will be the loss of energy?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: In a rectangular channel, the depths of flow before and after the hydraulic jump are respectively…

Q: The hydraulic jump has a depth of 5 m at the downstream end, and the velocity is V2=1.75 m/s. If the…

A: NOTE: Due to some technical issue, formulation and equation writings is not possible. Hence, images…

Q: 3. Find the discharge through a totally drowned orifice 3 m wide and 1 m deep, if the difference in…

Q: Three pipes of different lengths and diameters connected in series, discharges 160 liters per…

Q: 5. A rectangular channel to cause critical plan this section is Im, 4 m wide. narrowed to 2m width…

A: Given a rectangular channel 4m wide which is narrowed down to 2m wide so as to cause critical flow.…

Q: A downward step of height 0.5 m causes a hydraulic jump in a wide channel when the depth and…

A: Given :

Q: Hydraulic Jump Given a 12-foot rectangular channel with an upstream Froude Number of 4.2 (Fr1-4.2)…

Q: D A rectangular channel 4 m wide carries 2.5m'/s. If the depth of fow is reduced to half the…

A: Given data: rectangular channel width of channel =4m discharge = 2.5 m3/s Y1=yc2

Q: In a rectangular channel, the depths of flow before and after the hydraulic jump are respectively…

Q: Q.6 Uniform Flow Fluid Mechanics and Hydraulics - Unifo... The initial depth of a hydraulic jump in…

A: Given Initial depth of hydraulic jump(y1)= 0.4m And sequent depth ratio (y2/y1)=13 Calculate…

Q: A 1m wide rectangular channel carries a discharge of 2m³/s. The specific energy-depth diagram is…

Q: The rectangular channel is 3 m wide and caries a flow of 10 m3/s. At the 3.5 m drop, water is at the…

A: Hydraulic jump: Hydraulic jump is defined as the rise of water, this is occurred due to the…

Q: Suppose that a stable hydraulic jump forms between the two sluice gates shown in Figure 5.15. If the…

Q: A 3 m wide rectangular channel, as shown, carries a flow of 11.7m³/s. hydraulic jump Ус y2 2 Az =…

A: Given data: rectangular channel width = 3 m Discharge = 11.7 m3/s At section 3 hump = 0.4 m

Q: For a wide open rectangular channel, if the critical velocity is 6 m/s, 1. What is the critical…

A: Given data Wide rectangular channel Critical velocity V= 6 m/s Calculations are shown below

Q: Water flows over a spillway that is 8 ft wide. If the flow is 450 ft^3/s, and the depth at the…

A: above given data we have to find Fe ant point 1 depth after hydraulic jump and energy that is lost

Q: 22. A discharge of 9 m/s/m is flowing through a spillway. A hydraulic jump takes place at a depth of…

A: Given: Discharge per width, q = 9 m3/s/m Depth of water before jump, y1 = 50 cm = 0.5 m

Q: Water flows down a spillway at a rate (per meter of width) of q = 5 m²/s and reaches the streambed…

Q: For the standpipe shown, determine the discharge for the following depths. C Cad 0.6. a. 1m b. 1.5 m…

A: Given, cw=corf=0.6b=2 md=1.2 mg=10 m/sec2

Q: A hydraulic jump is situated a 4 m wide rectangular channel. The discharge in the channel is 7.5…

Q: The term alternate depths in open channel flow is used to designate the depths O at the beginning…

A: Answer :-"having the same specific energy for the particular given discharge" Explaination:- For a…

Q: If the flow changes from subcritical to supercritical, would form. A. Hydraulic jump B. Submerged…

A: Flow types and conditionswanted to know if the flow changes from subcritical to supercritical what…

Q: A hydraulic Jump occurs in a trapezoidal channel having b=6ft, m=2, and Q=200cfs. The flow depth…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…

Q: A rectangular channel is 4 m wide, and it reduces to 2 m through a hydraulic structure. Assuring the…

A: The specific energy at the constriction is given as 6 m. Assuming choking occurs, we can use the…

