A 1m wide rectangular channel carries a discharge of 2m³/s. The specific energy-depth diagram is prepared for the channel. It is observed in this diagram that corresponding to a particular specific energy, the subcritical depth is twice the supercritical depth. The subcritical depth (in meters, up to two decimal places) is equal to

A 1m wide rectangular channel carries a discharge of 2m³/s. The specific energy-depth diagram is prepared for the channel. It is observed in this diagram that corresponding to a particular specific energy, the subcritical depth is twice the supercritical depth. The subcritical depth (in meters, up to two decimal places) is equal to

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q.4 A 10 m wide rectangular channel carries a discharge of 20 m³/s under critical condition. Using g = 9.81 m/s², the specific energy (in m, up to two decimal places) is
Water is being discharged from an upper reservoir to a lower reservoir through a turbine (assume 80% efficiency), as shown in the figure. Find the power generated by the turbine (in hp). The pipe is made of cast iron and has length 100 m and diameter 250 mm. Neglect minor losses. The reservoir elevations and desired flowrate are shown on the figure. The kinematic viscosity of water is 1x106 m²/s. The roughness table and the Moody Diagram can be found in the Appendix. (Ywater 9800 N/m³ and 1 hp = 746 Watts or N.m/s) Elev. 197.3 m Water I Q-0.15 m³/s Turbine Elev. 50.0 m Water
A rectangular channel 9 m wide carries 7.65 m3/s when flowing 0.90 m deep. What is the specific energy? Select the correct response: 0.95 0.42 0.71 0.63
1.
Determine the kinetic energy correction coefficient for the compound channel shown in Figure 2.1 below. Im V,=0.5m/s V,=0.3m/s 20m 22m 3m Figure 2.1 4m V,=1.5m/s
36 The flow net constructed for the dam is shown in the figure below. Taking the coefficient of permeability as 3.8 x 10-6 m/s, the quantity of flow (in cm³/s) under the dam per meter of dam is. 6.3 m T ! 9.4 m 17.2 m I 1.6 m T - 50 m - Impermeable Stratum
A hydraulic jump takes place in a 6 m wide rectangular channel at a point where the upstream depth is 0.5 m (just before the jump). If the discharge in the channel is 30 m³/s and the energy loss in the jump is 1.6 m, then the Froude number computed at the end of the jump is (round off to two decimal places) (Consider the acceleration due to gravity as 10 m/s².) ..
A single -acting reciprocal pump lifts a liquid of specific weight 7.50 kN/m³ from a pressurised storeage reservoir to an overhead container. The free surface in the supply reservoir is at an elevation of 5.0 m above the centre of the pump. The ambient pressure over the liquid surface in the supply resevoir is 20 kN/m². The other relevant data relating to the pump are as follows: Length of suction pipe = 5.0 m Crank Speed= 60 rpm Diameter of suction pipe = 10 cm Length of Stroke = 40 cm Diameter of cylinder = 20 cm Atmospheric presure = 100 kN/m²(abs) Calculate the pressure in the cylinder and force on the piston at the beginning of the suction stroke.