The power plant furnace burns coal at the rate of 108,200 kg/hr. Air at 100.8 Kpa 28°C is supplied at the rate of 13.8 kg/kg coal. Determine the volume flow rate of air flow in m³/min. 21,327.64 m³/min O 19,414.62 m³/min O 20,435.26 m³/min 24,535.54 m³/min

Q: Air is to be compressed from 3 bar and 303K to pressure of 15 bar in a multistage compression…

A: a multipart question about a simply supported beam subjected to a thermal load and an axial point…

Q: The liquid food is flowed through an uninsulated pipe at 90 ° C. The product flow rate is 0.4 kg / s…

A: Given: T1 = 90 oC             T1 = 15 oC Required: Convection coefficient in the pipe hfood =?…

Q: In order to increase the velocity of steam used as a fluid for a power plant, it was concluded that…

A: Nozzle is a device which is used to increase the velocity of fluid. Given data: Mass flow rate of…

Q: • 200 kg/min superheated steam at 40 bar and 350C enters a turbine through a 7.5cm ID pipe. It exits…

A: Superheated heated is expanded through a turbine.

Q: For transfusion of blood to a patient, it is decided to have a heat exchanger which heat the blood…

A: Given that TC1  =6 CTC2 = 37 CQ = 590 mlminCp  = 4180 KJ/kg      According to bartleby rule I can…

Q: 1. At the Shell oil refinery, the lubricating oil, at a velocity of 6 feet per second, is passed…

A: The film temperature of the oil is, Tf = Ti+To2Tf = 105+902Tf = 97.5oF At this film temperature, the…

Q: A reciprocating compressor draws in 500 gal per minute of air whose density is 0.079 Ibm/cu ft and…

A:

Q: Oil flows at a rate of 1000 kg/min from an open reservoir at the top of a hill 400 m in height to…

A: The mass flow rate of the oil = 1000 kg/min. Height(Z)=400 m. Heat supplied=1800 kJ/min. Work done…

Q: The water flows through a horizontal pipe with a diameter of 20 cm and a length of 3 m. The inlet…

A:

Q: a- the volume flow rate of air at the inlet b- the mass flow rate of air at inlet and at exit c- the…

A: HGGHH

Q: The process of injecting water into a well under high pressure is called Thermal EOR a. False b.…

A: The oil is recovered from the reservoir by means of natural energy (pressure difference) but when…

Q: 12. Water at a rate of 1 lbm/s flows in a vertical heated tube (d = 1.5 in). System pressure is 1250…

A:

Q: A. Identify the type of thermodynamic systems involved and the heat and work flows and their…

A: Hi, since there are multiple questions posted, we are allowed to answer one question per submission.…

Q: Problem 2. Water is flowing through a circular pipe of radius R=2.5cm. The velocity profile of the…

A: Given, The velocity profile, v = v01-rR1/7 Where, v0 = 3 m/s The radius of circular pipe, R = 2.5 cm…

Q: Air enters an electric furnace at 100 kPa and 28°C with a volume flow rate of 22 m/min. At the exit…

A: Given that :At entering P1  =100KPaT1   =28 C  =28+273.15 = 301.15 KQ = 22 m3minAt exit P2  = 100…

Q: Q2/ Steam at 320 °C and 80 bar enter Nozzle with velocity 70 m/s and leaving by temperature is 100…

A:

Q: An automobile engine provides 596 Joules of work to push the pistons and generates 2246 Joules of…

A: Given that, Work done on the system W = 596 J Heat generated by the system Q = 2246 J It is required…

Q: Steam at 320 °C and 80 bar enter Nozzle with velocity 70 m/s and leaving by temperature is 100 °C,…

A:

Q: 4. (20 points) Water (25°C) flows at 4.5 gpm (gpm is gallons per minute) in the system shown below.…

A: a) flow rates will be same along the pipe assuming no change in density.   1 gpm =0.00006309 m3/s…

Q: Air at 22˚C and at atmospheric pressure flows over a flat plate at a velocity of 1.65 m/s. If the…

A: GivenTα=22°C v=1.65 ms Ts=110°C length=2.179m b=1m ρ=1.058 kgm3 cp=1.005 KJKg °C k=0.02897 wm °C…

Q: In a continuously operated bioreactor metabolic heat is generated at the rate of 4 kW. Also, mixing…

A: In a continuous reactor, the input and output streams carry material in a flowing manner. It is an…

Q: Problem 3. A liquid is flowing through an 8cm diameter pipe. It is being heated by a hot fluid…

A: here we have velocity data , so we have to find a perfectly fit curve for the given data points.…

Q: Power for Pumping in Flow System. Water is being pumped from an open water reservoir at the rate of…

A: Given data: Mass flow rate of water = 2 kg/s Length of pipe = 1500 m Frictional losses in the system…

Q: II. Two air flows are mixed to a single flow. One flow is 1.5 kg/s at 20 °C and the other is 2.6…

A: Mass flow rate for first flow m1.=1.5 kg/s Mass flow rate for other flow m2.=2.6 kg/s Temperature…

Q: The chilling room of a meat plant is 15 m × 18 m × 5.5 m in size and has a capacity of 350 beef…

A: It is very essential to cool beef carcasses as fast as possible to avoid the growth of…

Q: In a certain gas manufacturing plants, they presented a horizontal tube in which a gas assumed to be…

A: Given data: Initial temperature of N2 = 761.67 0R Initial velocity = 5.6 mph Final velocity = 180…

Q: Using the first law of thermodynamics, analyze the cycle below in the thermodynamic equipment to…

A:

Q: A compressor receives air at 101.3 kPa at a steady rate of 0.5 kg/s and delivers at 700 kPa. At the…

A: Given mass flow rate of air into compressor, v= 0.5 kg/s inlet velocity of air V1=6 m/s exit…

Q: In an engine working on ideal Otto,.cycle, combustion takes place

A: The Otto Cycle involves four engine strokes. A stroke is defined as a process in which the…

Q: Engine oil flows through a 50 mm diameter tube at an average temperature of 147°C. The flow velocity…

A: Given, Diameter D    = 50 mm = 0.050 m Average temperature Tm= 147°C Velocity U= 80 cm/s = 0.80 m/s…

Q: liquid water at 294.26 K. flows in a straight horizontal pipe in which there is no exchange of…

A: Enthalpy change of the water for the given flow is to be determined.

Q: The liquid food is flowed through an uninsulated pipe at 90 ° C. The product flow rate is 0.3 kg / s…

A: Given DataMass flow rate of food  m=0.3 kg/sSpecific heat of food  Cp=4 KJ/kg.KThermal conductivity…