Q: Question 4: A rectangular channel conveys Q=(10+b) m³/s discharges and has a K=(50+a). a) Calculate…

A: Given, Discharge (Q) = 14 m3/s K = 57

Q: 35p-Q.2) Water flows in a rectangular channel shown below. The bump has a maximum value, AZmax,…

Q: A hydraulic jump occurs in a rectangular channel that is 7 m wide. The initial depth is 0.8 m, and…

Q: For the rectangular channel below, what is the flow depth right before the hydraulic jump (the…

A: Discharge per width of the channel = q = 1.1ms2 Flow depth upstream = 9.6m

Q: Y1 V2

Q: Water flows through a 4m wide rectangular channel at a flow depth of 0.5m. Then, a hydraulic jump…

Q: A rectangular channel of width 10 m has a slope of 1 in 4000 and Manning coefficient 0.006 s/m/3.…

A: Width = B = 10m Slope = S = 14000 Manning's coefficient = n = .006 sm13 Discharge = Q = 40m3sec…

Q: Consider a rectangular channel of width b=7.5 m, in which the hydraulic jump occurs and one of its…

Q: Example: A rectangular channel 5.5 m wide conveys water of 16.5 m3/sec at a depth of 1.5 m: a) What…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: A tank 1.20 m wide and 2.0 m long, supported on frictionless rollers, contains water having a depth…

A: L (length of tank) = 2m W (width of tank) = 1.2m D(depth of water) = 1.8m a (orifice area) = 0.015m2…

Q: A hydraulic jump occurs in a horizontal rectangular channel. which is 1 m wide. The pre-jump depth…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

100%

**Problem 10.67:** In a rectangular channel 4 m wide with a flow of 7.65 m³/s the depth is 0.4 m. If a hydraulic jump is produced, (a) what will be the depth immediately after it? (b) What will be the loss of energy?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

QUESTION 30 In the figure shown, sub-critical uniform flow occurs in a 1.2 m width rectangular channel at the depth of 0.6 m. A hump of height 10 cm is placed in the bottom of the channel. Flow rate of the channel is 0.8 m/s. Assuming no energy losses, 1. Show that the flow depth on the step is 0.453 m(Y2) 2. If the flow depth on the step were to be critical depth (Y2) calculate the minimum height of the step (AH) Y-0.6 m Y: Q=0.8 m'/s DAH = 0.1 m
Do it fast 1 hour I will ?
1.
The discharge through a 3-m wide rectangular channel is 12 m³/s. If the head loss in a hydraulic jump is 1.3 m, find the depths before and after the jump.
PROBLEM 4 A pipe has a total length of 9800 ft with diameter of 30 in., and its thickness is 5/8 in. Assume that Ep = 30 x 10° psi, and Es = 300,000 psi. If the initial velocity for steady flow is 8 ft/s and a valve near the end of the pipe is partially closed so as to reduce the flow to half of the initial velocity in 3 seconds, (a) What is the wave celerity (ft/s), and (b) find the maximum pressure rise (psi) from the water hammer.
At a particular point of a 2 m wide rectangular channel, the flow has a depth of 0.3 and discharge of 1.5 m/s. Find out if a hydraulic jump will take place and if it will then what will be the height of hydraulic jump.
Water flows through a 4m wide rectangular channel at a flow depth of 0.5m. Then, a hydraulic jump occurred. If the upstream velocity is 10m/s, solve the head loss.
I need the answer as soon as possible
An overflow spillway is 40 m high. Water flows down the spillway with a head of 2.5m over the spillway crest. The spillway discharge coefficient Ca = 0.738. Show that the water depth at the toe of the spillway would be 0.3 m. Determine the sequent depth required for the formation of the hydraulic jump and the loss of head in the jump.
answer should be on the choices
Problem #4 Hydraulic JumpA hydraulic jump occurs in a rectangular channel 4.0 m wide. The water depth before the jump is0.4 m. If the flowrate is 20 m3/s, determine the depth after the jump and the critical depth at thejump.