Concept explainers
In a typical automobile engine, a gasoline vapor-air mixture is compressed and ignited in the cylinders of the engine. This results in a combustion reaction that produces mainly carbon dioxide and water vapor. For simplicity, assume that the fuel is C8H18 and has a density of 0.760 g/mL.
- (a) Calculate the partial pressures of N2 and 02 in the air before it goes into the cylinder; assume the atmospheric pressure is 734 mmHg.
- (b) Consider the case where the air, without any fuel added, is compressed in the cylinder to seven times atmospheric pressure, the compression ratio of many modem automobile engines. Calculate the partial pressures of N2 and O2 at this pressure.
- (c) Now consider the case where 0.050 mL gasoline is added to the air in the cylinder just before compression and completely vaporized. Assume that the volume of the cylinder is 485 mL and the temperature is 150°C. Calculate the partial pressure of the gasoline vapor.
- (d) Calculate the amount (mol) of oxygen required to bum the gasoline in part (c) completely to CO2 and H2O.
- (e) The combustion reaction in the cylinder creates temperatures in excess of 1200K. Due to the high temperature, some of the nitrogen and oxygen in the air reacts to form nitrogen monoxide. If 10% of the nitrogen is converted to NO, calculate the mass (g) of NO produced by this combustion.
- (f) Hot-rod cars use another oxide of nitrogen, dinitrogen monoxide, to create an extra burst in power. When such a power boost is needed, dinitrogen monoxide gas is injected into the cylinders where it reacts with oxygen to form NO. Calculate the mass of dinitrogen monoxide that would have to be injected to form the same quantity of NO as produced in part (e). Assume that sufficient oxygen is present to do so.
(a)
Interpretation:
Partial pressure of
Concept Introduction:
Mole fraction: Quantity which defines the number of moles of a substance in a mixture divided by the total number of moles of all substances present.
Partial pressure of a gas in the mixture of gases is the product of mole fraction of the gas and the total pressure.
Answer to Problem ISP
Partial pressure of
Partial pressure of
Explanation of Solution
Percentage by volume of
Percentage by volume of
Mole fraction of
Partial pressure of
Partial pressure of
(b)
Interpretation:
Partial pressure of
Answer to Problem ISP
Partial pressure of
Partial pressure of
Explanation of Solution
At
According to Boyle’s law, pressure and volume is inversely proportional to each other at constant temperature and number of molecules.
Hence, when the volume of gas is compressed by seven times, then pressure of the sample is increased by seven times.
Therefore,
Partial pressure of
(c)
Interpretation:
Partial pressure of the gasoline vapor has to be calculated.
Concept Introduction:
Ideal gas Equation:
Any gas is described by using four terms namely pressure, volume, temperature and the amount of gas. Thus combining three laws namely Boyle’s, Charles’s Law and Avogadro’s Hypothesis the following equation could be obtained. It is referred as ideal gas equation.
Here,
n is the moles of gas
P is the Pressure
V is the Volume
T is the Temperature
R is the gas constant
Answer to Problem ISP
Partial pressure of the gasoline vapor is
Explanation of Solution
Given information is shown below,
Number of moles of gasoline
Partial pressure of the gasoline vapor can be calculated using Ideal Gas equation as follows,
(d)
Interpretation:
Number of moles of
Answer to Problem ISP
Number of moles of
Explanation of Solution
Balanced equation for the combustion of gasoline is given below,
Number of moles of gasoline
From the balanced equation, it is clear that
(e)
Interpretation:
Mass of
Concept Introduction:
Refer to (c)
Answer to Problem ISP
Mass of
Explanation of Solution
Given information is shown below,
Number of moles of
The reaction that shows the formation of
From the balanced equation, it is clear that
Mass of
(f)
Interpretation:
Mass of
Answer to Problem ISP
Mass of
Explanation of Solution
The reaction that shows the formation of
Number of moles of
From the balanced equation, it is clear that
Want to see more full solutions like this?
