3-1ProjectLog

20)This multiple choice question from MEASUREMENTS INSTRUMENTATIONS course.

1 Use the profile angle method to calculate the distance between collectors, d, to achieve zero shading at between 8:30 AM and 3:30 PM solar time on December 10. Then, use the Cartesian sun path chart for Windsor, Ontario, and determine when points A and C are shaded by points 1, 2 and 3. Each PV module (there are 32 shown) measures 1.8 m by 1 m. Use a tilt of 30°.

please include working

6. Hi can you please address the question in attached image.  Thank you so much have a nice evening.

Question 7

Q8 - You wish to end up with a 2um width metal line (measured at the top of the metal lead cross section). A) You are using an isotropic wet etch process on a 1um thick metal layer. What linewidth should the protective photoresist line be to get these results? Sketch the resulting structure before photoresist strip. B) now you are using a completely anisotropic etch, what is the requisite linewidth of the photoresist to achieve the same end goal? Sketch the resulting structure before the stripping of the photoresist.

FIVE QUESTIONS ANSWER ALL Question 1 A cylindrical specimen of Aluminum having a diameter of 12.8 mm and a gauge length of 50.800 mm is pulled in tension. Use the load-elongation characteristics shown in the following table to complete Q1(a) through (f). Raw Data Load (N) Length (mm) 50.800 7330 50.851 15100 50.902 23100 50.952 30400 51.003 34400 51.054 38400 51.308 41300 51.816 44800 52.832 46200 53.848 47300 54.864 47500 55.880 46100 56.896 44800 57.658 42600 58.420 36400 59.182 a) Plot both the engineering stress versus engineering strain and true stress versus true strain curves on the same axis. EV[8] b) Compute the modulus of elasticity. EV[3] c) Determine the yield strength at a strain offset of 0.002. AN[3] d) Determine the tensile strength of this alloy. AN[2] e) Compute the modulus of resilience. AN[2] f) What is the ductility, in percent elongation? AN[2]

What is the approximate voltage amplitude and frequency of the waveform below

I just question 2 to be solved. Thanks

A negatively charged (-121 uC) block is sitting on a frictionless, flat surface. This 12 kg block is attached to a vertical wall with a horizontal, 0.39 m long string that is under a tension of 100 N. Embedded in the wall (on the other side of the string) is another charge. What is the charge of this embedded charge in the wall? Assume that the block is stuck in place.

A block diagram representing a depth-control system for a small submersible vehicle is shown. Disturbance TAs) R(s) Yis) E(s) Desired K depth K, Actual depth K2 Sensor K

2. Using the IV plots shown in Fig. 3 (and found in the reintroduction to PSpice) design a BJT biasing circuit that results in the following parameters: VCE = 2 Vand ig = 40 μA. We also require the power supply to be fixed at 5 Volts (this is where the load line intercepts the iB =ic = 0 line). You may use the circuit shown in Example 1. Note that all resistor values in Example 1 must be recalculated. Your solution for the base to ground and base to collector resistors may not be unique.

Subject: Electrical and electronics measurement Please write handwritten Answer AndExplain Briefly Please don't use ChatGPT