2 1. Calculate the relative vorticity within three atmospheric flow patterns. Be sure to useappropriate units for your calculations and answer. Remember what we learned vorticityAvwas equal to: 3Δυalso remember what delta means.ДуAxa. The 500 mb trough below. (use winds at end of arrows to estimate u,v)CLK1400km54354655555-5585615645675705731000 km

For functional purposes, vorticity can be considered essentially as a COUNTER-CLOCKWISE or CLOCKWISE…

1. Calculate the relative vorticity within three atmospheric flow patterns. Be sure to use appropriate units for your calculations and answer. Remember what we learned vorticity Δν was equal to: 3 Δυ also remember what delta means. Ay Ax a. The 500 mb trough below. (use winds at end of arrows to estimate u,v) CLIC 1400 km 543 546 55 555- 558- 561 564 567 570 573 1000 km .

1. Calculate the relative vorticity within three atmospheric flow patterns. Be sure to use appropriate units for your calculations and answer. Remember what we learned vorticity Δν was equal to: 3 Δυ also remember what delta means. Ay Ax a. The 500 mb trough below. (use winds at end of arrows to estimate u,v) CLIC 1400 km 543 546 55 555- 558- 561 564 567 570 573 1000 km .

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Mott ." cometer, which we can analyze later in Chap. 7. A small ball of diameter D and density p, falls through a tube of test liquid (p. µ). The fall velocity V is calculated by the time to fall a measured distance. The formula for calculating the viscosity of the fluid is discusses a simple falling-ball vis- (Po – p)gD² 18 V This result is limited by the requirement that the Reynolds number (pVD/u) be less than 1.0. Suppose a steel ball (SG = 7.87) of diameter 2.2 mm falls in SAE 25W oil (SG = 0.88) at 20°C. The measured fall velocity is 8.4 cm/s. (a) What is the viscosity of the oil, in kg/m-s? (b) Is the Reynolds num- ber small enough for a valid estimate?
1. The Stokes-Oseen formula for drag force Fon a sphere of diameter D in a fluid stream of low velocity V, density p, and viscosity u is: 9T F = 3TuDV + 16PD? Is this formula dimensionally homogenous? 2. The efficiency n of a pump is defined as the (dimensionless) ratio of the power required to drive a pump: QAp input power Where Q is the volume rate of flow and Ap is the pressure rise produced by the pump. Suppose that a certain pump develops a pressure of Ibf/in? (1ft = 12 in) when its flow rate is 40 L/s (1L =0.001 m). If the input power is 16hp (1hp = 760 W), what is the efficiency?
The slope of the height h of a surface wave moving in a shallow pool of liquid is related to the speed of the wave u and gravity g by the following equation и ди дх g əx (a) Use a length scale L and a velocity scale Vo to 'nondimensionalize' the equation (b) What is the nondimensional parameter of the flow?
[1] Consider steady flow of air through the diffuser portion of a wind tunnel. Along the centerline of the diffuser, the air speed decreases from uentrance to ut as sketched. Measurements reveal that the centerline air speed decreases parabolically through the diffuser. Write an equation for centerline speed u(x), based on the parameters given here, Dee x=0 to x=L.
The Reynolds transport theorem (RTT) is discussed in Chap. 4 of your textbook. For the general case of a moving and/or deforming control volume, we write the RTT as follows: d pb dV + pbV-ñ dA dt dt dB sys where Vr is the relative velocity, i.e., the velocity of the fluid relative to the control surface. Write the primary dimensions of each additive term in the equation and verify that the equation is dimensionally homogeneous. Show all your work. (Hint: Since B can be any property of the flow-scalar, vector, or even tensor—it can have a variety of dimensions. So, just let the dimensions of B be those of B itself, {B}. Also, b is defined as B per unit mass.)
Engineering Fluid mechanics pathlines, streamlines, and streaklines: B.) The pattern produced by smoke rising from a chimney on a windy day is analogous to a pathline or streakline? Explain the definition of each.
Panels AB and CD in Fig. are each 120 cm wide intothe paper. ( a ) Can you deduce, by inspection, which panelhas the larger water force? ( b ) Even if your deduction isbrilliant, calculate the panel forces anyway.
a) Consider two flow situations where water flows between twoinfinite parallel plates seen in top image. Case 1: The top plate moves and thebottom plate is stationary. Case 2: Both plates are stationary. Whatdiffers if Navier-Stokes is applied to both cases to solve for the x-component of velocity? A. equations in the x-directionB. equations in the y-directionC. the boundary conditionsD. the shear stress terms b) In a three-dimensional flow system of an incompressiblefluid, the x-component velocity, vx , is 6xy^2 and the y-component velocity, vy , is -4y^2z. Which is the z-componentvelocity, vz? c is an arbitrary constant. (See bottom image)A. 4yz^2B. 4yz^2 – 6y^2z + cC. 8yz – 6y^2D. 8yz – 6y^2 + c
Consider steady flow of air through the diffuser portion of a wind tunnel. Along the centerline of the diffuser, the air speed decreases from uentrance to uexit as sketched. Measurements reveal that the centerline air speed decreases parabolically through the diffuser. Write an equation for centerline speed u(x), based on the parameters given here, from x = 0 to x = L.
Hint: take partial derivatives of the given shallow water equations and subtract them, e.g. d(eq2)/dx - d(eq1)/dy, and look for bits that make up vorticity, vorticity advection and divergence
The totally made-up dimensionless parameter Co, called the Cotton number (hey, why not) is Co =79T HA where g is gravitational acceleration, T is a characteristic time, p is dynamic viscosity, and A is a surface area. What is the proper dimension of the parameter 7? Mass-length O Length3 Mass-1 Mass-length 2 O Mass QUESTION 12 What is the fastest speed that 80 °F air can be vented from a 4-inch by 4-inch square duct while ensuring the flow is laminar? The density is 0.07350 Ibm/ft and dynamic viscosity is 1.247 x 105 Ibm/ft-s. 37.7 ft/s 2.04 ft/s 0.0364 ft/s 0.0976 ft/s 1.17 ft/s
find mach and reynolds number and write out N-S eqns