24. For 12 mm plastering works in a ratio of 1:2 cement sand mortar total dry volume is 2 cubic meter the required sand is 1.2 cubic meter and required cement is: (A) 18 bags (C) 24 bags (B) 10 bags (D) 9 bags

24. For 12 mm plastering works in a ratio of 1:2 cement sand mortar total dry volume is 2 cubic meter the required sand is 1.2 cubic meter and required cement is: (A) 18 bags (C) 24 bags (B) 10 bags (D) 9 bags

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Calculate the weight of moist gravel that should be in a batch if the design mix requires concrete…

Q: Practical Part Q4). 1- State the meaning of normal consistency of cement. 2- Which method is widely…

A: Cement A dry, powdery material known as cement is created by calcining lime and clay. It can be…

Q: choose the correct answer The water/cement ratio needed to obtain zero porosity (Vcp=0) in a fully…

A: Basic concept introduction- Cement requires approximately 23% of the water by weight for its…

Q: Problem: A concrete mix for 3rd level floor, open sided parking garage f'c 30 MPa Slump = 50 -70mm…

A: All tables are taken from ACI 318 1. Find Required Compressive strength : f'cr For f'c = 30 MPa <…

Q: Match all the possible combinations between Column X (Cement compounds) and Column Y (Cement…

A: Cement has several components that are responsible for the different properties.

Q: Find the quantities of cement, sand and coarse aggregates in 1 m³ of concrete for a mix proportion…

A: Quantities of cement, sand and coarse aggregate

Q: Consider the following data for concrete with mild exposure Water-cement ratio = 0.50 Water = 191.6…

A: Given data- Water cement ratio=0.50, Water = 191.6 litres, To Find- The cement content.

Q: Practical Part Q4). 1- State the meaning of normal consistency of cement. 2- Which method is widely…

Q: In determining consistency of cement, the completion of mixing and placing the paste in Vicat mould…

Q: A) GIVE THE RESEAONS FOR THE FOLLOWING (THREE ONLY) 1- Pozzolanic cement can be used in mass…

A: (1) Pozzolanic cement in mass concreting: Portland pozzolana cement is used in mass concrete…

Q: q3 A sample of concrete is prepared by using 500 g of cement with water cement rat of 0.55 and 240…

Q: A mix design for a major sidewalk construction project is required. The concrete will not be…

A: To determine the mix design amounts for the concrete, we need to calculate the proportions of the…

Q: A concrete mix for a concrete beam exposed to mild climate is to be designed according to the ACI…

A: Answer Mix proportioning using ACI absolute volume method. Step (1) Calculate Required average…

Q: 1 /Choose the correct answer 4- Higher temperature during placing and setting increases the very b)…

A: Explanation : 4) Higher temp during placing and settling increases the early strength because of…

Q: Use the British method to design an air-entrained concrete trial mix with a volume of (0.04) m?, if…

A: Air-entrained concrete contains billions of microscopic air cells per cubic foot. It is for…

Q: 01/Choose the correct answer 5- Aggregate more workability is. b) Rounded 6. laitance will be formed…

A: 5)For given water content, workability decreases if the concrete aggregates contain an excess of…

Q: Match List-l with List-Il (3 P) List-l (Type of cement) List-Il (Characteristics) A. Air entraining…

A: A. Air entraini Portland cement-->3. Greater resistance to frost attack

Q: Q2: Concrete is required for a building foundation. Soil testing shows that the level of…

A: From ACI 318 we have below two table Table 1: Maximum Water-Cementtitious material ratios and…

Q: Concrete Mix Design Problem: A concrete mix for 3rd level floor, open sided parking garage Given:…

Q: In Type II Cement, the strength of the cement paste at early age is higher than that in Type I…

A: The strength of the cement paste is measured in 7days, 14 days, and 28 days. The Strength of the…

Q: 12 Ibs of cement was mixed water to get 17 Ibs of cement-water mixture. What is the water-cement…

A: Given, In a mixture Amount of cement = 12 lbs Cement water mixture = 17 lbs we have to find water…

Q: S The cement factor of the concrete mix is (24 sack/ 3.0 m), Find the Yield of this mix

Q: Calculate the weight of moist gravel

A: Given Data:water-cement ratio =0.45dry gravel= 1258kg/m3water of 122kg/m3Air content =…

Q: You are working on a concrete mix design that requires each cubic yard ofconcrete to have 0.45…

A: Given:- The water-cement ratio of the concrete = 0.45 The unit weight of the dry gravel = 1165 kg/m3…

Q: A. Why gypsum is added to the Portland cement? and what is the normal percentage of gypsum to be…

A: Addition of gypsum to portland cement.

