Consider a rectangular channel of width b=7.5 m, in which the hydraulic jump occurs and one of its stays is equal to 45 cm. A flow rate Q=54 m3/s passes through the channel. Determine: a) the other conjugate tie rod b) energy losses c) type of jump that occurs d) jump length

Consider a rectangular channel of width b=7.5 m, in which the hydraulic jump occurs and one of its stays is equal to 45 cm. A flow rate Q=54 m3/s passes through the channel. Determine: a) the other conjugate tie rod b) energy losses c) type of jump that occurs d) jump length

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 1. Consider a rectangular channel section having a length of 500 feet. The width of the channel is…

Q: a. The velocity before the jump b. The depth after the jump c. The velocity after the jump d. The…

Q: 1 3 2 Figure Q1

Q: An orifice (Ao = 0.005 m², cv = 0.92) is installed at the horizontal face of a tank as shown in the…

A: Cv = 0.92 Ao = 0.005 m² H = 8.5 m

Q: 10.67 In a rectangular channel 4 m wide flow of 7.65 m/s the depth is 0.4 m. If a hydraulic jump is…

A: We have equation2q2g=y1y2y1+y2

Q: Explain the physical significance of the above equation and give the type of jump you would expect…

A: Physical significance of given equation and type of jump between section 2 and 3### Hydraulic jump…

Q: Suppose that a stable hydraulic jump forms between the two sluice gates shown in Figure 5.15. If the…

Q: 3. The flow net shown in the figure corresponds to the transformed geom- etry of a problem in which…

A: Data given kh = 10-4 m/s kv = 10-5 m/s

Q: rough a spillway and goes th = 15m³/s per meter width of the channel and water depth Y₁ = 0.…

Q: A trapezoidal channel has a bottom width of 6 m and side slope of 1:1. The depth of flow is 2 m at a…

Q: A trapezoidal channel has a bottom width of 6m and side slope of 1:1. The depth of flow is 2m at a…

A: Bottom width = 6 mside slope = 1:1Depth of flow = 2 mDischarge = 24 m3/secTo find :Specific energy ?

Q: Y1 V2

Q: Water flows over the spillway shown in the figure below. If the velocity is uniform at sections (1)…

Q: b. Figure 3.2 is the flow of a channel having a large width, b, under a sluice gate. Assuming…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

Consider a rectangular channel of width b=7.5 m, in which the hydraulic jump occurs and one of its stays is equal to 45 cm. A flow rate Q=54 m³/s passes through the channel. Determine:

a) the other conjugate tie rod

b) energy losses

c) type of jump that occurs

d) jump length

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Calculating other conjugate depth using standard formula for a rectangular channel

VIEW

Step 2: Calculating energy loss and length of jump for a gien rectangular channel

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3. Water flows down a dam spillway and then forms a hydraulic jump. Just before the jump, the velocity of flow is 7.5 m/s, and the water depth is 0.15 m. Determine the average velocity of the flow downstream of the channel after the jump. 7,5m/s y2 yi=0.15m V2=.... ...m/s
A rectangular concrete channel 5m wide carries water as shown in the figure. The channel bed slope is 0.0022. Find the theoretical rate of flow in the channel.
For a 2-D flow field, the stream function y 3 y==(y²-x²). is given as 2 The magnitude of discharge occurring between the stream line passing through points (0, 3) and (3, 4) is
Consider the one-dimensional open channel flow shown in Figure P10.8. (a) Using the continuity principle and Bernoulli’s equation, show that where F is the local Froude number. (b) Discuss the implications of this result for subcritical flow everywhere, supercritical flow everywhere, and for F = 1 at station 2.
QUESTION 30 In the figure shown, sub-critical uniform flow occurs in a 1.2 m width rectangular channel at the depth of 0.6 m. A hump of height 10 cm is placed in the bottom of the channel. Flow rate of the channel is 0.8 m/s. Assuming no energy losses, 1. Show that the flow depth on the step is 0.453 m(Y2) 2. If the flow depth on the step were to be critical depth (Y2) calculate the minimum height of the step (AH) Y-0.6 m Y: Q=0.8 m'/s DAH = 0.1 m
Sol 4.
2-A water well is fully penetrates a confined aquifer, as shown in the figure, the external radius of the gravel pack around the water well is 35cm. The length of well screen is 25m and the well discharge is 0.15m3/s. Assess the validity of Darcy's law for this flow. Jse p=1000 kg/m³, µ =1.14×10-3 pa.s, d=1mm)
A dam releases water into a spillway, and then some distance downstream a hydraulic jump occurs. The dam height is 25 m, the initial depth in the spillway is 1 m, and the hydraulic jump leads to a region of depth 15 m. Upstream of the dam may be considered a reservoir. Determine the average velocity before the jump and whether the jump will occur. If there will be a jump, determine the velocity after the hydraulic jump, neglecting any friction losses.
1. A rectangular channel has a contraction that smoothly changes the width to a minimum width of 1.5 f t (the throat). If the flow is critical at the throat, find the volume flow rate when the depth at the throat is 1.5 f t. 2. Water in an open channel of constant width flows over a bump of height 1 f t, as shown in Figure P10.10. What is the depth of the water Y2? Assume uniform flow of constant width with no losses.
Q: Water is flowing through an inclined aquifer (a=15°) as shown in the following figure. The depth of aquifer is H₁-3m. Two observation wells are constructed at 55m apart (S-55m) to reach the top of the aquifer. It is found that the head difference between the points, observation wells were constructed, is h=3m. (i) Find the flow rate in m³/s/m length (at right angles to the cross section shown) if k-0.05 cm/s. (ii) Find the percentage rate of change in flow rate if the head difference is increased to 4m (h-5m). H Impervious layerPermeable layer Direction of flow
In the vertical wall of a reservoir (A) there is a drowned hole that it flows into another reservoir (B) with a real discharge speed of 4,5m/s. This one reservoir (B), in turn, has a square orifice with free discharge of the form shown in the figure. It requires a flow of 0,089 m³/s and there is no overflow of the system. Determine determine the area and edges of orifice 2. (See the image) Data: Orifice diameter 1 = 0.2m; Discharge coefficient for orifice 2 = 0.604; contraction coefficient for orifice 2 = 0.64. Consider both holessmall in relation to the depth of the reservoirs.
Water flows in a rectangular channel at a depth of 1.5 m. A 30 cm high smooth hump produces a drop of 15 cm in the water surface elevation. Neglecting losses, estimate the discharge per unit width of the channel. Solution: Refer to Figure 2.18. Let suffixes 1 and 2 refer to sections upstream of the hump and on the hump respectively as indicated in the figure. Energy Line V Е, У, 1 0.15 m √₂ Hump AZ = 0.30 m 2