Concept explainers
Express the volume flow rate of the duct in
Answer to Problem 27P
The volume flow rate of the duct in
Explanation of Solution
Given data:
Refer to the Figure problem 8.27 in the textbook for the duct system.
Formula used:
Write the expression for the volume flow rate.
Here,
Calculation:
Substitute
Give the volume flow rate in
Convert the unit volume flow rate in equation (2) from
Convert the unit volume flow rate in equation (2) from
Find the average speed of air in the
Substitute
Conclusion:
Hence, the volume flow rate of the duct in
Want to see more full solutions like this?
Chapter 8 Solutions
Engineering Fundamentals
- In a food processing (drying) application, air ( ρ = 1.10 kg⁄m3 , V = 3 m⁄min ) enters a chamber through a duct with dimensions of 500 mm × 450 mm and leaves (ρ = 1.10 kg⁄m3 ) through a ductwork with dimensions of 400 mm × 450 mm. What is the average air speed in the exit duct? Express your answer in m/s.arrow_forwardConsider the piping system shown in the accompanying figure. The speed of water flowing through the 10 cm diameter section of the piping system is 1 m/s. What is the volume flow rate of water in the piping system? Express the volume flow rate in L/s. For the case of steady flow of water through the piping system, what is the speed of water in the 7.5 cm diameter section of the system?arrow_forwardA fluid (s=0.92) flows through a 97 mm diameter pipe at a velocity of 4 m/sec. Compute the Volume flow rate. (m3/s) Round your answer to 4 decimal places.arrow_forward
- A room has a volume of 120 ?3. An air-conditioning system is to replace the air in this room every twenty minutes, using ducts that have a square cross section. Assuming that air can be treated as an incompressible fluid, find the length of a side of the square if the air speed within the ducts is:a) 3.0 m/s and b) 5.0 m/s.arrow_forwardA hair dryer is basically a duct of constant diameter in which a few layers of electric resistors are placed. A small fan pulls the air in and forces it through the resistors where it is heated. If the density of air is 1.2 kg/m3 at the inlet and 1.05 kg/m3 at the exit, determine the percent increase in the velocity of air as it flows through the hair dryer. 1.05 kg/m³ Pin kg/m³ The increase in velocity is | %.arrow_forwardA hair dryer is basically a duct of constant diameter in which a few layers of electric resistors are placed. A small fan pulls the air in and forces it through the resistors where it is heated. If the density of air is 1.16 kg/m³ at the inlet and 1.05 kg/m³ at the exit, determine the percent increase in the velocity of air as it flows through the hair dryer. 1.05 kg/m³ The increase in velocity is Pin kg/m³ 9.52 %.arrow_forward
- An air-conditioning system is shown in the figure below in which air flows over tubes carrying Refrigerant 134a. Air enters with a volumetric flow rate of (AV)₁ = 150 m³/min at 32°C, 1 bar, and exits at 22°C, 0.95 bar. Refrigerant enters the tubes at 5 bar with a quality of 20% and exits at 5 bar, 20°C. Air P₁ = 1 bar T₁ = 32°C = 305 K (AV)1 3 Refrigerant 134a R-134a P3 = 5 bar x3=0.20 Air 2-P2=0.95 bar T₂ 22°C 295 K R-134a P4 = 5 bar T₁ = 20°C Ignoring heat transfer at the outer surface of the air conditioner, and neglecting kinetic and potential energy effects, determine at steady state: (a) the mass flow rate of the refrigerant, in kg/min. (b) the rate of heat transfer, in kJ/min, to the air from the refrigerant.arrow_forwardThe Venturi meter shown in the sketch below, contracts the flow down to one quarter of its original area. Cold air at 0 deg C flows in the pipe through the Venturi meter. The velocity of the air upstream of the Venturi meter is equal to 40 ft/s and the pressure at the same point is equal to 30 psia. What is the manometer reading if the fluid of the manometer is water with density 1000 kg/m3 . Assume that the air behaves as an ideal gas with molecular weight equal to Mw=29 kg/kmol and constant density evaluated at upstream conditions. Use Bernoulli's equation for your calculations. please respond asap!arrow_forwardA rectangular duct with dimensions of 1 m × 110 cm delivers conditioned air with a density of 1.2 kg⁄m3 to a room at a rate of 45 m3 /min. What is the mass-flow rate of air? What is the average air speed in the duct?arrow_forward
- Fluid mechanicsarrow_forwardWater flows from the ground floor to the third floor in a 4-storey building through a pipe 50 mm in diameter at a rate of 2 L/s and according to the diagram below. The water flows out from the system through a tap with an opening diameter of 15 mm. Q1. Calculate the energy loss due to friction as the water flows through the pipe (J/Kg) Q2. Calculate the total energy loss due to friction through the system (J/Kg) Q3. Calcualte the pressure at point 1 (kN/m2)arrow_forward19arrow_forward
- Engineering Fundamentals: An Introduction to Engi...Civil EngineeringISBN:9781305084766Author:Saeed MoaveniPublisher:Cengage Learning