1. There is a substance in a solution (S.00 x1o M). when using a spectrophotometer, you find that the length of cuvette is 2 cm and only 50% of the certain light beam is transmitted. Calculate the molar absorptivity, including units? and What will be T% if the solution is diluted to twice its original volume?

1. There is a substance in a solution (S.00 x1o M). when using a spectrophotometer, you find that the length of cuvette is 2 cm and only 50% of the certain light beam is transmitted. Calculate the molar absorptivity, including units? and What will be T% if the solution is diluted to twice its original volume?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter26: Molecular Absorption Spectrometry

Section: Chapter Questions

Problem 26.2QAP

See similar textbooks

Similar questions

Nelson's test was first performed in standard glucose solutions to generate a linear equation to determine the concentration of D-glucose hydrolyzed from the glycogen isolate. The linear equation is constructed by plotting the concentration of standard glucose (in mM) on the x-axis against the absorbance of the resulting mixture at 510 nm on the y-axis. As such, the general form of the linear equation is: Abs = slope (in mM-1) [glucose] (in mM) + y - intercept
A student prepared a cereal sample solution using a procedure similar to that in Lab 5. The original sample solution was diluted by a factor of two, and then the absorbance of the diluted sample solution was measured and recorded as (2.0x10^-1). Use the following calibration plot and the dilution factor to determine the concentration of iron, in unit of M, in the original cereal sample solution. The trendline (linear regression) as displayed on the plot is y = 11898x - 0.0112.
What are the disadvantages of uses the Thick layer stationary phase in Thin layer Chromatography (TLC)? Please shortly answer at your own words. Answer should be to the point ( specific 4-5 lines).
What is the role of specific visualizing agents in a Thin layer Chromatography? Please shortly answer at your own words. Answer should be to the point (4-5 lines).
In normal-phase chromatography, the stationary phase is Therefore, the eluent strength of the solvent increases as the solvent becomes less) polar, because the solute is more soluble in the mobile phase as the polarity of the mobile phase -Energy (polar / non-polar). (increase / decrease). Circle the peak in the spectrum below that corresponds to the circled transition shown in the energy level diagram. E₁ ⇒ 2 (more / 1 (s
What does the %RSD, listed in the spectral data, as well as the correlation coefficient of your standard curve, tell you about the quality of the data and integrity of the results? my standard % RSD is 36.4%, I had to calculate manually from the 5 standard solutions I did have on the spectra. The R squared value from the standard curve is 0.7282
How can you use ion exchange Chromatography to de-ionize water? Please shortly write at your own words. (4-5 lines maximum ).
hree components in a mixture have varying distribution constants between the mobile phase and the stationary phass One of the components has a very low distribution constant, Would this component likely elute first or last and how would you design an experiment or modify the components of the separation to make it perform in the opposite manner?
3. What is particulate gravimetry? When do we use this technique? 4. What are the conditions for a successful gravimetric analysis. 5. Define nucleation. What conditions are important for this stage.
1. From spinach, the chromatographic analysis will yield two major substances: (a) B-carotene (C40H56), which will separate from the spinach mixture to form a yellow band, and (b) chlorophyll A (CSSH72MGN4OS), which will separate from the mixture to form a green band. i. Describe the characteristics and draw structures of these molecules. ii. From the spectrophotometric analysis, what wavelength (Amax) would you expect ß-carotene (C40H56) to absorb? What wavelength would chlorophyll A (CssH72MgN4O5) absorb?
One method for the quantitative determination of the concentration of constituents in a sample analyzed by gas chromatography is area normalization. Here, complete elution of all the sample constituents is necessary. The area of each peak is then measured and corrected for differences in detector response to the different eluates. This correction involves dividing the area by an empirically determined correction factor. The concentration of the analyte is found from the ratio of its corrected area to the total corrected area of all peaks. For a chromatogram containing three peaks, the relative areas were found to be 16.4, 45.2 and 30.2, in order of increasing retention time. Calculate the percentage of each compound if the relative detector responses were 0.60, 0.78 and 0.88, respectively.
Use the data below to construct a calibration curve showing the mole fraction of ethyl acetate vs refractive index. Run (A) Ethyl Acetate (ml) (B) Ethanol (ml) Refractive index 1 40 10 1.370 2 30 20 1.368 3 20 30 1.366 4 25 25 1.369 5 0 50 1.371 6 50 0 1.373