Explain how the outlet box is marked for installation to support the ceiling fan.

Question

Matched filter in the frequency domain (1.5) (a) Consider the signal s(t) in 3(c). Assuming that the unit of time is a millisecond and the desired frequency resolution is 1 Hz, use the function contFT to compute and plot |S(f). (b) Use the function contFT to compute and plot the magnitude of the Fourier trans- form of the convolution s * SMF numerically computed in 3(d). Also plot for comparison |S(f)12, using the output of 5(a). The two plots should match. (c) Plot the phase of the Fourier transform of s✶ SMF obtained in 5(b). Comment on whether the plot matches your expectations.

Answer 1

Question

Chapter 9, Problem 21R

To determine

Explain how the outlet box is marked for installation to support the ceiling fan.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

Matched filter in the frequency domain (1.5) (a) Consider the signal s(t) in 3(c). Assuming that the unit of time is a millisecond and the desired frequency resolution is 1 Hz, use the function contFT to compute and plot |S(f). (b) Use the function contFT to compute and plot the magnitude of the Fourier trans- form of the convolution s * SMF numerically computed in 3(d). Also plot for comparison |S(f)12, using the output of 5(a). The two plots should match. (c) Plot the phase of the Fourier transform of s✶ SMF obtained in 5(b). Comment on whether the plot matches your expectations.

Find Eigenvalues and Eigenvectors for the following matrices: [10 4 A=0 2 0 3 1 1 -3

1. (20 pts) Plot the pulse and the FFT for a pulse with the following properties at x=0 and x=10 cm. f=2 MHz m=3 Ncyc=2, 6, 20 po 1 MPa (source pressure) x=10 cm (propagates in a Newtonian fluid for 10 cm as a plane wave-not a sound beam) a=0.5 dB/(MHz cm) Consider 3 types of waves: sine, square, and sawtooth. (square and sawtooth only for grad students) Observe your plots and draw some conclusions. Discuss any possible issues you encounter. 2. (20 pts) We have the following 3 ultrasonic transducers: a. Focused 1 MHz, 2.54 cm diameter, 5.08 cm focus b. Focused 3 MHz, 2.54 cm diameter, 5.08 cm focus c. Unfocused 0.1 MHz, 2.54 cm diameter The transducers are operating in water (c=1486 m/s). I. Plot the axial field for all transducers II. Plot the focal transverse field for the focused transducers and the transverse field at the Rayleigh distance (R_0) and at 2R_0 for the unfocused. III. Assume source pressure of 0.1 MPa, and find the acoustic pressure in MPa at the location (r=0, z=4.5…