Refer to the following figure. If BDC = 100 and VCE(sat) = 0.1 V , the value of IC(sat) is equal to +20 V 2.5 kn Rg VIN O O a. none of the mentioned O b. 18 mA O c. 1.8 mA d. 7.96 mA

Q: How to determine where stem locations

A: Given: To find:

Q: overcurrent protection

A: Given :- Transformer rated at 1000V,              Primary overcurrent protection device is at 250%…

Q: what was the calculation done to get d? Confused on how this was rearranged.

A:

Q: I dont get it. howcan I make sure its in low condition?

A: You have asked that how to make sure it is in low condition.

Q: Should the correct answer be 3 decibals?

A: here we have to find the voltage gain for the given power gain.Here we assume that input and output…

Q: Can you help me with questions two and three please?

A: Present StateNext State (UP)Next State…

Q: 3. All exposed noncurrent-carrying metal parts of an information technology system shall be to the…

A: All the exposed noncurrent carrying metal parts of an information technology system shall be bonded…

Q: Problem 1 is a review of your understanding of KVL (Kirchhoff's voltage law) Using KVL find the…

A: A simple question based on network analysis and the topics described in the solution are kirchoff's…

Q: find out what type of flow meter is used in Dialysis machines.

A: Dialysis machine :  Dialysis machine is used for kidney failure patients for dialysis of blood .…

Q: if you have (10) 10 OHM resistors and (5) OMR resistors in a series circuit what would the total…

A: Resistances are given as,

Q: Where a 2 1/2 inch conduit enters an angle pull box with three 400 MCM type THHN conductors and a 2…

A: For angle pulls, the distance between each raceway entry inside the baox and the opposite wall of…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.