W5-Lab 5 Wien Bridge-OL 2023-06

In a Wien bridge oscillator circuit, resistor and capacitor form a series branch and a parallel branch. The value of the resistor is 200 ohm and the value of the capacitor is 10 mF. Determine the frequency of oscillation for the Wien Bridge oscillator circuit.

Subject: Analog Electronic and Circuit Please Solve this question

Ry III Determine the output voltage of the ideal op-amp differentiator in Figure below for the 4s v triangular-wave input shown. 2.2 k 10us Va of 5 us 15 us -5 V 0.001 uF

Consider the following circuit using diode and Op-Amp. Assume ideal Op-Amp with output saturation at +-13V. Assume diode forward drop is 0.7V. a. Find Vo and VA when Vin = 1V and 3V. b. Find V, and VA when Vin = -1V and -3V. R Vin R VA ovo ER₂

Q3( (A) Consider you have to analyze a Step-Down DC convertor having the following parameters: Input DC voltage - 24 V, Duty Cycle-0.65, L-20 μH, C = 15 μF, and R = 102. The switching frequency of IGBT/MOSFET Switch is 150 kHz. Analyze the above convertor for the following: a) The output voltage of the convertor b) The maximum and minimum inductor currents. c) The percent ripple in output voltage. (B) The full-bridge inverter of has a switching sequence that produces a square wave voltage across a series RL load. The switching frequency is 60 Hz, Voc-100 V, R=10. and L=25 mH. The power absorbed by load is 440 W. Analyze the above invertor for the following: (a) an expression for load current, (b) Average current in the DC source.

Subject : Power electronics Please write handwritten Answer

1. Consider the integrator circuit in Figure 1. The input signal, V; to the circuit is a 10 kHz square wave with a peak voltage of ± 1 V. Determine each of the following: (a) Sketch and label the values of the output signal, V,. (b) At what frequencies will the circuit stops acting as an integrator. (c) Sketch the output signal, V, when it is not acting as a integrator and what is it acting as now? 0.0047 µF RF 100 k2 V; R1 +15 V 2Vp. 10 k2 V. P-P -15 V 10 kHz RB 10 k2 Figure 1

An op-amp comparator in a firing circuit can produce waveforms at the output of up to 20 V peak-to-peak without any distortion. An inverse cosine-based firing circuit with a voltage range from +10 to -10 (reference voltage) is used to produce a gating signal for the SCR at the desired delay angle. if the reference voltage is 5.92 volts, the delay angle (in degrees) would be: O A. None of the other choices are correct O B. 41 O C. 139 O D. 131 O E. 49

A differential op-amp circuit as shown below is used to implement a given linear voltage measuring functionV = f(V,). ouf Provide answers to questions 19 – 22. ww V. V; W R out R2 Ground