1. A 800 kV transmission line has per phase con- ductor inductance of 1.0 mH/km and capaci tance of 10.5 nF/km. Find the following: (a) The line surge/characteristic impedance. (b) The ideal power transfer capability of the line. (c) Transient overvoltage generated when the line conductor is struck by lightning and a peak impulse current of 30 kA is injected. 2. A circuit breaker (CB) installed on the line in Q.1 opens when a fault occurs. What will be the peak values of the 'switching overvoltages' produced when: (a) The CB opens at the instant of current zero crossing of the power frequency fault current? (b) The CB interrupts a power frequency fault current at its instant magnitude of 10 kA? 1. (a) 308.6 (b) 2073.88 MW (c) 4.62 MV (peak) 2. (a) 2.26 MV (peak) (b) 4.35 MV (peak)

1. A 800 kV transmission line has per phase con- ductor inductance of 1.0 mH/km and capaci tance of 10.5 nF/km. Find the following: (a) The line surge/characteristic impedance. (b) The ideal power transfer capability of the line. (c) Transient overvoltage generated when the line conductor is struck by lightning and a peak impulse current of 30 kA is injected. 2. A circuit breaker (CB) installed on the line in Q.1 opens when a fault occurs. What will be the peak values of the 'switching overvoltages' produced when: (a) The CB opens at the instant of current zero crossing of the power frequency fault current? (b) The CB interrupts a power frequency fault current at its instant magnitude of 10 kA? 1. (a) 308.6 (b) 2073.88 MW (c) 4.62 MV (peak) 2. (a) 2.26 MV (peak) (b) 4.35 MV (peak)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.13MCQ

See similar textbooks

Similar questions

The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
A three-phase, 60-Hz, untransposed transmission line runs in parallel with a telephone line for 20 km. The power line carries a balanced three-phase rms current of Ia = 3202 – 240°A. The line configuration is as shown in figure. Assume zero current flows in the ungrounded telephone wires. Find the magnitude of the voltage induced in the telephone line. = 32020°A, Ī, = 3204–120°A, and a 4 m 4 m 5 m d G2 mO
Develop a small-scale equivalent transmission line pi model (per phase) of the transmission lines with the specification given in table 1. The conductors are placed with a flat horizontal spacing of 7.25 meters. Consider that the load connected against the line 125MW at 0.85 lagging power factor. You are required to develop an equivalent model for a maximum 220V (RMS) sending and receiving end voltage and a maximum of 5A load current. Sr. NTDC Transmission Line Length Conductor No. Туре 220 kV DG Khan-Loralai Transmission Line (227 km) 227km Pheasant TABLE AJ Electrical characteristics of bare aluminum conductors steel-relnforced (ACSR)+ Reniertance Reactance per conductor 1-ft apacing. 60 Ha Ae, 60 Ha Capaitive Aluminum ares, emil Layers of Outaide aluminum diameter, in a/1,000 ft soC, D/ml GMR Induetive Stranding AL/8t De, 20°C. 20C, a/mi Code word D. t Ma-mi Waswing Partridge Ostrieh Merlin Linnet Oriole Chickndee Ibin Pelienn Flicker Hawk 266,800 206,800 300,000 336, 400 336.400…
The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412 cm. The conductor spacing is 3 m. Determine the inductance of the line in millinery’s per mile. How much of the inductance is due to internal flux linkages? Assume skin effect is negligible.
Q A 50 Hz, 13.6kv, 3-phase arternator with grounded neutral hasinductance of 12 mH per phase and is connected to busbar 16]through a circuit breaker. The capacitance to earth between thealternator and the location of circuit breaker is o.03pF per phase.Neglect the resistance of the alternator. Determine the following:i) Maximum value of re-striking voltag. ."ro". the contactsof circuit breaker.i1) Frequency of transient oscillationsiii) Maximum value of RRRVir') Average RRRV upto the first peak of transientoscillations.
The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412 cm. The conductor spacing is 3 m. Determiņe the inductance of the line in millihenrys per mile. How much of the inductance is due to internal flux linkages? Assume skin effect is negligible.
answer it i will rate
In power distribution systems, what is sometimes necessary to install to reduce harmonic frequencies and distortion between the three-phase transformers and distribution panels?
High voltage engineering subject
2. A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 20 ft and the third is 40 ft. The conductors are ACSR Rook. Determine the capacitance to neutral in microfarads per mile and the capacitive reactance to neutral in ohm-miles. If the line is 115 mi long, find the capacitance to neutral and capacitive reactance of the line.
A 220 kV, three phase transmission line is 50 km long. The resistance per phase is r 2 per km and the inductance per phase is L mH per km. The shunt capacitance is negligible. If the line supplies a three-phase load of 229 MVA at 0.8 power factor lagging at 220 kV with an efficiency of 97.13% and a voltage regulation of 4.7581%. Use the short line model to find the line resistance and inductance of the line.
A three-phase 60-Hz transmission line has its conductors arranged in a triangular formationso that two of the distances between conductors are 25 ft. and the third distance is 42 ft.The conductors are ACSR Osprey. Determine the inductance and inductive reactance perphase per mile.