10.5 Calculate the maximum load of a 1.5 MVA, 3-phase Alternator having anequivalent reactance of 4 when connected to 3.3 kV bus-bars if its excitation issuch that the emf on open circuit is 3.0 kV. Also find the armature current and pf atthis load.

Step 1: Step 2: Step 3: Step 4:

Answered: 10.5 Calculate the maximum load of a…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7MCQ

See similar textbooks

Similar questions

The voltage regulation of an alternator having 0.75 leading p.f. load, no-load induced e.m.f. of 2400V and rated terminal voltage of 3000V is............... percent. *
A 4MVA, 13.3 kV, 60 Hz, 3 phase, delta connected alternator has aneffective resistance of 5.2 ohm per phase and a combined armaturereactance of 54 ohm per phase. Determine the full load generatedvoltage per phase :a) At unity power factorb) At 0.8 power factor leadingc) At 0. 866 at power factor lagging Whole Solution
Two identical, 3-phase, Y-connected alternators A and B share equally a load of 10MW at 33kV at 0.8pf lagging. The synchronous reactance of each machine is 4 ohms per phase and the armature resistance is negligible. Alternator A has its field excitation adjusted to carry 125A lagging current. What is the current supplied by alternator B?
A three phase star connected, 1500 kVA, 13 kV alternator has an armature resistance of 0.9 ohm and a synchronous reactance of 8.0 ohms. When carrying rated load voltage, calculate the generated voltage per phase at loads of a. Unity P.F. b. 0.8 lagging P.F. c. 0.8 leading P.F. d. Calculate the voltage regulation for each loads and determine best regulation.
The step down DC chopper uses DC source voltage V(dc) = 200 V and resistive load impedance of 10 ohm. The duty cycle is 0.4 the voltage drop across the switch may be taken as zero, Calculate : (a) Average and RMS value of output voltage. (b) Average and RMS value of output current.
A three phase star connected alternator gives 575 V on open circuit when the field current is 10 A. For same field current, a full load current of 75 A is observed on short circuit. The armature resistance between terminals is 2.16 ohms. On 0.8 leading power factor of full load condition, induced emf per phase is 6000 V. Find its rated terminal voltage between the lines. Also calculate kVA rating of the alternator.
Kindly solve the problem with step by step complete solution. Also, put the given and formula used so that I can understand. Thank you. A 2200V, 60 Hz, three-phase, Y-connected alternator has an effective resistance per phase of 0.5 ohm. A field current of 30A produces a full load current of 200A on short circuit and a line-to-line emf of 1100 V on open circuit. Determine the power angle of the alternator when it delivers full load at .80 lagging pf.
Two turbo alternators rated for 140 MW and 260 MW have gov ernor drop characteristics of 5% from no load to full load. They are connected in parallel to share a load of 250 MW. Determine the load shared by each machine suming free governing action.
Don't use other platforms answer and also don't use chatgpt. A 3 phase 6000 kVA, 6600V, Y connected 2 pole 60 Hz alternator has the following characteristics: a. Field current= 125A, Open Circuit Voltage line value=8000V, Short circuit current=800A At full load the resistance drop is 3%. Find voltage regulation at power factor of 0.8 lagging.
A three-phase alternator connected in delta of 100 KVA and 635 volts is tested for OCC, SCC and winding resistance, giving the following data: Based on the above data, obtain: a) - Equivalent circuit per phase of the alternator b) - Voltage regulation when operating at full load and feeding a load with power factor of 0.8 inductive. c) - Voltage regulation when operating at full load and feeding a load with unity power factor. d) - Voltage regulation when operating at full load and feeding a load with a power factor of 0.8 capacitive.
Q A 50 Hz, 13.6kv, 3-phase arternator with grounded neutral hasinductance of 12 mH per phase and is connected to busbar 16]through a circuit breaker. The capacitance to earth between thealternator and the location of circuit breaker is o.03pF per phase.Neglect the resistance of the alternator. Determine the following:i) Maximum value of re-striking voltag. ."ro". the contactsof circuit breaker.i1) Frequency of transient oscillationsiii) Maximum value of RRRVir') Average RRRV upto the first peak of transientoscillations.
A 1200 kVA, 6600 volt, 3-phase, Y-connected alternator has an effective resistance of 0.40 ohm and a reactance of 6 ohms per phase. It delivers full load current of 0.80 lagging power factor at rated voltage. What will be the terminal voltage for the same excitation and load current if the power factor is 0.80 leading? a. 4,560 V b. 9,878 V c. 7,898 V d. 4,250 V

SEE MORE QUESTIONS

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning