The initial speed v 1 A of the projectile.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 86AP

(a)

To determine

The initial speed v1A of the projectile.

(b)

To determine

The speed v1A of the projectile when it is fired horizontally.

(c)

To determine

The factor which create difference in the velocity of part (a) and (b).

Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Your neighbor designs automobiles for a living. You are fascinated with her work. She is designing a new automobile and needs to determine how strong the front suspension should be. She knows of your fascination with her work and your expertise in physics, so she asks you to determine how large the normal force on the front wheels of her design automobile could become under a hard stop, ma when the wheels are locked and the automobile is skidding on the road. She gives you the following information. The mass of the automobile is m₂ = 1.10 × 103 kg and it can carry five passengers of average mass m = 80.0 kg. The front and rear wheels are separated by d = 4.45 m. The center of mass of the car carrying five passengers is dCM = 2.25 m behind the front wheels and hcm = 0.630 m above the roadway. A typical coefficient of kinetic friction between tires and roadway is μk 0.840. (Caution: The braking automobile is not in an inertial reference frame. Enter the magnitude of the force in N.)…

John is pushing his daughter Rachel in a wheelbarrow when it is stopped by a brick 8.00 cm high (see the figure below). The handles make an angle of 0 = 17.5° with the ground. Due to the weight of Rachel and the wheelbarrow, a downward force of 403 N is exerted at the center of the wheel, which has a radius of 16.0 cm. Assume the brick remains fixed and does not slide along the ground. Also assume the force applied by John is directed exactly toward the center of the wheel. (Choose the positive x-axis to be pointing to the right.) (a) What force (in N) must John apply along the handles to just start the wheel over the brick? (No Response) N (b) What is the force (magnitude in kN and direction in degrees clockwise from the -x-axis) that the brick exerts on the wheel just as the wheel begins to lift over the brick? magnitude (No Response) KN direction (No Response) ° clockwise from the -x-axis

An automobile tire is shown in the figure below. The tire is made of rubber with a uniform density of 1.10 × 103 kg/m³. The tire can be modeled as consisting of two flat sidewalls and a tread region. Each of the sidewalls has an inner radius of 16.5 cm and an outer radius of 30.5 cm as shown, and a uniform thickness of 0.600 cm. The tread region can be approximated as having a uniform thickness of 2.50 cm (that is, its inner radius is 30.5 cm and outer radius is 33.0 cm as shown) and a width of 19.2 cm. What is the moment of inertia (in kg. m²) of the tire about an axis perpendicular to the page through its center? 2.18 x Sidewall 33.0 cm 30.5 cm 16.5 cm Tread

Answer 2

Question

Chapter 9, Problem 86AP

(a)

To determine

The initial speed v1A of the projectile.

(b)

To determine

The speed v1A of the projectile when it is fired horizontally.

(c)

To determine

The factor which create difference in the velocity of part (a) and (b).

Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 3

Question

Chapter 9, Problem 86AP

(a)

To determine

The initial speed v1A of the projectile.

(b)

To determine

The speed v1A of the projectile when it is fired horizontally.

(c)

To determine

The factor which create difference in the velocity of part (a) and (b).

Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 4

Question

Chapter 9, Problem 86AP

(a)

To determine

The initial speed v1A of the projectile.

(b)

To determine

The speed v1A of the projectile when it is fired horizontally.

(c)

To determine

The factor which create difference in the velocity of part (a) and (b).

Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 5

Chapter 9, Problem 86AP

(a)

To determine

The initial speed v1A of the projectile.

(b)

To determine

The speed v1A of the projectile when it is fired horizontally.

(c)

To determine

The factor which create difference in the velocity of part (a) and (b).

Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.

Answer 6

Chapter 9, Problem 86AP

(a)

To determine

The initial speed v1A of the projectile.

Answer 7

Chapter 9, Problem 86AP

(a)

To determine

The initial speed v1A of the projectile.

Answer 8

(b)

To determine

The speed v1A of the projectile when it is fired horizontally.

Answer 9

(b)

To determine

The speed v1A of the projectile when it is fired horizontally.

Answer 10

(c)

To determine

The factor which create difference in the velocity of part (a) and (b).

Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.

Answer 11

(c)

To determine

The factor which create difference in the velocity of part (a) and (b).

Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.

Answer 12

Expert Solution & Answer

Answer 13

Expert Solution & Answer

Answer 14

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 15

Ch. 9.1 - Two objects have equal kinetic energies. How do...Ch. 9.1 - Your physical education teacher throws a baseball...Ch. 9.3 - Two objects are at rest on a frictionless surface....Ch. 9.3 - Rank an automobile dashboard, seat belt, and air...Ch. 9.4 - Prob. 9.5QQ Ch. 9.4 - A table-tennis ball is thrown at a stationary...Ch. 9.6 - A baseball bat of uniform density is cut at the...Ch. 9.7 - A cruise ship is moving at constant speed through...Ch. 9 - Prob. 1OQ Ch. 9 - Prob. 2OQ

The initial speed v 1 A of the projectile.

Solution Summary: The author calculates the speed of the projectile and ballistic by subtracting sqrt2gh from the equation.

Videos

The initial speed v1A of the projectile.

The speed v1A of the projectile when it is fired horizontally.

The factor which create difference in the velocity of part (a) and (b).

Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.

Want to see the full answer?

Chapter 9 Solutions

The initial speed v 1 A of the projectile.

Solution Summary: The author calculates the speed of the projectile and ballistic by subtracting sqrt2gh from the equation.

Videos

The initial speed v1A of the projectile.

The speed v1A of the projectile when it is fired horizontally.

The factor which create difference in the velocity of part (a) and (b). Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.

Want to see the full answer?

Chapter 9 Solutions

The factor which create difference in the velocity of part (a) and (b).

Introduction: When two or more bodies are collided then the total momentum of the system remains conserved if there is no external force acting on the system.