Chapter 8 Solutions
Bundle: Chemistry: The Molecular Science, 5th, Loose-Leaf + OWLv2 with Quick Prep 24-Months Printed Access Card
- Please correct answer and don't used hand raitingarrow_forwardPlease correct answer and don't used hand raitingarrow_forward(a) The following synthesis of the molecule shown in the circle has a major problem. What is this problem? (2 pts) 1) HBr (no peroxides) 2) H- NaNH2 Br 3) NaNH, 4) CH3Br 5) H2, Pd (b) Starting with the molecule shown below and any other materials with two carbons or less, write out an alternate synthesis of the circled molecule. More than one step is needed. Indicate the reagent(s) and the major product in all the steps in your synthesis. (5 pts) 2024 Fall Term (1) Organic Chemistry 1 (Lec) CHEM 22204 02[6386] (Hunter College) (c) Using the same starting material as in part (b) and any other materials win two carpons or less, write out syntheses of the circled molecules shown below. More than one step is needed in each case. Indicate the reagent(s) and the major product in all the steps in your synthesis. You may use reactions and products from your synthesis in part (b). (5 pts)arrow_forward
- alt ons for Free Response Questions FRQ 1: 0/5 To spectrophotometrically determine the mass percent of cobalt in an ore containing cobalt and some inert materials, solutions with known [Co?) are prepared and absorbance of each of the solutions is measured at the wavelength of optimum absorbance. The data are used to create a calibration plot, shown below. 0.90- 0.80- 0.70 0.60 0.50 0.40- 0.30 0.20- 0.10- 0.00- 0.005 0.010 Concentration (M) 0.015 A 0.630 g sample of the ore is completely dissolved in concentrated HNO3(aq). The mixture is diluted with water to a final volume of 50.00 ml. Assume that all the cobalt in the ore sample is converted to Co2+(aq). a. What is the [Co2] in the solution if the absorbance of a sample of the solution is 0.74? 13 ✗ b. Calculate the number of moles of Co2+(aq) in the 50.00 mL solution. 0.008 mols Coarrow_forwardPlease correct answer and don't used hand raitingarrow_forwardCloso-boranes and arachno-boranes are structures that exhibit B-B, B-H-B, and B-H bonds. Correct?arrow_forward
- Indicate why boron hydrides cannot form large linear or planar structures.arrow_forwardNido-boranes are structures with the molecular formula BnHn+4 that exhibit B-B, B-H-B and B-H bonds. Correct?arrow_forward8:07 AM Wed Dec 18 Final Exam 2024 copy Home Insert Draw Page Layout Formulas Data Review AA 田 General A G fx Alexis Cozort ☑ ⚫ 61% A B D E F H K M N P R S T U 3+ 10 125 mM that yielded peak heights of Aa = 9 1-(a)A sample solution was examined under XRF to quantify the analyte Ce³+. Find the response factor F, when standardized concentration of analyte [Ce³+]A = concentration of internal standard S i.e. [In³*]s = 151 mM was spiked with standardized 1600 and As = 3015 respectively? 11 12 (i)Define F, F = Aa As [A] [S] + X 13 (*Define with variables) 4000 14 15 (ii)Calculate F, F = numeral (You will use the F value in part 1-(b) below) As 16 (*Calculate with numerals) 17 18 1-(b)To determine the unknown conc of analyte [Ce³+], a volume of 15 mL of internal standard S having a concentration [In³+]s = 0.264 M 19 20 was added to 45 mL of unknown, and the mixture was diluted to 100 mL in a volumetric flask. XRF analysis yielded a spectrum, Figure-1, where peak heights A and As are…arrow_forward
- All structural types of Boron hydrides exhibit B-B, B-H-B and B-H bonds. Correct?arrow_forwardN-nitrosodimethylamine (NDMA) is a suspected carcinogen that can form via reactions between dimethylamine (DMA) and monochloramine (NH2Cl). The relevant elementary reactions and the corresponding rate constants are as shown below. Reaction Rate constant (M¹s¹) DMA + NH2Cl = DMCA + NH3 k =1.4×10-1, kr = 5.83×10-3 1.28×10-3 DMA + NH2Cl → UDMH UDMH + NH2Cl → NDMA -> 1.11×10-1 If the initial concentrations of DMA and NH2Cl are given, you should be able to predict the concentrations of all species at any given reaction time. Please write down the rate equations for DMA, NH2C1, DMCA, UDMH and NDMA.arrow_forwardYou wish to add enough NaOCl (sodium hypochlorite) to a 150 m³ swimming pool to provide a dose of 5.0 mg/L TOTOCI as Cl2. (a) How much NaOCI (kg) should you add? (Note: the equivalent weight of NaOCl is based on the reaction: NaOCl + 2H + 2 e→CI + Na +H₂O.) (10 pts) (atomic weight: Na 23, O 16, C1 35.5) (b) The pH in the pool after the NaOCl addition is 8.67. To improve disinfection, you want at least 90% of the TOTOCI to be in the form of HOCI (pKa 7.53). Assuming that HOCI/OCI is the only weak acid/base group in solution, what volume (L) of 10 N HCl must be added to achieve the goal? (15 pts) Note that part a) is a bonus question for undergraduate students. If you decide not to work on this part of the question, you many assume TOTOCI = 7×10-5 M for part b).arrow_forward
- Chemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage LearningChemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
- Chemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage LearningChemistry: Matter and ChangeChemistryISBN:9780078746376Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl WistromPublisher:Glencoe/McGraw-Hill School Pub Co