To select : The phase(s) present and their composition at temperature of 200°C for a lead-tin alloy having a composition of 25wt%Sn-75wt%Pb.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 4FEQP

To determine

To select:

The phase(s) present and their composition at temperature of 200°C for a lead-tin alloy having a composition of 25wt%Sn-75wt%Pb.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

A wheel of diameter 150.0 mm and width 37.00 mm carrying a load 2.200 kN rolls on a flat rail. Take the wheel material as steel and the rail material as cast iron. Assume the figure given, which is based on a Poisson's ratio of 0.3, is applicable to estimate the depth at which the maximum shear stress occurs for these materials. At this critical depth, calculate the Hertzian stresses σr, σy, σz, and Tmax for the wheel. 1.0 0.8 0, т Ratio of stress to Pmax 0.4 0.6 90 69 0.2 0.5b b 1.5b Tmax 2b Distance from contact surface The Hertizian stresses are as follows: 02 = or = -23.8 psi for the wheel =| necessary.) σy for the wheel =| MPa σz for the wheel = MPa V4 for the wheel = | MPa 2.5b ཡི 3b MPa (Include a minus sign if

Only question 3

A closed tank contains compressed air and oil ( 0.90)OilS = as is shown. A U-tube manometerusing mercury ( 13.6)HgS = is connected to the tank as shown. The column heights are1 2 340 , 8 , 15h cm h cm h cm= = = . Determine the pressure reading (in KPa ) of the gage.(Answer: 15.8AirP KPa= )