For the rectangular channel below, what is the flow depth right before the hydraulic jump (the smallest flow depth shown in the figure)? Flow depth upstream of the spillway is 9.6 m and discharge per width of the channel is 1.1 m2/s. Assume negligible energy loss over the spillway.

Q: Uniform Flow A rectangular channel of width 4m is carrying a discharge of 36m³/sec. If the depth of…

A: Width of the rectangular channel-B = 4 m,Discharge Q=36 m3/sDepth of flow of one end of hydraulic…

Q: Hydraulic Jump Given a 12-foot rectangular channel with an upstream Froude Number of 4.2 (Fr1-4.2)…

A:

Q: What is the critical depth in a rectangular channel with 2.3 m width and 0.91 m2/s discharge per…

A: What is the critical depth in a rectangular channel and calculate minimum specific energy?

Q: Q1) In a rectangular channel with a base width of 3 m, the depth of the water is 0.5 m and the flow…

A: The channel is rectangularWidth of base, B = 3 mDepth of water, y1 = 0.5 mVelocity of flow, V1 = 5…

Q: Two rectangular clarifiers which are connected in series, each 50 m long and 15 m wide with water…

A: For Two rectangular clarifiers which are connected in series,Length,L  50 mWidth,B= 15 m wide Depth…

Q: 10.67 In a rectangular channel 4 m wide flow of 7.65 m/s the depth is 0.4 m. If a hydraulic jump is…

A: We have equation2q2g=y1y2y1+y2

Q: Uniform flows occur in a 10 meter wide rectangle channel. The flow in the channel is 18.4 m³/s and…

A: Minimum Specific Energy of flow is given by ; Emin Emin = 1.5  *  yc Where ; yc = (q2g)13

Q: The flow depth upstream of a sluice gate is 0.60 meters. The velocity is 0.9 m/s. a. What is the…

A:

Q: The crest of a spillway dam is located 78 m above the platform of the dissipation tank located…

A: Given;Flow rate per crest meter = 195 m³/s per crest meter Height of the spillway dam = 78 mSlope…

Q: A 3 m wide rectangular channel, as shown, carries a flow of 11.7m³/s. hydraulic jump Ус y2 2 Az =…

A: Given data: rectangular channel width = 3 m Discharge = 11.7 m3/s At section 3 hump = 0.4 m

Q: The upstream and downstream depth of flow of a sluice gate is 1 m and 0.2 m respectively. Calculate…

A: Given: Upstream depth, y1 = 1 m Downstream depth, y2 = 0.2 m

Q: Water flows over a spillway that is 8 ft wide. If the flow is 450 ft^3/s, and the depth at the…

A: above given data we have to find Fe ant point 1 depth after hydraulic jump and energy that is lost

Q: A hydraulic jump is situated a 4 m wide rectangular channel. The discharge in the channel is 7.5…

A:

Spillway design

A spillway is the overflow portion of the dam that carries the surplus discharge flow from the reservoir to the downstream, that is, it carries the flood water safely downstream, which is enough to be stored in that reservoir. Therefore, it acts as a safety valve for the dam because many failures of the dam arise due to the incorrect design of the spillway.