1. For the circuit below, what is Vout when Vin is HIGH (5V) and what is it when it is LOW (OV)? Vin Vin = 5V, Vout= Vin = OV, Vout || Explain why: ww R1 100 Q2 Q1 2N3904 12V Q2 2N3904 ww R2 100 £2 Vout

Q: Problem D Determine the value of Re so that collector current is 22 mA Vcc (Base current can be…

A: Transistor biasing

Q: Determine the approximate value of Ipss of the given circuit below. VDD 20V 2.1ka lQ1 V, V --4.5V V,…

A: From given figure , find drain current and gate to source voltage using kvl and ohms law. Use Jfet…

Q: Sketch the output voltage for each Zener limiting circuit in the Figure for the following cases: a)…

A:

Q: 1. Calculate the lc in figure below with beta = 80 Vcc= 12 V ३1. 550k Select one: O a. 0.174mA O b.…

A: In this question,  We need to determine the collector current as shown the circuit.  We know…

Q: Consider the circuit in Figure A2 where Vs = 12 V, R₁= R₂ and the input is a sinusoidal signal with…

A:

Q: Refer to the following figure. If BDC = 100 and VCE(sat) = 0.1 V , the value of IC(sat) is equal to…

A: By kvl Vcc-Ic(sat) × Rc - Vce(sat)=0 So Ic(sat)= (vcc - Vce(sat))/Rc

Q: 1. Consider a system of two small spheres, one carrying a charge of 2.00 μC and the other a charge…

A: The magnitude of the potential point per unit charge is the electric potential at a specific…

Q: Q2. Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. Re LOKO RB Vcc Bpc = 50 www 20…

A:

Q: 2. The circuit below is a emitter follower (the output is taken from the emitter and its voltage…

A: This question belong to small signal modelling of transister and it is in common collector…

Q: 1. Consider the circuit shown in Figure 1 below, constructed with an ideal opamp, with R = 1 kQ, C =…

A: In this question We need to determine the voltage Vo as shown the circuit.  We are solving this…

Q: 3. Assume the input to the circuit below is given by 3sin(2лft) Volts, where f-1000 Hz. What does…

A:

Q: Consider the circuit in Figure A2 where Vs = 12 V, R₁ R₂ and the input is a sinusoidal signal with…

A:

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.