Q: Example select a mix proportional of 28-day compressive strength (measured on standard cubes) of 44…

A: w/c ratio = 0.55 (maximum) Cement Content = 290kg/m3 Water Content = 0.55 Cement Content = 159.5…

Q: (a) Hydration process of cement has significantly influence in producing good quality of concrete.…

A: Solution: Hydration is defined as the process that is the result of an exothermic reaction when…

Q: Flexural and compressive strengths are required for a special type of cement. For this purpose, TS…

A: Compressive stress is the force that deforms the material in a way that reduces the volume of the…

Q: Which of the following is correct for Low Heat Cement Heat of hydration is reduced by tricalcium…

Q: Determine the quantity of tricalcium silicate (C3S) of a cement from the following oxide…

Q: D concrete mix for use in reinforced cement concrete work from the following data. ) Characteristic…

Q: On most rigs cement materials are handled in bulk, which makes blending and mixing much easier. a.…

A: The workability of concrete mix is influenced by water cement ratio. If we increase the quantity of…

Q: 13 - What is the type of cement with Blaine fineness around 7000-9000 cm2 / g? A) Aluminous cement…

A: GIVEN QUESTION IS BASED ON THE BUILDING MATERIAL SPECIALY FOR CEMENT SPECIFICATION.

Q: Q- A sample of concrete is prepared by using 500 g of cement with water cement ratio of 0.55 and 240…

A: Given data: Cement weight, c = 500 g water cement ratio, Woc = 0.55…

Concept explainers

Reactions with Materials

Limestone

Question

24. For 12 mm plastering works in a ratio of 1:2 cement sand
mortar total dry volume is 2 cubic meter the required sand is
1.2 cubic meter and required cement is:
(A) 18 bags
(C) 24 bags
(B) 10 bags
(D) 9 bags

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 : BASIC DETAILS :

VIEW

Step 2 : QUANTITY OF CEMENT :

VIEW

Step 3 : NUMBER OF CEMENT BAGS :

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the solution with the same concentration, strength loss of the hardened cement paste soaked in magnesium sulfate solution was less than that in sodium sulfate solution. why?
Civil.
Note:hand written solution should be avoided.
12 Ibs of cement was mixed water to get 17 Ibs of cement-water mixture. What is the water-cement ratio of the mixture? a. 42% b. 29% c. 70% d. 30%
i need clear ans and solve very very fast in 20 min and thank you | DYBALA For the If the chemical composition of cement is as follows (CaO-60%, SiO2 =25.6%, A1203= 3.8%, MgO=4%, SO3=2.1%, C4AF=13.7%) the type of cement is White cement Expansive cement Pozzolanic cement None of the above
I need the answer as soon as possible
Q/The following materials are added to cement mixtures and compositions. What is the role of each of them in this - 1-FeO, 3 2-AIO, 2 3
Match all the possible combinations between Column X (Cement compounds) and Column Y (Cement properties): Column - X (i) C3 S (ii) C₂S (iii) C3 A Column Y (P) Early age strength (Q) Later age strength (R) Flash setting (s) Highest heat of hydration (T) Lowest heat of hydration Which one of the following combinations is correct?
Building material civil question.
Consider the following data for concrete with mild exposure Water-cement ratio = 0.50 Water 191.6 litre The required cement content will be (a) 561 kg/m³ (b) 472 kg/m³ (c) 383 kg/m³ (d) 294 kg/m³
The amount of cement (kg) in 1 m3 of mortar with the mix (1:2) is definitely - than that in 1m3 of concrete with a mix (1:2:4). O equal to O more than O less than