02: A compressed air bottle of volume 0.15 m³ contains air at 40 bar and 27°C. It is used to drive a turbine which exhausts to atmosphere at 1 bar. If the pressure in the bottle is allowed to fall to 2 bar, determine the amount of work that could be delivered by the turbine.

Q: Air is to be compressed from 3 bar and 303K to pressure of 15 bar in a multistage compression…

A: a multipart question about a simply supported beam subjected to a thermal load and an axial point…

Q: A piston-cylinder assembly contains 5 kg of steam at a pressure of 100 bar and a temperature of 400…

A: Mass balance is applied to a closed system. The First law of thermodynamics is applied. The initial…

Q: an insulated piston-cylinder assembly initially at constant pressure of 250 kPa There is 4 L of…

A: Given data:   Pressure of piston-cylinder assembly = 250 kPa Volume of saturated liquid water = 4 L…

Q: • 200 kg/min superheated steam at 40 bar and 350C enters a turbine through a 7.5cm ID pipe. It exits…

A: Superheated heated is expanded through a turbine.

Q: A fluid system undergoes a non-flow frictionless process following the pressure-volume relation as p…

A:

Q: There is 7 bar pressure and 200 o C hot steam in a tank. This steam is allowed to cool in constant…

A:

Q: 1. At the Shell oil refinery, the lubricating oil, at a velocity of 6 feet per second, is passed…

A: The film temperature of the oil is, Tf = Ti+To2Tf = 105+902Tf = 97.5oF At this film temperature, the…

Q: 3. Air flows isentropically from a reservoir through a nozzle; PR = 60 psia, and TR = 100°F. At some…

A:

Q: The turbine in a hydroelectric power plant receives water at a rate of 120 m3/s from an elevation of…

A: The power output from the hydro-electric power plant is to be determined.

Q: 2. A tank, elevated on a 4-ft high wooden platform is exposed to the atmosphere and the minimum…

A: The mass rate is calculated from the given two flow rates. The two volumetric flow rates are…

Q: Water at 200 kPa and 300 K (H=343.4 kJ/kg) enters a straight horizontal pipe at a velocity 3 m/s…

A: For water Inlet pressure = 200 KPa  Inlet temperature = 300 K  Inlet enthalpy = 343.4 KJ/kg  Inlet…

Q: If the suction pressure of compressor equal to discharge pressure then the work of compression for…

A:

Q: Compute the change in volume and work done when one kilogram of cyclohexane is compressed from 1 bar…

A:

Q: Water (T = 20°C) from a reservoir is pumped up at 5 kg/s through a 3-in Sch. 40 pipe connected to a…

A: Given :Fluid Flow and Pumping:Water is being pumped from a reservoir through a The flow rate is Pump…

Q: Find the average power of the paddle wheel in kW During a constant-pressure process in a cylinder…

A: The average power for the wheel of a paddle is to be determined in kW.

Q: Turbines in a hydroelectric power plant receive water from a 100-m high dam, generate power and…

A: Given data: Height of the dam = 100 m. Diameter of the plant = 6 m. Velocity of the water = 15 m/s.…

Q: Oil at a rate of 1000 kg/min flows from an open reservoir placed at the top of a hill 400 m in…

A: The mass flow rate of oil, m = 1000 kg/min Height of the top of the hill to its bottom, Δ z = 400 m…

Q: Compressed air at room temperature (295 K) is contained in a 20-L tank at 2 bar. The valve is opened…

A:

Q: Calculate the change in molar enthalpy when isobutane gas is compressed from 350 K and 10 bar to 450…

A:

Q: An adiabatic steady-state turbine is operated reversibly to generate energy. The inlet to the…

A: Energy is generated by expansion of steam through a reversible, adiabatic turbine.

Q: Determine the rate of energy input to generate 13,000 m^3/hr of stream at 50 bar and 500 degrees C…

A: Flow rate of saturated liquid water (Q) = 13,000 m3/hrHeating of saturated liquid water at 50˚C to…

Q: Air enters an adiabatic turbine at 600 kPa and 1000oC. The exit pressure of the air is 50 kPa.…

A: The temperature at the exit of the adiabatic turbine is to be calculated along with the amount of…

Q: A 400-L rigid tank contains 5 kg of air at 25°C. Determine the reading on the pressure gage if the…

A: Given Volume of rigid tank V = 400L =   0.4 m3 Amount of air M = 5 kg  Temperature T = 25 oC…

Q: Single acting single cylinder compressor with diameter (15cm) and stroke length of (22.5cm). The air…

A: This problem is based on the concept of isothermal efficiency. Data given : 1. Stroke length , L =…

Q: Consider the piston-cylinder arrangement shown, in which the friction-free piston is free to move…

A:

Q: Steam is generated in a boiler. Water enters the boiler as saturated liquid at 7 MPa and leaves as…

A:

Q: Q 1) The cylinder of an engine contains a gas at a pressure of (1600 kPa), which expands in the…

A: As the process is represented by straight line. So, it is an isothermal process. DATA: P1=1600kPa…

Q: ank containing water i

A: The pressure of air = 25 PSIG

Q: -Pipe A 21 Pipe B 11110 Question 1 Two pipes, made from the same material, are connected to a water…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Power for Pumping in Flow System. Water is being pumped from an open water reservoir at the rate of…

A: Given data: Mass flow rate of water = 2 kg/s Length of pipe = 1500 m Frictional losses in the system…

Q: A Diesel cycle releases 1750 J/mol of heat. The pressure and temperature at the begin- ning of the…

A: Given, The heat rejected, Qr=1750 J/mol The pressure  PC=1 bar The temperature, TC=50°C=50+273 K=323…

Q: A rigid tank is divided into two equal sections by a diaphragm. Initially, one of the sections has a…

A:

Q: The power plant furnace burns coal at the rate of 108,200 kg/hr. Air at 100.8 Kpa 28°C is supplied…

A: Given, The ratio of mass of air to  the mass of coal, mairmcoal = 13.8 kgkg coal The mass flow rate…

Q: At the commencement of compression in the reciprocating compressor of a refrigeration plant the…

A: Given:The compressor follows  at To find the work done, Internal energy and heat transfer through…

Q: 17-156 Air is approaching a converging-diverging nozzle with a low velocity at 20°C and 300 kPa, and…

A:

Q: . a. A gas flowing in a pipe compresses as density falls. b. A gas is flowing in a pipe. As gas…

A: Answer  d. A gas flowing in a pipe expands as density falls A gas flowing in a pipe expands as…

Q: Steam flows in a Schedule 40, 6" (NPS) nominal pipe size 1000 ft long pipe, with roughness 45…

A: given = L = 1000ft = 304.87 m D = 6 in = 0.1524 m m = 45000 lb/hr = 5.67 Kg/s μ = 0.018*10-3 Pa.s T…

Q: Saturated water vapor at 100 kPa is in a piston-cylinder device. At the initial state the piston is…

A:

Q: Water flows over a waterfall 328 Ft in height. Take 2.204 lb of the water as the syste and assume…

A:

Q: 9. In figure, pressure gage A reads 10.8 psi, while pressure gage B reads 11.7 psi. Find the…

A: Given, Pressure at A = 10.8 psi Pressure at B = 11.7 psi

Q: Two hundred kJ of work is transferred to the air by means of a paddle wheel inserted into an…

A: