[1] Consider steady flow of air through the diffuser portion of a wind tunnel. Along thecenterline of the diffuser, the air speed decreases from uentrance to ut as sketched.Measurements reveal that the centerline air speed decreases parabolically through thediffuser. Write an equation for centerline speed u(x), based on the parameters given here,Deex=0 to x=L.

As per Question We have to find the equation for centerline speed based on parameter.

[1] Consider steady flow of air through the diffuser portion of a wind tunnel. Along the centerline of the diffuser, the air speed decreases from uentrance to uat as sketched. Measurements reveal that the centerline air speed decreases parabolically through the diffuser. Write an equation for centerline speed u(x), based on the parameters given here, x=0 to x=L.

[1] Consider steady flow of air through the diffuser portion of a wind tunnel. Along the centerline of the diffuser, the air speed decreases from uentrance to uat as sketched. Measurements reveal that the centerline air speed decreases parabolically through the diffuser. Write an equation for centerline speed u(x), based on the parameters given here, x=0 to x=L.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

(b) A Formula 1 team tests their car in a wind tunnel at a scale of 50%, at a speed of Vwinarunnet = 50 m/s. The measured downforce at this speed is Foownforce.WT = 3000 N and the model reference area is Aref wT = 0.5 m?. 1. Find the downforce magnitude on the full-scale race car at the same Reynolds number. Assume constant air density p = 1.2 kg/m. II. It is said that F1 cars could travel upside down, as shown below. At what speed should the full-scale car travel to achieve this, if its mass is m = 740 kg? The acceleration of gravity is g = 9.81 m/s?. Downforce Weight
Reference 12 contains inviscid theory calculations for the upper and lower surface velocity distributions V(x) over an airfoil, where x is the chordwise coordinate. A typical re- sult for small angle of attack is as follows: xlc VIU„(upper) VIU„(lower) 0.0 0.0 0.0 0.025 0.97 0.82 0.05 1.23 0.98 0.1 1.28 1.05 1.13 0.2 1.29 0.3 1.29 1.16 0.4 1.24 1.16 0.6 1.14 1.08 0.8 0.99 0.95 1.0 0.82 0.82 Use these data, plus Bernoulli's equation, to estimate (a) the lift coefficient and (b) the angle of attack if the airfoil is symmetric.
Find the correct option of the given question briefly
A small, axisymmetric, low-speed wind tunnel is built to calibrate hot wires. The diameter of the test section is 6.68 in, and its length is 12.5 in. The air is at 60°F. At a uniform air speed of 5.0 ft/s at the test section inlet, by how much will the centerline air speed accelerate by the end of the test section? What should the engineers do to eliminate this acceleration?
Ex. The force required to tow a 1:30scale model of a motor boat in a lake at a speed of 2m/s is 0.5 N, Assuming that the viscosity resistance due to water and air is negligible in comparison with the wave resistance, calculate the corresponding speed of the prototype for dynamically similar conditions. What would be the force required to propel the prptype at that velocity in the same lake? Ans.: 10.95m/s, 13500N
1. [-/2 Points] DETAILS SERCP8 3.P.035. MY NOTES ASK YOUR TEACHER PRACTICE ANOTHER A jet airliner moving initially at 300 mi/h due east enters a region where the wind is blowing at 105 mi/h in a direction 35.0° north of east. What is the new velocity of the aircraft relative to the ground? o north of east mi/h at
Fast pls
A flow model is constructed to a scale of 1/23 of the prototype and the free stream velocity in the prototype is 3 that of the model. Calculate the following ratios between prototype and model: (Provide your answer to two decimal places) The time ratio f, = The acceleration ratio a, =
An underwater device which is 2m long is to be moved at 4 m/sec. If a geometrically similar model 40 cm long is tested in a variable pressure wind tunnel at a speed of 60 m/sec with the following information, Poir at Standard atmospheric pressure = 1.18kg/m³ Pwater = 998kg/m3 Hair = 1.80 x 10-5 Pa-s at local atmospheric pressure and Hwater = 1 × 10-3 Pa-s then the pressure of the air in the model used times local atmospheric pressure is
I need answer 2,3 and i give upvote (no plagarism)
A prototype ocean platform piling is expected to encountercurrents of 150 cm/s and waves of 12-s period and 3-mheight. If a one-fifteenth-scale model is tested in a wavethe channel, what current speed, wave period, and wave heightshould be encountered by the model?
I need the answer as soon as possible