1. The following table values were obtained by measuring the velocity of the fluid flowing in a pipe with a radius of 10 cm at certain points. Where r is the measurement points to the center of the pipe 2 The distance is in meters (m), and v is the measured velocities in meters / second (m / s). r(m) 0 0.02 0.04 0.06 0.08 0.1 v(m/sn) 5 4.817 4.592 4.292 3.823 0 Accordingly, for r = 0.07 m, the velocity value can be determined from the third order with the help of appropriate points that make the error minimum. Çalculate using interpolation. %3D

1. The following table values were obtained by measuring the velocity of the fluid flowing in a pipe with a radius of 10 cm at certain points. Where r is the measurement points to the center of the pipe 2 The distance is in meters (m), and v is the measured velocities in meters / second (m / s). r(m) 0 0.02 0.04 0.06 0.08 0.1 v(m/sn) 5 4.817 4.592 4.292 3.823 0 Accordingly, for r = 0.07 m, the velocity value can be determined from the third order with the help of appropriate points that make the error minimum. Çalculate using interpolation. %3D

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

What is the length and wall thickness of the vertical bear
What is CEA ?
ENTIRE ANSWER IS WRONG
I'm sorry instead of 695 it was 605.
That is the answer I have and it is marked as wrong, could you please do it again and see if you get another answer?
can this be done using simpsons rule?
Question 1 An engineer first draws a circle in a plane and uses a tool to convert the circle to a disk that is 3 mm thick in SOLIDWORKS. The engineer most likely used the feature. Chamfer Fillet Hole Extrude
Solidification is the process of changing the state of the material from .. powder to solid liquid to solid. solid to liquid. solid to solid none of the above 00O o
question 3 pls
what is the actual area in part a ?
Moving to another question will save this response. Question 1 Which of the following statement is NOT correct? Fluid Mechanics is the study of the behaviour of fluids. Fluid Mechanics is the study of the behaviour of solids. Fluid Mechanics is the study of the behaviour of liquids. Fluid Mechanics is the study of the behaviour of gases.
The Figure to the right shows a manufacturing process? What is this process called? 2. Identify the parte from 1 to 8 3. Explain how this process is performed? 1.